usage and packet loss.
</p>
<p>
- The default is 1000. Values below 100 will be rounded up to 100.
+ The default is 2500. Values below 100 will be rounded up to 100.
+ </p>
+ </column>
+
+ <column name="other_config" key="force-miss-model">
+ <p>
+ Specifies userspace behaviour for handling flow misses. This takes
+ precedence over flow-eviction-threshold.
+ </p>
+ <p>
+ <dl>
+ <dt><code>auto</code></dt>
+ <dd>Handle automatically based on the flow-eviction-threshold and
+ the flow setup governer (default, recommended).</dd>
+ <dt><code>with-facets</code></dt>
+ <dd>Always create facets. Expensive kernel flow creation and
+ statistics tracking is always performed, even on flows with only
+ a small number of packets.</dd>
+ <dt><code>without-facets</code></dt>
+ <dd>Always handle without facets. Forces flow misses to be handled
+ in userspace. May cause an increase in CPU usage and packet loss
+ on high throughput.</dd>
+ </dl>
+ </p>
+ </column>
+
+ <column name="other_config" key="n-handler-threads"
+ type='{"type": "integer", "minInteger": 1}'>
+ <p>
+ Specifies the number of threads for software datapaths to use for
+ handling new flows. The default is one less than the number of
+ online CPU cores (but at least 1).
+ </p>
+ <p>
+ This configuration is per datapath. If you have more than one
+ software datapath (e.g. some <code>system</code> bridges and some
+ <code>netdev</code> bridges), then the total number of threads is
+ <code>n-handler-threads</code> times the number of software
+ datapaths.
</p>
</column>
</group>
on a host.
</column>
+ <column name="ifindex">
+ A positive interface index as defined for SNMP MIB-II in RFCs 1213 and
+ 2863, if the interface has one, otherwise 0. The ifindex is useful for
+ seamless integration with protocols such as SNMP and sFlow.
+ </column>
+
<column name="mac_in_use">
The MAC address in use by this interface.
</column>
times the expected reception rate, will signal a connectivity
fault. In the case of a unidirectional connectivity issue, the
system not receiving BFD control messages will signal the problem
- to its peer in the messages is transmists.
+ to its peer in the messages it transmits.
</p>
<p>
<code>false</code>.
</column>
+ <column name="bfd" key="check_tnl_key" type='{"type": "boolean"}'>
+ When set to true, Check Tunnel Key will make BFD only accept control
+ messages with an <code>in_key</code> of zero. Defaults to
+ <code>false</code>.
+ </column>
+
+ <column name="bfd" key="bfd_dst_mac">
+ An Ethernet address in the form
+ <var>xx</var>:<var>xx</var>:<var>xx</var>:<var>xx</var>:<var>xx</var>:<var>xx</var>
+ to set the destination mac address of the bfd packet. If this
+ field is set, it is assumed that all the bfd packets destined to this
+ interface also has the same destination mac address. If not set, a
+ default value of <code>00:23:20:00:00:01</code> is used.
+ </column>
+
<column name="bfd_status" key="state"
type='{"type": "string",
"enum": ["set", ["admin_down", "down", "init", "up"]]}'>