X-Git-Url: http://git.onelab.eu/?a=blobdiff_plain;f=Documentation%2Fi2c%2Fbusses%2Fscx200_acb;h=f50e69981ec6570357acdfd6a6a825609f9fe6c7;hb=9464c7cf61b9433057924c36e6e02f303a00e768;hp=7c07883d4dfc054302561791cbef9366110d6edc;hpb=41689045f6a3cbe0550e1d34e9cc20d2e8c432ba;p=linux-2.6.git

diff --git a/Documentation/i2c/busses/scx200_acb b/Documentation/i2c/busses/scx200_acb
index 7c07883d4..f50e69981 100644
--- a/Documentation/i2c/busses/scx200_acb
+++ b/Documentation/i2c/busses/scx200_acb
@@ -2,31 +2,14 @@ Kernel driver scx200_acb
 
 Author: Christer Weinigel <wingel@nano-system.com>
 
-The driver supersedes the older, never merged driver named i2c-nscacb.
-
 Module Parameters
 -----------------
 
-* base: up to 4 ints
+* base: int
   Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
 
-  By default the driver uses two base addresses 0x820 and 0x840.
-  If you want only one base address, specify the second as 0 so as to
-  override this default.
-
 Description
 -----------
 
 Enable the use of the ACCESS.bus controller on the Geode SCx200 and
 SC1100 processors and the CS5535 and CS5536 Geode companion devices.
-
-Device-specific notes
----------------------
-
-The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
-If the scx200_acb driver is built into the kernel, add the following
-parameter to your boot command line:
-  scx200_acb.base=0x810,0x820
-If the scx200_acb driver is built as a module, add the following line to
-the file /etc/modprobe.conf instead:
-  options scx200_acb base=0x810,0x820