+ CNTR(dma_ch) = dma_length;
+
+ return 0;
+}
+
+/**
+ * imx_dma_setup_sg - setup i.MX DMA channel SG list to/from device transfer
+ * @dma_ch: i.MX DMA channel number
+ * @sg: pointer to the scatter-gather list/vector
+ * @sgcount: scatter-gather list hungs count
+ * @dma_length: total length of the transfer request in bytes
+ * @dev_addr: physical device port address
+ * @dmamode: DMA transfer mode, %DMA_MODE_READ from the device to the memory
+ * or %DMA_MODE_WRITE from memory to the device
+ *
+ * The function setups DMA channel state and registers to be ready for transfer
+ * specified by provided parameters. The scatter-gather emulation is set up
+ * according to the parameters.
+ *
+ * The full preparation of the transfer requires setup of more register
+ * by the caller before imx_dma_enable() can be called.
+ *
+ * %BLR(dma_ch) holds transfer burst length in bytes, 0 means 64 bytes
+ *
+ * %RSSR(dma_ch) has to be set to the DMA request line source %DMA_REQ_xxx
+ *
+ * %CCR(dma_ch) has to specify transfer parameters, the next settings is typical
+ * for linear or simple scatter-gather transfers if %DMA_MODE_READ is specified
+ *
+ * %CCR_DMOD_LINEAR | %CCR_DSIZ_32 | %CCR_SMOD_FIFO | %CCR_SSIZ_x
+ *
+ * The typical setup for %DMA_MODE_WRITE is specified by next options combination
+ *
+ * %CCR_SMOD_LINEAR | %CCR_SSIZ_32 | %CCR_DMOD_FIFO | %CCR_DSIZ_x
+ *
+ * Be carefull there and do not mistakenly mix source and target device
+ * port sizes constants, they are really different:
+ * %CCR_SSIZ_8, %CCR_SSIZ_16, %CCR_SSIZ_32,
+ * %CCR_DSIZ_8, %CCR_DSIZ_16, %CCR_DSIZ_32
+ *
+ * Return value: if incorrect parameters are provided -%EINVAL.
+ * Zero indicates success.
+ */
+int
+imx_dma_setup_sg(imx_dmach_t dma_ch,
+ struct scatterlist *sg, unsigned int sgcount, unsigned int dma_length,
+ unsigned int dev_addr, dmamode_t dmamode)
+{
+ int res;
+ struct imx_dma_channel *imxdma = &imx_dma_channels[dma_ch];
+
+ imxdma->sg = NULL;
+ imxdma->sgcount = 0;
+ imxdma->dma_mode = dmamode;
+ imxdma->resbytes = dma_length;
+
+ if (!sg || !sgcount) {
+ printk(KERN_ERR "imxdma%d: imx_dma_setup_sg epty sg list\n",
+ dma_ch);
+ return -EINVAL;