X-Git-Url: http://git.onelab.eu/?a=blobdiff_plain;f=drivers%2Fscsi%2Fsata_uli.c;h=38b52bd3fa3f1d5772ca83a8cb3341c9fad24862;hb=43bc926fffd92024b46cafaf7350d669ba9ca884;hp=a71fb54eebd301e07240310964a323b240db670d;hpb=cee37fe97739d85991964371c1f3a745c00dd236;p=linux-2.6.git diff --git a/drivers/scsi/sata_uli.c b/drivers/scsi/sata_uli.c index a71fb54ee..38b52bd3f 100644 --- a/drivers/scsi/sata_uli.c +++ b/drivers/scsi/sata_uli.c @@ -1,21 +1,26 @@ /* * sata_uli.c - ULi Electronics SATA * - * The contents of this file are subject to the Open - * Software License version 1.1 that can be found at - * http://www.opensource.org/licenses/osl-1.1.txt and is included herein - * by reference. * - * Alternatively, the contents of this file may be used under the terms - * of the GNU General Public License version 2 (the "GPL") as distributed - * in the kernel source COPYING file, in which case the provisions of - * the GPL are applicable instead of the above. If you wish to allow - * the use of your version of this file only under the terms of the - * GPL and not to allow others to use your version of this file under - * the OSL, indicate your decision by deleting the provisions above and - * replace them with the notice and other provisions required by the GPL. - * If you do not delete the provisions above, a recipient may use your - * version of this file under either the OSL or the GPL. + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2, or (at your option) + * any later version. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; see the file COPYING. If not, write to + * the Free Software Foundation, 675 Mass Ave, Cambridge, MA 02139, USA. + * + * + * libata documentation is available via 'make {ps|pdf}docs', + * as Documentation/DocBook/libata.* + * + * Hardware documentation available under NDA. * */ @@ -27,7 +32,7 @@ #include #include #include -#include "scsi.h" +#include #include #include @@ -39,6 +44,8 @@ enum { uli_5287 = 1, uli_5281 = 2, + uli_max_ports = 4, + /* PCI configuration registers */ ULI5287_BASE = 0x90, /* sata0 phy SCR registers */ ULI5287_OFFS = 0x10, /* offset from sata0->sata1 phy regs */ @@ -46,11 +53,15 @@ enum { ULI5281_OFFS = 0x60, /* offset from sata0->sata1 phy regs */ }; +struct uli_priv { + unsigned int scr_cfg_addr[uli_max_ports]; +}; + static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent); static u32 uli_scr_read (struct ata_port *ap, unsigned int sc_reg); static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val); -static struct pci_device_id uli_pci_tbl[] = { +static const struct pci_device_id uli_pci_tbl[] = { { PCI_VENDOR_ID_AL, 0x5289, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5289 }, { PCI_VENDOR_ID_AL, 0x5287, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5287 }, { PCI_VENDOR_ID_AL, 0x5281, PCI_ANY_ID, PCI_ANY_ID, 0, 0, uli_5281 }, @@ -65,16 +76,14 @@ static struct pci_driver uli_pci_driver = { .remove = ata_pci_remove_one, }; -static Scsi_Host_Template uli_sht = { +static struct scsi_host_template uli_sht = { .module = THIS_MODULE, .name = DRV_NAME, .ioctl = ata_scsi_ioctl, .queuecommand = ata_scsi_queuecmd, - .eh_strategy_handler = ata_scsi_error, .can_queue = ATA_DEF_QUEUE, .this_id = ATA_SHT_THIS_ID, .sg_tablesize = LIBATA_MAX_PRD, - .max_sectors = ATA_MAX_SECTORS, .cmd_per_lun = ATA_SHT_CMD_PER_LUN, .emulated = ATA_SHT_EMULATED, .use_clustering = ATA_SHT_USE_CLUSTERING, @@ -82,10 +91,9 @@ static Scsi_Host_Template uli_sht = { .dma_boundary = ATA_DMA_BOUNDARY, .slave_configure = ata_scsi_slave_config, .bios_param = ata_std_bios_param, - .ordered_flush = 1, }; -static struct ata_port_operations uli_ops = { +static const struct ata_port_operations uli_ops = { .port_disable = ata_port_disable, .tf_load = ata_tf_load, @@ -120,8 +128,8 @@ static struct ata_port_info uli_port_info = { .sht = &uli_sht, .host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET | ATA_FLAG_NO_LEGACY, - .pio_mask = 0x03, //support