This commit was manufactured by cvs2svn to create tag

[linux-2.6.git] / drivers / mtd / maps / Kconfig

diff --git a/drivers/mtd/maps/Kconfig b/drivers/mtd/maps/Kconfig
index cdc5bbd..b1ad656 100644 (file)
--- a/drivers/mtd/maps/Kconfig
+++ b/drivers/mtd/maps/Kconfig
@@ -1,5 +1,5 @@
 # drivers/mtd/maps/Kconfig
-# $Id: Kconfig,v 1.30 2004/07/21 00:16:14 jwboyer Exp $
+# $Id: Kconfig,v 1.29 2004/07/15 15:29:17 dwmw2 Exp $
 
 menu "Mapping drivers for chip access"
        depends on MTD!=n
@@ -19,8 +19,7 @@ config MTD_PHYSMAP
          command set driver code to communicate with flash chips which
          are mapped physically into the CPU's memory. You will need to
          configure the physical address and size of the flash chips on
-         your particular board as well as the bus width, either statically
-         with config options or at run-time.
+         your particular board as well as the bus width.
 
 config MTD_PHYSMAP_START
        hex "Physical start address of flash mapping"
@@ -31,8 +30,6 @@ config MTD_PHYSMAP_START
          are mapped on your particular target board. Refer to the
          memory map which should hopefully be in the documentation for
          your board.
-         Ignore this option if you use run-time physmap configuration
-         (i.e., run-time calling physmap_configure()).
 
 config MTD_PHYSMAP_LEN
        hex "Physical length of flash mapping"
@@ -45,11 +42,9 @@ config MTD_PHYSMAP_LEN
          than the total amount of flash present. Refer to the memory
          map which should hopefully be in the documentation for your
          board.
-         Ignore this option if you use run-time physmap configuration
-         (i.e., run-time calling physmap_configure()).
 
-config MTD_PHYSMAP_BANKWIDTH
-       int "Bank width in octets"
+config MTD_PHYSMAP_BUSWIDTH
+       int "Bus width in octets"
        depends on MTD_PHYSMAP
        default "2"
        help
@@ -57,8 +52,6 @@ config MTD_PHYSMAP_BANKWIDTH
          in octets. For example, if you have a data bus width of 32
          bits, you would set the bus width octect value to 4. This is
          used internally by the CFI drivers.
-         Ignore this option if you use run-time physmap configuration
-         (i.e., run-time calling physmap_configure()).
 
 config MTD_SUN_UFLASH
        tristate "Sun Microsystems userflash support"