+/*
+ * Hypertransport sub capability types
+ *
+ * Unfortunately there are both 3 bit and 5 bit capability types defined
+ * in the HT spec, catering for that is a little messy. You probably don't
+ * want to use these directly, just use pci_find_ht_capability() and it
+ * will do the right thing for you.
+ */
+#define HT_3BIT_CAP_MASK 0xE0
+#define HT_CAPTYPE_SLAVE 0x00 /* Slave/Primary link configuration */
+#define HT_CAPTYPE_HOST 0x20 /* Host/Secondary link configuration */
+
+#define HT_5BIT_CAP_MASK 0xF8
+#define HT_CAPTYPE_IRQ 0x80 /* IRQ Configuration */
+#define HT_CAPTYPE_REMAPPING_40 0xA0 /* 40 bit address remapping */
+#define HT_CAPTYPE_REMAPPING_64 0xA2 /* 64 bit address remapping */
+#define HT_CAPTYPE_UNITID_CLUMP 0x90 /* Unit ID clumping */
+#define HT_CAPTYPE_EXTCONF 0x98 /* Extended Configuration Space Access */
+#define HT_CAPTYPE_MSI_MAPPING 0xA8 /* MSI Mapping Capability */
+#define HT_MSI_FLAGS 0x02 /* Offset to flags */
+#define HT_MSI_FLAGS_ENABLE 0x1 /* Mapping enable */
+#define HT_MSI_FLAGS_FIXED 0x2 /* Fixed mapping only */
+#define HT_MSI_FIXED_ADDR 0x00000000FEE00000ULL /* Fixed addr */
+#define HT_MSI_ADDR_LO 0x04 /* Offset to low addr bits */
+#define HT_MSI_ADDR_LO_MASK 0xFFF00000 /* Low address bit mask */
+#define HT_MSI_ADDR_HI 0x08 /* Offset to high addr bits */
+#define HT_CAPTYPE_DIRECT_ROUTE 0xB0 /* Direct routing configuration */
+#define HT_CAPTYPE_VCSET 0xB8 /* Virtual Channel configuration */
+#define HT_CAPTYPE_ERROR_RETRY 0xC0 /* Retry on error configuration */
+#define HT_CAPTYPE_GEN3 0xD0 /* Generation 3 hypertransport configuration */
+#define HT_CAPTYPE_PM 0xE0 /* Hypertransport powermanagement configuration */
+
+