+ /* NAND / SmartMedia */
+struct at91_nand_data {
+ u8 enable_pin; /* chip enable */
+ u8 det_pin; /* card detect */
+ u8 rdy_pin; /* ready/busy */
+ u8 ale; /* address line number connected to ALE */
+ u8 cle; /* address line number connected to CLE */
+ u8 bus_width_16; /* buswidth is 16 bit */
+ struct mtd_partition* (*partition_info)(int, int*);
+};
+extern void __init at91_add_device_nand(struct at91_nand_data *data);
+
+ /* I2C*/
+extern void __init at91_add_device_i2c(void);
+
+ /* SPI */
+extern void __init at91_add_device_spi(struct spi_board_info *devices, int nr_devices);
+
+ /* Serial */
+struct at91_uart_config {
+ unsigned short console_tty; /* tty number of serial console */
+ unsigned short nr_tty; /* number of serial tty's */
+ short tty_map[]; /* map UART to tty number */
+};
+extern struct platform_device *atmel_default_console_device;
+extern void __init at91_init_serial(struct at91_uart_config *config);
+
+struct atmel_uart_data {
+ short use_dma_tx; /* use transmit DMA? */
+ short use_dma_rx; /* use receive DMA? */
+ void __iomem *regs; /* virtual base address, if any */
+};
+extern void __init at91_add_device_serial(void);
+
+ /* LEDs */
+extern u8 at91_leds_cpu;
+extern u8 at91_leds_timer;
+extern void __init at91_init_leds(u8 cpu_led, u8 timer_led);
+