NET_ACT_POLICE, either built-in or as modules. (NET_CLS_POLICE is
obsolete and not needed.)
- If GRE tunneling is being used it is recommended that the kernel
- be compiled with IPv6 support (CONFIG_IPV6). This allows for
- special handling (such as path MTU discovery) of IPv6 packets.
+ To use GRE tunneling on Linux 2.6.37 or newer, kernel support
+ for GRE must be compiled in or available as a module
+ (CONFIG_NET_IPGRE_DEMUX).
To configure HTB or HFSC quality of service with Open vSwitch,
you must enable the respective configuration options.
6. Run "make install" to install the executables and manpages into the
running system, by default under /usr/local.
-7. If you built kernel modules, you may load them with "insmod", e.g.:
+7. If you built kernel modules, you may install and load them, e.g.:
- % insmod datapath/linux/openvswitch.ko
+ % make modules_install
+ % /sbin/modprobe openvswitch
- You may need to specify a full path to insmod, e.g. /sbin/insmod.
To verify that the modules have been loaded, run "/sbin/lsmod" and
check that openvswitch is listed.
- If the "insmod" operation fails, look at the last few kernel log
+ If the "modprobe" operation fails, look at the last few kernel log
messages (e.g. with "dmesg | tail"):
- The message "openvswitch: exports duplicate symbol
you do not understand what this means or do not know if your driver
will work, do not set this.
- Once you verify that the kernel modules load properly, you should
- install them:
-
- % make modules_install
-
8. Initialize the configuration database using ovsdb-tool, e.g.:
% mkdir -p /usr/local/etc/openvswitch
configuration in the database:
% ovsdb-server --remote=punix:/usr/local/var/run/openvswitch/db.sock \
- --remote=db:Open_vSwitch,manager_options \
- --private-key=db:SSL,private_key \
- --certificate=db:SSL,certificate \
- --bootstrap-ca-cert=db:SSL,ca_cert \
+ --remote=db:Open_vSwitch,Open_vSwitch,manager_options \
+ --private-key=db:Open_vSwitch,SSL,private_key \
+ --certificate=db:Open_vSwitch,SSL,certificate \
+ --bootstrap-ca-cert=db:Open_vSwitch,SSL,ca_cert \
--pidfile --detach
(If you built Open vSwitch without SSL support, then omit