- Use the 'Test Reboot' button. This will set the boot state to 'rins' and
+ Use the 'Test Reboot' button. This will set the boot state to 'reinstall' and
attempt to reboot your machine using the registered PCU.
-
-
If Reboot succeeds,
- your machine will reboot, install the bootstrap image, and
- contacted PLC. Finally, the boot state will be updated to 'boot'.
-
- Continue using the 'Reload' button to check whether the node has
- completed its installation.
-
+
+
If Reboot fails,
there will be an error displayed that will assist you in
diagnosing the error. Otherwise, please double check the
@@ -25,7 +19,25 @@
PCU manually (using it's web or ssh interface).
To try the test again, use 'Test Reboot'.
+ If you need help diagnosing the problem, please contact
+ PlanetLab Support.
+
Reboot Failure:
+
= $error ?>
+
+
If Reboot succeeds,
+ your machine will reboot, install the bootstrap image, and
+ contacted PLC. Finally, the boot state will be updated to 'boot'.
+
+ Continue using the 'Reload' button to check whether the node has
+ completed its installation.
+
+
Reboot without error:
+
No errors were reported for your reboot. Please double check by
+ confirming at the console. If the reboot failed, please report this
+ to PlanetLab Feedback.
+
+
Success!!
The installation is complete; your machine has reached the final
@@ -40,7 +52,7 @@
Start with the 'Test Reboot' button.
-
+
'Test Reboot' to start again.
'Reload' to Reload this page.
@@ -52,13 +64,6 @@