X-Git-Url: http://git.onelab.eu/?a=blobdiff_plain;f=arch%2Fmips%2Fau1000%2Fpb1100%2Fboard_setup.c;h=2d1533f116c0c020f57a4de59c952b6167f3545c;hb=97bf2856c6014879bd04983a3e9dfcdac1e7fe85;hp=13c2f6ca7e335a4bb5d8d21e3f8f731b51f23e2b;hpb=76828883507a47dae78837ab5dec5a5b4513c667;p=linux-2.6.git

diff --git a/arch/mips/au1000/pb1100/board_setup.c b/arch/mips/au1000/pb1100/board_setup.c
index 13c2f6ca7..2d1533f11 100644
--- a/arch/mips/au1000/pb1100/board_setup.c
+++ b/arch/mips/au1000/pb1100/board_setup.c
@@ -23,7 +23,6 @@
  *  with this program; if not, write  to the Free Software Foundation, Inc.,
  *  675 Mass Ave, Cambridge, MA 02139, USA.
  */
-#include <linux/config.h>
 #include <linux/init.h>
 #include <linux/sched.h>
 #include <linux/ioport.h>
@@ -56,7 +55,7 @@ void __init board_setup(void)
 	au_writel(0, SYS_PININPUTEN);
 	udelay(100);
 
-#if defined (CONFIG_USB_OHCI) || defined (CONFIG_AU1X00_USB_DEVICE)
+#ifdef CONFIG_USB_OHCI
 	// configure pins GPIO[14:9] as GPIO
 	pin_func = au_readl(SYS_PINFUNC) & (u32)(~0x80);
 
@@ -93,12 +92,10 @@ void __init board_setup(void)
 
 	// get USB Functionality pin state (device vs host drive pins)
 	pin_func = au_readl(SYS_PINFUNC) & (u32)(~0x8000);
-#ifndef CONFIG_AU1X00_USB_DEVICE
 	// 2nd USB port is USB host
 	pin_func |= 0x8000;
-#endif
 	au_writel(pin_func, SYS_PINFUNC);
-#endif // defined (CONFIG_USB_OHCI) || defined (CONFIG_AU1X00_USB_DEVICE)
+#endif // defined (CONFIG_USB_OHCI)
 
 	/* Enable sys bus clock divider when IDLE state or no bus activity. */
 	au_writel(au_readl(SYS_POWERCTRL) | (0x3 << 5), SYS_POWERCTRL);