-#else /* CONFIG_X86_PC9800 */
-#define STATUS (0x0000)
-#define TX_STATUS (0x0000)
-#define RX_STATUS (0x0001)
-#define TX_INTR (0x0200)/* Bit-mapped interrupt enable registers. */
-#define RX_INTR (0x0201)
-#define TX_MODE (0x0400)
-#define RX_MODE (0x0401)
-#define CONFIG_0 (0x0600)/* Misc. configuration settings. */
-#define CONFIG_1 (0x0601)
-/* Run-time register bank 2 definitions. */
-#define DATAPORT (0x0800)/* Word-wide DMA or programmed-I/O dataport. */
-#define TX_START (0x0a00)
-#define COL16CNTL (0x0a01)/* Controll Reg for 16 collisions */
-#define MODE13 (0x0c01)
-#define RX_CTRL (0x0e00)
-/* Configuration registers only on the '865A/B chips. */
-#define EEPROM_Ctrl (0x1000)
-#define EEPROM_Data (0x1200)
-#define CARDSTATUS 16 /* FMV-18x Card Status */
-#define CARDSTATUS1 17 /* FMV-18x Card Status */
-#define IOCONFIG (0x1400)/* Either read the jumper, or move the I/O. */
-#define IOCONFIG1 (0x1600)
-#define SAPROM 20 /* The station address PROM, if no EEPROM. */
-#define MODE24 (0x1800)/* The station address PROM, if no EEPROM. */
-#define RESET (0x1e01)/* Write to reset some parts of the chip. */
-#define PORT_OFFSET(o) ({ int _o_ = (o); (_o_ & ~1) * 0x100 + (_o_ & 1); })
-#endif /* CONFIG_X86_PC9800 */