linux 2.6.16.38 w/ vs2.0.3-rc1

[linux-2.6.git] / arch / arm / mach-s3c2410 / Kconfig

diff --git a/arch/arm/mach-s3c2410/Kconfig b/arch/arm/mach-s3c2410/Kconfig
index 534df0c..0b9d7ca 100644 (file)
--- a/arch/arm/mach-s3c2410/Kconfig
+++ b/arch/arm/mach-s3c2410/Kconfig
@@ -2,15 +2,31 @@ if ARCH_S3C2410
 
 menu "S3C24XX Implementations"
 
+config MACH_ANUBIS
+       bool "Simtec Electronics ANUBIS"
+       select CPU_S3C2440
+       help
+         Say Y gere if you are using the Simtec Electronics ANUBIS
+         development system
+
 config ARCH_BAST
        bool "Simtec Electronics BAST (EB2410ITX)"
        select CPU_S3C2410
+       select ISA
        help
          Say Y here if you are using the Simtec Electronics EB2410ITX
          development board (also known as BAST)
 
          Product page: <http://www.simtec.co.uk/products/EB2410ITX/>.
 
+config BAST_PC104_IRQ
+       bool "BAST PC104 IRQ support"
+       depends on ARCH_BAST
+       default y
+       help
+         Say Y here to enable the PC104 IRQ routing on the
+         Simtec BAST (EB2410ITX)
+
 config ARCH_H1940
        bool "IPAQ H1940"
        select CPU_S3C2410
@@ -105,6 +121,14 @@ config S3C2410_BOOT_WATCHDOG
          system resets depends on the value of PCLK. The timeout on an
          200MHz s3c2410 should be about 30 seconds.
 
+config S3C2410_BOOT_ERROR_RESET
+       bool "S3C2410 Reboot on decompression error"
+       depends on ARCH_S3C2410
+       help
+         Say y here to use the watchdog to reset the system if the
+         kernel decompressor detects an error during decompression.
+
+
 comment "S3C2410 Setup"
 
 config S3C2410_DMA
@@ -154,6 +178,11 @@ config S3C2410_PM_CHECK_CHUNKSIZE
          the CRC data block will take more memory, but wil identify any
          faults with better precision.
 
+config PM_SIMTEC
+       bool
+       depends on PM && (ARCH_BAST || MACH_VR1000)
+       default y
+
 config S3C2410_LOWLEVEL_UART_PORT
        int "S3C2410 UART to use for low-level messages"
        default 0