* with this program; if not, write to the Free Software Foundation, Inc.,
* 59 Temple Place - Suite 330, Boston MA 02111-1307, USA.
*/
-#include <linux/config.h>
#include <linux/init.h>
#include <linux/sched.h>
#include <linux/ioport.h>
+#include <linux/irq.h>
#include <linux/mm.h>
#include <linux/delay.h>
#include <linux/interrupt.h>
-#include <linux/serial_ip3106.h>
+#include <linux/serial_pnx8xxx.h>
#include <linux/pm.h>
#include <asm/cpu.h>
extern void pnx8550_machine_power_off(void);
extern struct resource ioport_resource;
extern struct resource iomem_resource;
-extern void (*board_time_init)(void);
extern void pnx8550_time_init(void);
-extern void (*board_timer_setup)(struct irqaction *irq);
-extern void pnx8550_timer_setup(struct irqaction *irq);
extern void rs_kgdb_hook(int tty_no);
extern void prom_printf(char *fmt, ...);
extern char *prom_getcmdline(void);
struct resource standard_io_resources[] = {
- {"dma1", 0x00, 0x1f, IORESOURCE_BUSY},
- {"timer", 0x40, 0x5f, IORESOURCE_BUSY},
- {"dma page reg", 0x80, 0x8f, IORESOURCE_BUSY},
- {"dma2", 0xc0, 0xdf, IORESOURCE_BUSY},
+ {
+ .start = 0x00,
+ .end = 0x1f,
+ .name = "dma1",
+ .flags = IORESOURCE_BUSY
+ }, {
+ .start = 0x40,
+ .end = 0x5f,
+ .name = "timer",
+ .flags = IORESOURCE_BUSY
+ }, {
+ .start = 0x80,
+ .end = 0x8f,
+ .name = "dma page reg",
+ .flags = IORESOURCE_BUSY
+ }, {
+ .start = 0xc0,
+ .end = 0xdf,
+ .name = "dma2",
+ .flags = IORESOURCE_BUSY
+ },
};
#define STANDARD_IO_RESOURCES (sizeof(standard_io_resources)/sizeof(struct resource))
int pnx8550_console_port = -1;
-void __init plat_setup(void)
+void __init plat_mem_setup(void)
{
int i;
char* argptr;
pm_power_off = pnx8550_machine_power_off;
board_time_init = pnx8550_time_init;
- board_timer_setup = pnx8550_timer_setup;
/* Clear the Global 2 Register, PCI Inta Output Enable Registers
Bit 1:Enable DAC Powerdown
/* We must initialize the UART (console) before prom_printf */
/* Set LCR to 8-bit and BAUD to 38400 (no 5) */
ip3106_lcr(UART_BASE, pnx8550_console_port) =
- IP3106_UART_LCR_8BIT;
+ PNX8XXX_UART_LCR_8BIT;
ip3106_baud(UART_BASE, pnx8550_console_port) = 5;
}