# USB Storage driver configuration
#
-comment "NOTE: USB_STORAGE enables SCSI, and 'SCSI disk support' may also be needed; see USB_STORAGE Help for more information"
+comment "NOTE: USB_STORAGE enables SCSI, and 'SCSI disk support'"
+comment "may also be needed; see USB_STORAGE Help for more information"
depends on USB
config USB_STORAGE
tristate "USB Mass Storage support"
- depends on USB
- select SCSI
+ depends on USB && SCSI
---help---
Say Y here if you want to connect USB mass storage devices to your
computer's USB port. This is the driver you need for USB
similar devices. This driver may also be used for some cameras
and card readers.
- This option 'selects' (turns on, enables) 'SCSI', but you
+ This option depends on 'SCSI' support being enabled, but you
probably also need 'SCSI device support: SCSI disk support'
(BLK_DEV_SD) for most USB storage devices.
config USB_STORAGE_ISD200
bool "ISD-200 USB/ATA Bridge support"
- depends on USB_STORAGE && BLK_DEV_IDE
+ depends on USB_STORAGE
+ depends on BLK_DEV_IDE=y || BLK_DEV_IDE=USB_STORAGE
---help---
Say Y here if you want to use USB Mass Store devices based
on the In-Systems Design ISD-200 USB/ATA bridge.
Say Y here to include additional code to support the Lexar Jumpshot
USB CompactFlash reader.
+config USB_STORAGE_ALAUDA
+ bool "Olympus MAUSB-10/Fuji DPC-R1 support (EXPERIMENTAL)"
+ depends on USB_STORAGE && EXPERIMENTAL
+ help
+ Say Y here to include additional code to support the Olympus MAUSB-10
+ and Fujifilm DPC-R1 USB Card reader/writer devices.
+
+ These devices are based on the Alauda chip and support both
+ XD and SmartMedia cards.
+
+config USB_STORAGE_ONETOUCH
+ bool "Support OneTouch Button on Maxtor Hard Drives (EXPERIMENTAL)"
+ depends on USB_STORAGE && INPUT_EVDEV && EXPERIMENTAL && !PM
+ help
+ Say Y here to include additional code to support the Maxtor OneTouch
+ USB hard drive's onetouch button.
+
+ This code registers the button on the front of Maxtor OneTouch USB
+ hard drive's as an input device. An action can be associated with
+ this input in any keybinding software. (e.g. gnome's keyboard short-
+ cuts)
+
+config USB_STORAGE_KARMA
+ bool "Support for Rio Karma music player"
+ depends on USB_STORAGE
+ help
+ Say Y here to include additional code to support the Rio Karma
+ USB interface.
+
+ This code places the Rio Karma into mass storage mode, enabling
+ it to be mounted as an ordinary filesystem. Performing an eject
+ on the resulting scsi device node returns the Karma to normal
+ operation.
+
+config USB_LIBUSUAL
+ bool "The shared table of common (or usual) storage devices"
+ depends on USB
+ help
+ This module contains a table of common (or usual) devices
+ for usb-storage and ub drivers, and allows to switch binding
+ of these devices without rebuilding modules.
+
+ Typical syntax of /etc/modprobe.conf is:
+
+ options libusual bias="ub"
+
+ If unsure, say N.