-post-v1.9.0
---------------------
+post-v1.11.0
+---------------------
+ - OpenFlow:
+ * New support for matching outer source and destination IP address
+ of tunneled packets, for tunnel ports configured with the newly
+ added "remote_ip=flow" and "local_ip=flow" options.
+ - New "check-oftest" Makefile target for running OFTest against Open
+ vSwitch. See README-OFTest for details.
+ - The flow eviction threshold has been moved to the Open_vSwitch table.
-v1.9.0 - xx xxx xxxx
---------------------
- - The tunneling code no longer assumes input and output keys are symmetric.
- If they are not, PMTUD needs to be disabled for tunneling to work. Note
- this only applies to flow-based keys.
+v1.11.0 - xx xxx xxxx
+---------------------
+ - The "tutorial" directory contains a new tutorial for some advanced
+ Open vSwitch features.
+ - Stable bond mode has been removed.
+ - The autopath action has been removed.
+ - New support for the data encapsulation format of the LISP tunnel
+ protocol (RFC 6830). An external control plane or manual flow
+ setup is required for EID-to-RLOC mapping.
+ - OpenFlow:
+ * The "dec_mpls_ttl" and "set_mpls_ttl" actions from OpenFlow
+ 1.1 and later are now implemented.
+ * New "stack" extension for use in actions, to push and pop from
+ NXM fields.
+ * The "load" and "set_field" actions can now modify the "in_port". (This
+ allows one to enable output to a flow's input port by setting the
+ in_port to some unused value, such as OFPP_NONE.)
+ - ovs-dpctl:
+ * New debugging commands "add-flow", "mod-flow", "del-flow".
+ - In dpif-based bridges, cache action translations, which can improve
+ flow set up performance by 80% with a complicated flow table.
+ - New syslog format, prefixed with "ovs|", to be easier to filter.
+ - RHEL: Removes the default firewall rule that allowed GRE traffic to
+ pass through. Any users that relied on this automatic firewall hole
+ will have to manually configure it. The ovs-ctl(8) manpage documents
+ the "enable-protocol" command that can be used as an alternative.
+ - New CFM demand mode which uses data traffic to indicate interface
+ liveness.
+
+v1.10.0 - 01 May 2013
+---------------------
+ - Bridge compatibility support has been removed. Any uses that
+ rely on ovs-brcompatd will have to stick with Open vSwitch 1.9.x
+ or adapt to native Open vSwitch support (e.g. use ovs-vsctl instead
+ of brctl).
+ - The maximum size of the MAC learning table is now configurable.
+ - With the Linux datapath, packets for new flows are now queued
+ separately on a per-port basis, so it should no longer be
+ possible for a large number of new flows arriving on one port to
+ prevent new flows from being processed on other ports.
+ - ovs-vsctl:
+ * Previously ovs-vsctl would retry connecting to the database forever,
+ causing it to hang if ovsdb-server was not running. Now, ovs-vsctl
+ only tries once by default (use --retry to try forever). This change
+ means that you may want to remove uses of --timeout to avoid hangs
+ in ovs-vsctl calls.
+ * Many "ovs-vsctl" database commands now accept an --if-exists option.
+ Please refer to the ovs-vsctl manpage for details.
+ - OpenFlow:
+ - Experimental support for newer versions of OpenFlow. See
+ the "What versions of OpenFlow does Open vSwitch support?"
+ question in the FAQ for more details.
+ - The OpenFlow "dp_desc" may now be configured by setting the
+ value of other-config:dp-desc in the Bridge table.
+ - It is possible to request the OpenFlow port number with the
+ "ofport_request" column in the Interface table.
+ - The NXM flow_removed message now reports the OpenFlow table ID
+ from which the flow was removed.
+ - Tunneling:
+ - New support for the VXLAN tunnel protocol (see the IETF draft here:
+ http://tools.ietf.org/html/draft-mahalingam-dutt-dcops-vxlan-03).
