+config W1_MATROX
+ tristate "Matrox G400 transport layer for 1-wire"
+ depends on W1 && PCI
+ help
+ Say Y here if you want to communicate with your 1-wire devices
+ using Matrox's G400 GPIO pins.
+
+ This support is also available as a module. If so, the module
+ will be called matrox_w1.ko.
+
+config W1_DS9490
+ tristate "DS9490R transport layer driver"
+ depends on W1 && USB
+ help
+ Say Y here if you want to have a driver for DS9490R UWB <-> W1 bridge.
+
+ This support is also available as a module. If so, the module
+ will be called ds9490r.ko.
+
+config W1_DS9490_BRIDGE
+ tristate "DS9490R USB <-> W1 transport layer for 1-wire"
+ depends on W1_DS9490
+ help
+ Say Y here if you want to communicate with your 1-wire devices
+ using DS9490R USB bridge.
+
+ This support is also available as a module. If so, the module
+ will be called ds_w1_bridge.ko.
+
+config W1_THERM
+ tristate "Thermal family implementation"
+ depends on W1
+ help
+ Say Y here if you want to connect 1-wire thermal sensors to you
+ wire.
+
+config W1_SMEM
+ tristate "Simple 64bit memory family implementation"
+ depends on W1
+ help
+ Say Y here if you want to connect 1-wire
+ simple 64bit memory rom(ds2401/ds2411/ds1990*) to you wire.
+
+config W1_DS2433
+ tristate "4kb EEPROM family support (DS2433)"
+ depends on W1
+ help
+ Say Y here if you want to use a 1-wire
+ 4kb EEPROM family device (DS2433).
+
+config W1_DS2433_CRC
+ bool "Protect DS2433 data with a CRC16"
+ depends on W1_DS2433
+ select CRC16
+ help
+ Say Y here to protect DS2433 data with a CRC16.
+ Each block has 30 bytes of data and a two byte CRC16.
+ Full block writes are only allowed if the CRC is valid.