+ This enables the NAND flash driver on the PPChameleon EVB Board.
+
+config MTD_NAND_S3C2410
+ tristate "NAND Flash support for S3C2410/S3C2440 SoC"
+ depends on ARCH_S3C2410 && MTD_NAND
+ help
+ This enables the NAND flash controller on the S3C2410 and S3C2440
+ SoCs
+
+ No board specific support is done by this driver, each board
+ must advertise a platform_device for the driver to attach.
+
+config MTD_NAND_S3C2410_DEBUG
+ bool "S3C2410 NAND driver debug"
+ depends on MTD_NAND_S3C2410
+ help
+ Enable debugging of the S3C2410 NAND driver
+
+config MTD_NAND_S3C2410_HWECC
+ bool "S3C2410 NAND Hardware ECC"
+ depends on MTD_NAND_S3C2410
+ help
+ Enable the use of the S3C2410's internal ECC generator when
+ using NAND. Early versions of the chip have had problems with
+ incorrect ECC generation, and if using these, the default of
+ software ECC is preferable.
+
+ If you lay down a device with the hardware ECC, then you will
+ currently not be able to switch to software, as there is no
+ implementation for ECC method used by the S3C2410
+
+config MTD_NAND_NDFC
+ tristate "NDFC NanD Flash Controller"
+ depends on MTD_NAND && 44x
+ select MTD_NAND_ECC_SMC
+ help
+ NDFC Nand Flash Controllers are integrated in EP44x SoCs
+
+config MTD_NAND_S3C2410_CLKSTOP
+ bool "S3C2410 NAND IDLE clock stop"
+ depends on MTD_NAND_S3C2410
+ default n
+ help
+ Stop the clock to the NAND controller when there is no chip
+ selected to save power. This will mean there is a small delay
+ when the is NAND chip selected or released, but will save
+ approximately 5mA of power when there is nothing happening.