-void (*phy_reset) (struct ata_port *ap);
- </programlisting>
-
- <para>
-Deprecated. Use ->error_handler() instead.
- </para>
-
- <programlisting>
-void (*freeze) (struct ata_port *ap);
-void (*thaw) (struct ata_port *ap);
- </programlisting>
-
- <para>
-ata_port_freeze() is called when HSM violations or some other
-condition disrupts normal operation of the port. A frozen port
-is not allowed to perform any operation until the port is
-thawed, which usually follows a successful reset.
- </para>
-
- <para>
-The optional ->freeze() callback can be used for freezing the port
-hardware-wise (e.g. mask interrupt and stop DMA engine). If a
-port cannot be frozen hardware-wise, the interrupt handler
-must ack and clear interrupts unconditionally while the port
-is frozen.
- </para>
- <para>
-The optional ->thaw() callback is called to perform the opposite of ->freeze():
-prepare the port for normal operation once again. Unmask interrupts,
-start DMA engine, etc.
- </para>
-
- <programlisting>
-void (*error_handler) (struct ata_port *ap);
- </programlisting>
-
- <para>
-->error_handler() is a driver's hook into probe, hotplug, and recovery
-and other exceptional conditions. The primary responsibility of an
-implementation is to call ata_do_eh() or ata_bmdma_drive_eh() with a set
-of EH hooks as arguments:
- </para>
-
- <para>
-'prereset' hook (may be NULL) is called during an EH reset, before any other actions
-are taken.
- </para>
-
- <para>
-'postreset' hook (may be NULL) is called after the EH reset is performed. Based on
-existing conditions, severity of the problem, and hardware capabilities,
- </para>
-
- <para>
-Either 'softreset' (may be NULL) or 'hardreset' (may be NULL) will be
-called to perform the low-level EH reset.
- </para>
-
- <programlisting>
-void (*post_internal_cmd) (struct ata_queued_cmd *qc);