config W1
tristate "Dallas's 1-wire support"
---help---
- Dallas's 1-wire bus is usefull to connect slow 1-pin devices
+ Dallas' 1-wire bus is useful to connect slow 1-pin devices
such as iButtons and thermal sensors.
-
+
If you want W1 support, you should say Y here.
This W1 support can also be built as a module. If so, the module
will be called wire.ko.
-config W1_MATROX
- tristate "Matrox G400 transport layer for 1-wire"
- depends on W1 && PCI
- help
- Say Y here if you want to communicate with your 1-wire devices
- using Matrox's G400 GPIO pins.
-
- This support is also available as a module. If so, the module
- will be called matrox_w1.ko.
+config W1_CON
+ depends on CONNECTOR && W1
+ bool "Userspace communication over connector"
+ default y
+ --- help ---
+ This allows to communicate with userspace using connector [Documentation/connector].
+ There are three types of messages between w1 core and userspace:
+ 1. Events. They are generated each time new master or slave device found
+ either due to automatic or requested search.
+ 2. Userspace commands. Includes read/write and search/alarm search commands.
+ 3. Replies to userspace commands.
-config W1_THERM
- tristate "Thermal family implementation"
- depends on W1
- help
- Say Y here if you want to connect 1-wire thermal sensors to you
- wire.
+source drivers/w1/masters/Kconfig
+source drivers/w1/slaves/Kconfig
endmenu