X-Git-Url: http://git.onelab.eu/?a=blobdiff_plain;f=drivers%2Fide%2Fpci%2Ftriflex.c;h=eca0772f22e68d4a9b5ef9e3eff92c5e3f3fb3ae;hb=c7b5ebbddf7bcd3651947760f423e3783bbe6573;hp=52e088e2569f369354288847a5ed83af4bd343dd;hpb=a2c21200f1c81b08cb55e417b68150bba439b646;p=linux-2.6.git diff --git a/drivers/ide/pci/triflex.c b/drivers/ide/pci/triflex.c index 52e088e25..eca0772f2 100644 --- a/drivers/ide/pci/triflex.c +++ b/drivers/ide/pci/triflex.c @@ -41,57 +41,6 @@ #include #include -static struct pci_dev *triflex_dev; - -#ifdef CONFIG_PROC_FS -static int triflex_get_info(char *buf, char **addr, off_t offset, int count) -{ - char *p = buf; - int len; - - struct pci_dev *dev = triflex_dev; - unsigned long bibma = pci_resource_start(dev, 4); - u8 c0 = 0, c1 = 0; - u32 pri_timing, sec_timing; - - p += sprintf(p, "\n Compaq Triflex Chipset\n"); - - pci_read_config_dword(dev, 0x70, &pri_timing); - pci_read_config_dword(dev, 0x74, &sec_timing); - - /* - * at that point bibma+0x2 et bibma+0xa are byte registers - * to investigate: - */ - c0 = inb((unsigned short)bibma + 0x02); - c1 = inb((unsigned short)bibma + 0x0a); - - p += sprintf(p, "--------------- Primary Channel " - "---------------- Secondary Channel " - "-------------\n"); - p += sprintf(p, " %sabled " - " %sabled\n", - (c0&0x80) ? "dis" : " en", - (c1&0x80) ? "dis" : " en"); - p += sprintf(p, "--------------- drive0 --------- drive1 " - "-------- drive0 ---------- drive1 ------\n"); - p += sprintf(p, "DMA enabled: %s %s " - " %s %s\n", - (c0&0x20) ? "yes" : "no ", - (c0&0x40) ? "yes" : "no ", - (c1&0x20) ? "yes" : "no ", - (c1&0x40) ? "yes" : "no " ); - - p += sprintf(p, "DMA\n"); - p += sprintf(p, "PIO\n"); - - len = (p - buf) - offset; - *addr = buf + offset; - - return len > count ? count : len; -} -#endif - static int triflex_tune_chipset(ide_drive_t *drive, u8 xferspeed) { ide_hwif_t *hwif = HWIF(drive); @@ -206,18 +155,8 @@ static void __init init_hwif_triflex(ide_hwif_t *hwif) hwif->drives[1].autodma = hwif->autodma; } -static unsigned int __init init_chipset_triflex(struct pci_dev *dev, - const char *name) -{ -#ifdef CONFIG_PROC_FS - ide_pci_create_host_proc("triflex", triflex_get_info); -#endif - return 0; -} - static ide_pci_device_t triflex_device __devinitdata = { .name = "TRIFLEX", - .init_chipset = init_chipset_triflex, .init_hwif = init_hwif_triflex, .channels = 2, .autodma = AUTODMA, @@ -229,7 +168,6 @@ static int __devinit triflex_init_one(struct pci_dev *dev, const struct pci_device_id *id) { ide_setup_pci_device(dev, &triflex_device); - triflex_dev = dev; return 0; } @@ -242,7 +180,7 @@ static struct pci_device_id triflex_pci_tbl[] = { MODULE_DEVICE_TABLE(pci, triflex_pci_tbl); static struct pci_driver driver = { - .name = "TRIFLEX IDE", + .name = "TRIFLEX_IDE", .id_table = triflex_pci_tbl, .probe = triflex_init_one, };