+ - Tunneling requires the version of the kernel module paired with
+ Open vSwitch 1.9.0 or later.
+ - Inheritance of the Don't Fragment bit in IP tunnels (df_inherit)
+ is no longer supported.
+ - Path MTU discovery is no longer supported.
+ - CAPWAP tunneling support removed.
+ - Tunnels with multicast destination ports are no longer supported.
+ - ovs-dpctl:
+ - The "dump-flows" and "del-flows" no longer require an argument
+ if only one datapath exists.
+ - ovs-appctl:
+ - New "vlog/disable-rate-limit" and "vlog/enable-rate-limit"
+ commands available allow control over logging rate limits.
+ - New "dpif/dump-dps", "dpif/show", and "dpif/dump-flows" command
+ that mimic the equivalent ovs-dpctl commands.
+ - The ofproto library is now responsible for assigning OpenFlow port
+ numbers. An ofproto implementation should assign them when
+ port_construct() is called.
+ - All dpif-based bridges of a particular type share a common
+ datapath called "ovs-<type>", e.g. "ovs-system". The ovs-dpctl
+ commands will now return information on that shared datapath. To
+ get the equivalent bridge-specific information, use the new
+ "ovs-appctl dpif/*" commands.
+ - Backward-incompatible changes:
+ - Earlier Open vSwitch versions treated ANY as a wildcard in flow
+ syntax. OpenFlow 1.1 adds a port named ANY, which introduces a
+ conflict. ANY was rarely used in flow syntax, so we chose to
+ retire that meaning of ANY in favor of the OpenFlow 1.1 meaning.
+ - Patch ports no longer require kernel support, so they now work
+ with FreeBSD and the kernel module built into Linux 3.3 and later.
+ - New "sample" action.
+
+
+v1.9.0 - 26 Feb 2013
+------------------------
+ - Datapath:
+ - Support for ipv6 set action.
+ - SKB mark matching and setting.
+ - support for Linux kernels up to 3.8
- FreeBSD is now a supported platform, thanks to code contributions from
Gaetano Catalli, Ed Maste, and Giuseppe Lettieri.
- ovs-bugtool: New --ovs option to report only OVS related information.
- Allow bitwise masking for SHA and THA fields in ARP, SLL and TLL
fields in IPv6 neighbor discovery messages, and IPv6 flow label.
- Adds support for writing to the metadata field for a flow.
+ - Tunneling:
+ - The tunneling code no longer assumes input and output keys are
+ symmetric. If they are not, PMTUD needs to be disabled for
+ tunneling to work. Note this only applies to flow-based keys.
+ - New support for a nonstandard form of GRE that supports a 64-bit key.
+ - Tunnel Path MTU Discovery default value was set to 'disabled'.
+ This feature is deprecated and will be removed soon.
+ - Tunnel header caching removed.
- ovs-ofctl:
- Commands and actions that accept port numbers now also accept keywords
that represent those ports (such as LOCAL, NONE, and ALL). This is
program was not included in distribution packaging.)
- ovsdb-server now enforces the immutability of immutable columns. This
was not enforced in earlier versions due to an oversight.
- - New support for a nonstandard form of GRE that supports a 64-bit key.
- The following features are now deprecated. They will be removed no
earlier than February 2013. Please email dev@openvswitch.org with
concerns.
+ - Bridge compatibility.
- Stable bond mode.
- The autopath action.
- Interface type "null".
- Numeric values for reserved ports (see "ovs-ofctl" note above).
+ - Tunnel Path MTU Discovery.
+ - CAPWAP tunnel support.
+ - The data in the RARP packets can now be matched in the same way as the
+ data in ARP packets.
-v1.8.0 - xx xxx xxxx
+v1.8.0 - 26 Feb 2013
------------------------
+ *** Internal only release ***
- New FAQ. Please send updates and additions!
- Authors of controllers, please read the new section titled "Action
Reproduction" in DESIGN, which describes an Open vSwitch change in