+config NF_CONNTRACK_H323
+ tristate "H.323 protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK && (IPV6 || IPV6=n)
+ help
+ H.323 is a VoIP signalling protocol from ITU-T. As one of the most
+ important VoIP protocols, it is widely used by voice hardware and
+ software including voice gateways, IP phones, Netmeeting, OpenPhone,
+ Gnomemeeting, etc.
+
+ With this module you can support H.323 on a connection tracking/NAT
+ firewall.
+
+ This module supports RAS, Fast Start, H.245 Tunnelling, Call
+ Forwarding, RTP/RTCP and T.120 based audio, video, fax, chat,
+ whiteboard, file transfer, etc. For more information, please
+ visit http://nath323.sourceforge.net/.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_IRC
+ tristate "IRC protocol support"
+ depends on NF_CONNTRACK
+ help
+ There is a commonly-used extension to IRC called
+ Direct Client-to-Client Protocol (DCC). This enables users to send
+ files to each other, and also chat to each other without the need
+ of a server. DCC Sending is used anywhere you send files over IRC,
+ and DCC Chat is most commonly used by Eggdrop bots. If you are
+ using NAT, this extension will enable you to send files and initiate
+ chats. Note that you do NOT need this extension to get files or
+ have others initiate chats, or everything else in IRC.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_NETBIOS_NS
+ tristate "NetBIOS name service protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK
+ help
+ NetBIOS name service requests are sent as broadcast messages from an
+ unprivileged port and responded to with unicast messages to the
+ same port. This make them hard to firewall properly because connection
+ tracking doesn't deal with broadcasts. This helper tracks locally
+ originating NetBIOS name service requests and the corresponding
+ responses. It relies on correct IP address configuration, specifically
+ netmask and broadcast address. When properly configured, the output
+ of "ip address show" should look similar to this:
+
+ $ ip -4 address show eth0
+ 4: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
+ inet 172.16.2.252/24 brd 172.16.2.255 scope global eth0
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_PPTP
+ tristate "PPtP protocol support"
+ depends on NF_CONNTRACK
+ select NF_CT_PROTO_GRE
+ help
+ This module adds support for PPTP (Point to Point Tunnelling
+ Protocol, RFC2637) connection tracking and NAT.
+
+ If you are running PPTP sessions over a stateful firewall or NAT
+ box, you may want to enable this feature.
+
+ Please note that not all PPTP modes of operation are supported yet.
+ Specifically these limitations exist:
+ - Blindy assumes that control connections are always established
+ in PNS->PAC direction. This is a violation of RFC2637.
+ - Only supports a single call within each session
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_SIP
+ tristate "SIP protocol support (EXPERIMENTAL)"
+ depends on EXPERIMENTAL && NF_CONNTRACK
+ help
+ SIP is an application-layer control protocol that can establish,
+ modify, and terminate multimedia sessions (conferences) such as
+ Internet telephony calls. With the ip_conntrack_sip and
+ the nf_nat_sip modules you can support the protocol on a connection
+ tracking/NATing firewall.
+
+ To compile it as a module, choose M here. If unsure, say N.
+
+config NF_CONNTRACK_TFTP
+ tristate "TFTP protocol support"
+ depends on NF_CONNTRACK
+ help
+ TFTP connection tracking helper, this is required depending
+ on how restrictive your ruleset is.
+ If you are using a tftp client behind -j SNAT or -j MASQUERADING
+ you will need this.
+
+ To compile it as a module, choose M here. If unsure, say N.
+