menu "S3C24XX Implementations"
+config MACH_ANUBIS
+ bool "Simtec Electronics ANUBIS"
+ select CPU_S3C2440
+ help
+ Say Y gere if you are using the Simtec Electronics ANUBIS
+ development system
+
+config MACH_OSIRIS
+ bool "Simtec IM2440D20 (OSIRIS) module"
+ select CPU_S3C2440
+ help
+ Say Y here if you are using the Simtec IM2440D20 module, also
+ known as the Osiris.
+
config ARCH_BAST
bool "Simtec Electronics BAST (EB2410ITX)"
select CPU_S3C2410
+ select ISA
help
Say Y here if you are using the Simtec Electronics EB2410ITX
development board (also known as BAST)
Product page: <http://www.simtec.co.uk/products/EB2410ITX/>.
+config BAST_PC104_IRQ
+ bool "BAST PC104 IRQ support"
+ depends on ARCH_BAST
+ default y
+ help
+ Say Y here to enable the PC104 IRQ routing on the
+ Simtec BAST (EB2410ITX)
+
config ARCH_H1940
bool "IPAQ H1940"
select CPU_S3C2410
<http://zoo.weinigel.se/n30>.
+config MACH_SMDK
+ bool
+ help
+ Common machine code for SMDK2410 and SMDK2440
+
config ARCH_SMDK2410
bool "SMDK2410/A9M2410"
select CPU_S3C2410
+ select MACH_SMDK
help
Say Y here if you are using the SMDK2410 or the derived module A9M2410
<http://www.fsforth.de>
config ARCH_S3C2440
bool "SMDK2440"
select CPU_S3C2440
+ select MACH_SMDK
help
Say Y here if you are using the SMDK2440.
system resets depends on the value of PCLK. The timeout on an
200MHz s3c2410 should be about 30 seconds.
+config S3C2410_BOOT_ERROR_RESET
+ bool "S3C2410 Reboot on decompression error"
+ depends on ARCH_S3C2410
+ help
+ Say y here to use the watchdog to reset the system if the
+ kernel decompressor detects an error during decompression.
+
+
comment "S3C2410 Setup"
config S3C2410_DMA
depends on ARCH_S3C2410 && PM
help
Say Y here if you want verbose debugging from the PM Suspend and
- Resume code. See `Documentation/arm/Samsing-S3C24XX/Suspend.txt`
+ Resume code. See <file:Documentation/arm/Samsung-S3C24XX/Suspend.txt>
for more information.
config S3C2410_PM_CHECK
the CRC data block will take more memory, but wil identify any
faults with better precision.
+config PM_SIMTEC
+ bool
+ depends on PM && (ARCH_BAST || MACH_VR1000)
+ default y
+
config S3C2410_LOWLEVEL_UART_PORT
int "S3C2410 UART to use for low-level messages"
default 0