+journal=inum When a journal already exists, this option is ignored.
+ Otherwise, it specifies the number of the inode which
+ will represent the ext3 file system's journal file.
+
+journal_dev=devnum When the external journal device's major/minor numbers
+ have changed, this option allows the user to specify
+ the new journal location. The journal device is
+ identified through its new major/minor numbers encoded
+ in devnum.
+
+noload Don't load the journal on mounting.
+
+data=journal All data are committed into the journal prior to being
+ written into the main file system.
+
+data=ordered (*) All data are forced directly out to the main file
+ system prior to its metadata being committed to the
+ journal.
+
+data=writeback Data ordering is not preserved, data may be written
+ into the main file system after its metadata has been
+ committed to the journal.
+
+commit=nrsec (*) Ext3 can be told to sync all its data and metadata
+ every 'nrsec' seconds. The default value is 5 seconds.
+ This means that if you lose your power, you will lose
+ as much as the latest 5 seconds of work (your
+ filesystem will not be damaged though, thanks to the
+ journaling). This default value (or any low value)
+ will hurt performance, but it's good for data-safety.
+ Setting it to 0 will have the same effect as leaving
+ it at the default (5 seconds).
+ Setting it to very large values will improve
+ performance.
+
+barrier=1 This enables/disables barriers. barrier=0 disables
+ it, barrier=1 enables it.
+
+orlov (*) This enables the new Orlov block allocator. It is
+ enabled by default.
+
+oldalloc This disables the Orlov block allocator and enables
+ the old block allocator. Orlov should have better
+ performance - we'd like to get some feedback if it's
+ the contrary for you.
+
+user_xattr Enables Extended User Attributes. Additionally, you
+ need to have extended attribute support enabled in the
+ kernel configuration (CONFIG_EXT3_FS_XATTR). See the
+ attr(5) manual page and http://acl.bestbits.at/ to
+ learn more about extended attributes.
+
+nouser_xattr Disables Extended User Attributes.
+
+acl Enables POSIX Access Control Lists support.
+ Additionally, you need to have ACL support enabled in
+ the kernel configuration (CONFIG_EXT3_FS_POSIX_ACL).
+ See the acl(5) manual page and http://acl.bestbits.at/
+ for more information.
+
+noacl This option disables POSIX Access Control List
+ support.
+
+reservation
+
+noreservation