pio mode 4 (FIXME) - .udma_mask = 0x7f, //support udma mode 6 + .pio_mask = 0x1f, /* pio0-4 */ + .udma_mask = 0x7f, /* udma0-6 */ .port_ops = &uli_ops, }; @@ -134,7 +142,8 @@ MODULE_VERSION(DRV_VERSION); static unsigned int get_scr_cfg_addr(struct ata_port *ap, unsigned int sc_reg) { - return ap->ioaddr.scr_addr + (4 * sc_reg); + struct uli_priv *hpriv = ap->host_set->private_data; + return hpriv->scr_cfg_addr[ap->port_no] + (4 * sc_reg); } static u32 uli_scr_cfg_read (struct ata_port *ap, unsigned int sc_reg) @@ -171,25 +180,18 @@ static void uli_scr_write (struct ata_port *ap, unsigned int sc_reg, u32 val) uli_scr_cfg_write(ap, sc_reg, val); } -/* move to PCI layer, integrate w/ MSI stuff */ -static void pci_enable_intx(struct pci_dev *pdev) -{ - u16 pci_command; - - pci_read_config_word(pdev, PCI_COMMAND, &pci_command); - if (pci_command & PCI_COMMAND_INTX_DISABLE) { - pci_command &= ~PCI_COMMAND_INTX_DISABLE; - pci_write_config_word(pdev, PCI_COMMAND, pci_command); - } -} - static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) { + static int printed_version; struct ata_probe_ent *probe_ent; struct ata_port_info *ppi; int rc; unsigned int board_idx = (unsigned int) ent->driver_data; int pci_dev_busy = 0; + struct uli_priv *hpriv; + + if (!printed_version++) + dev_printk(KERN_INFO, &pdev->dev, "version " DRV_VERSION "\n"); rc = pci_enable_device(pdev); if (rc) @@ -209,16 +211,24 @@ static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) goto err_out_regions; ppi = &uli_port_info; - probe_ent = ata_pci_init_native_mode(pdev, &ppi); + probe_ent = ata_pci_init_native_mode(pdev, &ppi, ATA_PORT_PRIMARY | ATA_PORT_SECONDARY); if (!probe_ent) { rc = -ENOMEM; goto err_out_regions; } - + + hpriv = kzalloc(sizeof(*hpriv), GFP_KERNEL); + if (!hpriv) { + rc = -ENOMEM; + goto err_out_probe_ent; + } + + probe_ent->private_data = hpriv; + switch (board_idx) { case uli_5287: - probe_ent->port[0].scr_addr = ULI5287_BASE; - probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS; + hpriv->scr_cfg_addr[0] = ULI5287_BASE; + hpriv->scr_cfg_addr[1] = ULI5287_BASE + ULI5287_OFFS; probe_ent->n_ports = 4; probe_ent->port[2].cmd_addr = pci_resource_start(pdev, 0) + 8; @@ -226,27 +236,27 @@ static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) probe_ent->port[2].ctl_addr = (pci_resource_start(pdev, 1) | ATA_PCI_CTL_OFS) + 4; probe_ent->port[2].bmdma_addr = pci_resource_start(pdev, 4) + 16; - probe_ent->port[2].scr_addr = ULI5287_BASE + ULI5287_OFFS*4; + hpriv->scr_cfg_addr[2] = ULI5287_BASE + ULI5287_OFFS*4; probe_ent->port[3].cmd_addr = pci_resource_start(pdev, 2) + 8; probe_ent->port[3].altstatus_addr = probe_ent->port[3].ctl_addr = (pci_resource_start(pdev, 3) | ATA_PCI_CTL_OFS) + 4; probe_ent->port[3].bmdma_addr = pci_resource_start(pdev, 4) + 24; - probe_ent->port[3].scr_addr = ULI5287_BASE + ULI5287_OFFS*5; + hpriv->scr_cfg_addr[3] = ULI5287_BASE + ULI5287_OFFS*5; ata_std_ports(&probe_ent->port[2]); ata_std_ports(&probe_ent->port[3]); break; case uli_5289: - probe_ent->port[0].scr_addr = ULI5287_BASE; - probe_ent->port[1].scr_addr = ULI5287_BASE + ULI5287_OFFS; + hpriv->scr_cfg_addr[0] = ULI5287_BASE; + hpriv->scr_cfg_addr[1] = ULI5287_BASE + ULI5287_OFFS; break; case uli_5281: - probe_ent->port[0].scr_addr = ULI5281_BASE; - probe_ent->port[1].scr_addr = ULI5281_BASE + ULI5281_OFFS; + hpriv->scr_cfg_addr[0] = ULI5281_BASE; + hpriv->scr_cfg_addr[1] = ULI5281_BASE + ULI5281_OFFS; break; default: @@ -255,7 +265,7 @@ static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) } pci_set_master(pdev); - pci_enable_intx(pdev); + pci_intx(pdev, 1); /* FIXME: check ata_device_add return value */ ata_device_add(probe_ent); @@ -263,9 +273,10 @@ static int uli_init_one (struct pci_dev *pdev, const struct pci_device_id *ent) return 0; +err_out_probe_ent: + kfree(probe_ent); err_out_regions: pci_release_regions(pdev); - err_out: if (!pci_dev_busy) pci_disable_device(pdev);