Use the 'Test Reboot' button. This will set the boot state to 'reinstall' and
attempt to reboot your machine using the registered PCU.
If Reboot fails,
there will be an error displayed that will assist you in
diagnosing the error. Otherwise, please double check the
registered information for the PCU, and that you can operate the
PCU manually (using it's web or ssh interface).
To try the test again, use 'Test Reboot'.
If you need help diagnosing the problem, please contact
PlanetLab Support.
Reboot Failure:
If Reboot succeeds,
your machine will reboot, install the bootstrap image, and
contacted PLC. Finally, the boot state will be updated to 'boot'.
Continue using the 'Reload' button to check whether the node has
completed its installation.
Reboot without error:
No errors were reported for your reboot. Please double check by
confirming at the console. If the reboot failed, please report this
to PlanetLab Feedback.
Success!!
The installation is complete; your machine has reached the final
'boot' state. You can continue to the final stage.
Site:
Hostname:
Boot State:
Start with the 'Test Reboot' button. 'Test Reboot' to start again.
'Reload' to Reload this page.
Success!! Your machine has booted and contacted PLC.
'Continue' to the final stage.
If you do not see an error, this does not mean that none have
occurred. We need your help in verifying that the PCU function is
configured correctly.
Please be patient. Installations may take between 10 to 30
minutes depending on the speed of your hardware and network. Checking the
console is the fastest way to verify that the installation is proceeding.