-
- if (test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery)) {
- /* reshaping is quite different to recovery/resync so it is
- * handled quite separately ... here.
- *
- * On each call to sync_request, we gather one chunk worth of
- * destination stripes and flag them as expanding.
- * Then we find all the source stripes and request reads.
- * As the reads complete, handle_stripe will copy the data
- * into the destination stripe and release that stripe.
- */
- int i;
- int dd_idx;
- sector_t writepos, safepos, gap;
-
- if (sector_nr == 0 &&
- conf->expand_progress != 0) {
- /* restarting in the middle, skip the initial sectors */
- sector_nr = conf->expand_progress;
- sector_div(sector_nr, conf->raid_disks-1);
- *skipped = 1;
- return sector_nr;
- }
-
- /* we update the metadata when there is more than 3Meg
- * in the block range (that is rather arbitrary, should
- * probably be time based) or when the data about to be
- * copied would over-write the source of the data at
- * the front of the range.
- * i.e. one new_stripe forward from expand_progress new_maps
- * to after where expand_lo old_maps to
- */
- writepos = conf->expand_progress +
- conf->chunk_size/512*(conf->raid_disks-1);
- sector_div(writepos, conf->raid_disks-1);
- safepos = conf->expand_lo;
- sector_div(safepos, conf->previous_raid_disks-1);
- gap = conf->expand_progress - conf->expand_lo;
-
- if (writepos >= safepos ||
- gap > (conf->raid_disks-1)*3000*2 /*3Meg*/) {
- /* Cannot proceed until we've updated the superblock... */
- wait_event(conf->wait_for_overlap,
- atomic_read(&conf->reshape_stripes)==0);
- mddev->reshape_position = conf->expand_progress;
- mddev->sb_dirty = 1;
- md_wakeup_thread(mddev->thread);
- wait_event(mddev->sb_wait, mddev->sb_dirty == 0 ||
- kthread_should_stop());
- spin_lock_irq(&conf->device_lock);
- conf->expand_lo = mddev->reshape_position;
- spin_unlock_irq(&conf->device_lock);
- wake_up(&conf->wait_for_overlap);
- }
-
- for (i=0; i < conf->chunk_size/512; i+= STRIPE_SECTORS) {
- int j;
- int skipped = 0;
- pd_idx = stripe_to_pdidx(sector_nr+i, conf, conf->raid_disks);
- sh = get_active_stripe(conf, sector_nr+i,
- conf->raid_disks, pd_idx, 0);
- set_bit(STRIPE_EXPANDING, &sh->state);
- atomic_inc(&conf->reshape_stripes);
- /* If any of this stripe is beyond the end of the old
- * array, then we need to zero those blocks
- */
- for (j=sh->disks; j--;) {
- sector_t s;
- if (j == sh->pd_idx)
- continue;
- s = compute_blocknr(sh, j);
- if (s < (mddev->array_size<<1)) {
- skipped = 1;
- continue;
- }
- memset(page_address(sh->dev[j].page), 0, STRIPE_SIZE);
- set_bit(R5_Expanded, &sh->dev[j].flags);
- set_bit(R5_UPTODATE, &sh->dev[j].flags);
- }
- if (!skipped) {
- set_bit(STRIPE_EXPAND_READY, &sh->state);
- set_bit(STRIPE_HANDLE, &sh->state);
- }
- release_stripe(sh);
- }
- spin_lock_irq(&conf->device_lock);
- conf->expand_progress = (sector_nr + i)*(conf->raid_disks-1);
- spin_unlock_irq(&conf->device_lock);
- /* Ok, those stripe are ready. We can start scheduling
- * reads on the source stripes.
- * The source stripes are determined by mapping the first and last
- * block on the destination stripes.
- */
- raid_disks = conf->previous_raid_disks;
- data_disks = raid_disks - 1;
- first_sector =
- raid5_compute_sector(sector_nr*(conf->raid_disks-1),
- raid_disks, data_disks,
- &dd_idx, &pd_idx, conf);
- last_sector =
- raid5_compute_sector((sector_nr+conf->chunk_size/512)
- *(conf->raid_disks-1) -1,
- raid_disks, data_disks,
- &dd_idx, &pd_idx, conf);
- if (last_sector >= (mddev->size<<1))
- last_sector = (mddev->size<<1)-1;
- while (first_sector <= last_sector) {
- pd_idx = stripe_to_pdidx(first_sector, conf, conf->previous_raid_disks);
- sh = get_active_stripe(conf, first_sector,
- conf->previous_raid_disks, pd_idx, 0);
- set_bit(STRIPE_EXPAND_SOURCE, &sh->state);
- set_bit(STRIPE_HANDLE, &sh->state);
- release_stripe(sh);
- first_sector += STRIPE_SECTORS;
- }
- return conf->chunk_size>>9;
- }