dbg_hcs_params(ehci, "reset");
dbg_hcc_params(ehci, "reset");
+ /* ehci_init() causes memory for DMA transfers to be
+ * allocated. Thus, any vendor-specific workarounds based on
+ * limiting the type of memory used for DMA transfers must
+ * happen before ehci_init() is called. */
+ switch (pdev->vendor) {
+ case PCI_VENDOR_ID_NVIDIA:
+ /* NVidia reports that certain chips don't handle
+ * QH, ITD, or SITD addresses above 2GB. (But TD,
+ * data buffer, and periodic schedule are normal.)
+ */
+ switch (pdev->device) {
+ case 0x003c: /* MCP04 */
+ case 0x005b: /* CK804 */
+ case 0x00d8: /* CK8 */
+ case 0x00e8: /* CK8S */
+ if (pci_set_consistent_dma_mask(pdev,
+ DMA_31BIT_MASK) < 0)
+ ehci_warn(ehci, "can't enable NVidia "
+ "workaround for >2GB RAM\n");
+ break;
+ }
+ break;
+ }
+
/* cache this readonly data; minimize chip reads */
ehci->hcs_params = readl(&ehci->caps->hcs_params);
if (retval)
return retval;
- /* NOTE: only the parts below this line are PCI-specific */
-
switch (pdev->vendor) {
case PCI_VENDOR_ID_TDI:
if (pdev->device == PCI_DEVICE_ID_TDI_EHCI) {
break;
case PCI_VENDOR_ID_NVIDIA:
switch (pdev->device) {
- /* NVidia reports that certain chips don't handle
- * QH, ITD, or SITD addresses above 2GB. (But TD,
- * data buffer, and periodic schedule are normal.)
- */
- case 0x003c: /* MCP04 */
- case 0x005b: /* CK804 */
- case 0x00d8: /* CK8 */
- case 0x00e8: /* CK8S */
- if (pci_set_consistent_dma_mask(pdev,
- DMA_31BIT_MASK) < 0)
- ehci_warn(ehci, "can't enable NVidia "
- "workaround for >2GB RAM\n");
- break;
/* Some NForce2 chips have problems with selective suspend;
* fixed in newer silicon.
*/
writel (0, &ehci->regs->intr_enable);
(void)readl(&ehci->regs->intr_enable);
+ /* make sure snapshot being resumed re-enumerates everything */
+ if (message.event == PM_EVENT_PRETHAW) {
+ ehci_halt(ehci);
+ ehci_reset(ehci);
+ }
+
clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
bail:
spin_unlock_irqrestore (&ehci->lock, flags);
static int ehci_pci_resume(struct usb_hcd *hcd)
{
struct ehci_hcd *ehci = hcd_to_ehci(hcd);
- unsigned port;
struct pci_dev *pdev = to_pci_dev(hcd->self.controller);
- int retval = -EINVAL;
// maybe restore FLADJ
/* Mark hardware accessible again as we are out of D3 state by now */
set_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
- /* If CF is clear, we lost PCI Vaux power and need to restart. */
- if (readl(&ehci->regs->configured_flag) != FLAG_CF)
- goto restart;
-
- /* If any port is suspended (or owned by the companion),
- * we know we can/must resume the HC (and mustn't reset it).
- * We just defer that to the root hub code.
+ /* If CF is still set, we maintained PCI Vaux power.
+ * Just undo the effect of ehci_pci_suspend().
*/
- for (port = HCS_N_PORTS(ehci->hcs_params); port > 0; ) {
- u32 status;
- port--;
- status = readl(&ehci->regs->port_status [port]);
- if (!(status & PORT_POWER))
- continue;
- if (status & (PORT_SUSPEND | PORT_RESUME | PORT_OWNER)) {
- usb_hcd_resume_root_hub(hcd);
- return 0;
- }
+ if (readl(&ehci->regs->configured_flag) == FLAG_CF) {
+ int mask = INTR_MASK;
+
+ if (!device_may_wakeup(&hcd->self.root_hub->dev))
+ mask &= ~STS_PCD;
+ writel(mask, &ehci->regs->intr_enable);
+ readl(&ehci->regs->intr_enable);
+ return 0;
}
-restart:
ehci_dbg(ehci, "lost power, restarting\n");
usb_root_hub_lost_power(hcd->self.root_hub);
spin_lock_irq(&ehci->lock);
if (ehci->reclaim)
ehci->reclaim_ready = 1;
- ehci_work(ehci, NULL);
+ ehci_work(ehci);
spin_unlock_irq(&ehci->lock);
- /* restart; khubd will disconnect devices */
- retval = ehci_run(hcd);
-
/* here we "know" root ports should always stay powered */
ehci_port_power(ehci, 1);
- return retval;
+ writel(ehci->command, &ehci->regs->command);
+ writel(FLAG_CF, &ehci->regs->configured_flag);
+ readl(&ehci->regs->command); /* unblock posted writes */
+
+ hcd->state = HC_STATE_SUSPENDED;
+ return 0;
}
#endif
.resume = ehci_pci_resume,
#endif
.stop = ehci_stop,
+ .shutdown = ehci_shutdown,
/*
* managing i/o requests and associated device resources
.suspend = usb_hcd_pci_suspend,
.resume = usb_hcd_pci_resume,
#endif
+ .shutdown = usb_hcd_pci_shutdown,
};
-
-static int __init ehci_hcd_pci_init(void)
-{
- if (usb_disabled())
- return -ENODEV;
-
- pr_debug("%s: block sizes: qh %Zd qtd %Zd itd %Zd sitd %Zd\n",
- hcd_name,
- sizeof(struct ehci_qh), sizeof(struct ehci_qtd),
- sizeof(struct ehci_itd), sizeof(struct ehci_sitd));
-
- return pci_register_driver(&ehci_pci_driver);
-}
-module_init(ehci_hcd_pci_init);
-
-static void __exit ehci_hcd_pci_cleanup(void)
-{
- pci_unregister_driver(&ehci_pci_driver);
-}
-module_exit(ehci_hcd_pci_cleanup);
git://git.onelab.eu / linux-2.6.git / blobdiff