* with this program; if not, write to the Free Software Foundation, Inc.,
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
-#include <linux/config.h>
#include <linux/init.h>
#include <linux/sched.h>
#include <linux/ioport.h>
#include <asm/mach-au1x00/au1000.h>
#include <asm/mach-db1x00/db1x00.h>
-/* not correct for db1550 */
-static BCSR * const bcsr = (BCSR *)0xAE000000;
+static BCSR * const bcsr = (BCSR *)BCSR_KSEG1_ADDR;
void board_reset (void)
{
/* Hit BCSR.SYSTEM_CONTROL[SW_RST] */
- au_writel(0x00000000, 0xAE00001C);
+ bcsr->swreset = 0x0000;
}
void __init board_setup(void)
pin_func = 0;
/* not valid for 1550 */
-#ifdef CONFIG_AU1X00_USB_DEVICE
- // 2nd USB port is USB device
- pin_func = au_readl(SYS_PINFUNC) & (u32)(~0x8000);
- au_writel(pin_func, SYS_PINFUNC);
-#endif
#if defined(CONFIG_IRDA) && (defined(CONFIG_SOC_AU1000) || defined(CONFIG_SOC_AU1100))
/* set IRFIRSEL instead of GPIO15 */
bcsr->resets |= BCSR_RESETS_IRDA_MODE_OFF;
au_sync();
#endif
- au_writel(0, 0xAE000010); /* turn off pcmcia power */
+ bcsr->pcmcia = 0x0000; /* turn off PCMCIA power */
#ifdef CONFIG_MIPS_MIRAGE
/* enable GPIO[31:0] inputs */