---------------------
- Stable bond mode has been removed.
- The autopath action has been removed.
- - CAPWAP tunneling support removed.
- New support for the data encapsulation format of the LISP tunnel
protocol (RFC 6830). An external control plane or manual flow
setup is required for EID-to-RLOC mapping.
value of other-config:dp-desc in the Bridge table.
- It is possible to request the OpenFlow port number with the
"ofport_request" column in the Interface table.
+ - The NXM flow_removed message now reports the OpenFlow table ID
+ from which the flow was removed.
- Tunneling:
- New support for the VXLAN tunnel protocol (see the IETF draft here:
http://tools.ietf.org/html/draft-mahalingam-dutt-dcops-vxlan-03).
- Inheritance of the Don't Fragment bit in IP tunnels (df_inherit)
is no longer supported.
- Path MTU discovery is no longer supported.
+ - CAPWAP tunneling support removed.
+ - Tunnels with multicast destination ports are no longer supported.
- ovs-dpctl:
- The "dump-flows" and "del-flows" no longer require an argument
if only one datapath exists.
with FreeBSD and the kernel module built into Linux 3.3 and later.
-v1.9.0 - xx xxx xxxx
---------------------
+v1.9.0 - 26 Feb 2013
+------------------------
- Datapath:
- Support for ipv6 set action.
- SKB mark matching and setting.
data in ARP packets.
-v1.8.0 - xx xxx xxxx
+v1.8.0 - 26 Feb 2013
------------------------
+ *** Internal only release ***
- New FAQ. Please send updates and additions!
- Authors of controllers, please read the new section titled "Action
Reproduction" in DESIGN, which describes an Open vSwitch change in
git://git.onelab.eu / sliver-openvswitch.git / blobdiff