#include <linux/ide.h>
#include <linux/init.h>
-static struct pci_dev *triflex_dev;
-
-#ifdef CONFIG_PROC_FS
-static int triflex_get_info(char *buf, char **addr, off_t offset, int count)
-{
- char *p = buf;
- int len;
-
- struct pci_dev *dev = triflex_dev;
- unsigned long bibma = pci_resource_start(dev, 4);
- u8 c0 = 0, c1 = 0;
- u32 pri_timing, sec_timing;
-
- p += sprintf(p, "\n Compaq Triflex Chipset\n");
-
- pci_read_config_dword(dev, 0x70, &pri_timing);
- pci_read_config_dword(dev, 0x74, &sec_timing);
-
- /*
- * at that point bibma+0x2 et bibma+0xa are byte registers
- * to investigate:
- */
- c0 = inb((unsigned short)bibma + 0x02);
- c1 = inb((unsigned short)bibma + 0x0a);
-
- p += sprintf(p, "--------------- Primary Channel "
- "---------------- Secondary Channel "
- "-------------\n");
- p += sprintf(p, " %sabled "
- " %sabled\n",
- (c0&0x80) ? "dis" : " en",
- (c1&0x80) ? "dis" : " en");
- p += sprintf(p, "--------------- drive0 --------- drive1 "
- "-------- drive0 ---------- drive1 ------\n");
- p += sprintf(p, "DMA enabled: %s %s "
- " %s %s\n",
- (c0&0x20) ? "yes" : "no ",
- (c0&0x40) ? "yes" : "no ",
- (c1&0x20) ? "yes" : "no ",
- (c1&0x40) ? "yes" : "no " );
-
- p += sprintf(p, "DMA\n");
- p += sprintf(p, "PIO\n");
-
- len = (p - buf) - offset;
- *addr = buf + offset;
-
- return len > count ? count : len;
-}
-#endif
-
static int triflex_tune_chipset(ide_drive_t *drive, u8 xferspeed)
{
ide_hwif_t *hwif = HWIF(drive);
hwif->drives[1].autodma = hwif->autodma;
}
-static unsigned int __init init_chipset_triflex(struct pci_dev *dev,
- const char *name)
-{
-#ifdef CONFIG_PROC_FS
- ide_pci_create_host_proc("triflex", triflex_get_info);
-#endif
- return 0;
-}
-
static ide_pci_device_t triflex_device __devinitdata = {
.name = "TRIFLEX",
- .init_chipset = init_chipset_triflex,
.init_hwif = init_hwif_triflex,
.channels = 2,
.autodma = AUTODMA,
const struct pci_device_id *id)
{
ide_setup_pci_device(dev, &triflex_device);
- triflex_dev = dev;
return 0;
}
MODULE_DEVICE_TABLE(pci, triflex_pci_tbl);
static struct pci_driver driver = {
- .name = "TRIFLEX IDE",
+ .name = "TRIFLEX_IDE",
.id_table = triflex_pci_tbl,
.probe = triflex_init_one,
};