#define OMAP_TAG_CLOCK 0x4f01
#define OMAP_TAG_MMC 0x4f02
#define OMAP_TAG_UART 0x4f03
+#define OMAP_TAG_USB 0x4f04
-struct omap_clock_info {
+struct omap_clock_config {
/* 0 for 12 MHz, 1 for 13 MHz and 2 for 19.2 MHz */
u8 system_clock_type;
};
-struct omap_mmc_info {
+struct omap_mmc_config {
u8 mmc_blocks;
s8 mmc1_power_pin, mmc2_power_pin;
s8 mmc1_switch_pin, mmc2_switch_pin;
};
-struct omap_uart_info {
+struct omap_uart_config {
u8 console_uart;
u32 console_speed;
};
-struct omap_board_info_entry {
+struct omap_usb_config {
+ /* Configure drivers according to the connectors on your board:
+ * - "A" connector (rectagular)
+ * ... for host/OHCI use, set "register_host".
+ * - "B" connector (squarish) or "Mini-B"
+ * ... for device/gadget use, set "register_dev".
+ * - "Mini-AB" connector (very similar to Mini-B)
+ * ... for OTG use as device OR host, initialize "otg"
+ */
+ unsigned register_host:1;
+ unsigned register_dev:1;
+ u8 otg; /* port number, 1-based: usb1 == 2 */
+
+ u8 hmc_mode;
+
+ /* implicitly true if otg: host supports remote wakeup? */
+ u8 rwc;
+
+ /* signaling pins used to talk to transceiver on usbN:
+ * 0 == usbN unused
+ * 2 == usb0-only, using internal transceiver
+ * 3 == 3 wire bidirectional
+ * 4 == 4 wire bidirectional
+ * 6 == 6 wire unidirectional (or TLL)
+ */
+ u8 pins[3];
+};
+
+struct omap_board_config_entry {
u16 tag;
u16 len;
u8 data[0];
};
-extern const void *__omap_get_per_info(u16 tag, size_t len);
+struct omap_board_config_kernel {
+ u16 tag;
+ const void *data;
+};
+
+extern const void *__omap_get_config(u16 tag, size_t len);
+
+#define omap_get_config(tag, type) \
+ ((const type *) __omap_get_config((tag), sizeof(type)))
-#define omap_get_per_info(tag, type) \
- ((const type *) __omap_get_per_info((tag), sizeof(type)))
+extern struct omap_board_config_kernel *omap_board_config;
+extern int omap_board_config_size;
#endif