* PCI Local Bus Specification
* PCI to PCI Bridge Specification
* PCI System Design Guide
+ *
+ * For hypertransport information, please consult the following manuals
+ * from http://www.hypertransport.org
+ *
+ * The Hypertransport I/O Link Specification
*/
#ifndef LINUX_PCI_REGS_H
#define PCI_CAP_ID_MSI 0x05 /* Message Signalled Interrupts */
#define PCI_CAP_ID_CHSWP 0x06 /* CompactPCI HotSwap */
#define PCI_CAP_ID_PCIX 0x07 /* PCI-X */
-#define PCI_CAP_ID_HT_IRQCONF 0x08 /* HyperTransport IRQ Configuration */
+#define PCI_CAP_ID_HT 0x08 /* HyperTransport */
#define PCI_CAP_ID_VNDR 0x09 /* Vendor specific capability */
#define PCI_CAP_ID_SHPC 0x0C /* PCI Standard Hot-Plug Controller */
#define PCI_CAP_ID_EXP 0x10 /* PCI Express */
#define PCI_MSI_DATA_64 12 /* 16 bits of data for 64-bit devices */
#define PCI_MSI_MASK_BIT 16 /* Mask bits register */
+/* MSI-X registers (these are at offset PCI_MSI_FLAGS) */
+#define PCI_MSIX_FLAGS_QSIZE 0x7FF
+#define PCI_MSIX_FLAGS_ENABLE (1 << 15)
+#define PCI_MSIX_FLAGS_BIRMASK (7 << 0)
+#define PCI_MSIX_FLAGS_BITMASK (1 << 0)
+
/* CompactPCI Hotswap Register */
#define PCI_CHSWP_CSR 2 /* Control and Status Register */
#define PCI_EXP_DEVSTA_TRPND 0x20 /* Transactions Pending */
#define PCI_EXP_LNKCAP 12 /* Link Capabilities */
#define PCI_EXP_LNKCTL 16 /* Link Control */
+#define PCI_EXP_LNKCTL_CLKREQ_EN 0x100 /* Enable clkreq */
#define PCI_EXP_LNKSTA 18 /* Link Status */
#define PCI_EXP_SLTCAP 20 /* Slot Capabilities */
#define PCI_EXP_SLTCTL 24 /* Slot Control */
#define PCI_PWR_CAP 12 /* Capability */
#define PCI_PWR_CAP_BUDGET(x) ((x) & 1) /* Included in system budget */
+/*
+ * Hypertransport sub capability types
+ *
+ * Unfortunately there are both 3 bit and 5 bit capability types defined
+ * in the HT spec, catering for that is a little messy. You probably don't
+ * want to use these directly, just use pci_find_ht_capability() and it
+ * will do the right thing for you.
+ */
+#define HT_3BIT_CAP_MASK 0xE0
+#define HT_CAPTYPE_SLAVE 0x00 /* Slave/Primary link configuration */
+#define HT_CAPTYPE_HOST 0x20 /* Host/Secondary link configuration */
+
+#define HT_5BIT_CAP_MASK 0xF8
+#define HT_CAPTYPE_IRQ 0x80 /* IRQ Configuration */
+#define HT_CAPTYPE_REMAPPING_40 0xA0 /* 40 bit address remapping */
+#define HT_CAPTYPE_REMAPPING_64 0xA2 /* 64 bit address remapping */
+#define HT_CAPTYPE_UNITID_CLUMP 0x90 /* Unit ID clumping */
+#define HT_CAPTYPE_EXTCONF 0x98 /* Extended Configuration Space Access */
+#define HT_CAPTYPE_MSI_MAPPING 0xA8 /* MSI Mapping Capability */
+#define HT_MSI_FLAGS 0x02 /* Offset to flags */
+#define HT_MSI_FLAGS_ENABLE 0x1 /* Mapping enable */
+#define HT_MSI_FLAGS_FIXED 0x2 /* Fixed mapping only */
+#define HT_MSI_FIXED_ADDR 0x00000000FEE00000ULL /* Fixed addr */
+#define HT_MSI_ADDR_LO 0x04 /* Offset to low addr bits */
+#define HT_MSI_ADDR_LO_MASK 0xFFF00000 /* Low address bit mask */
+#define HT_MSI_ADDR_HI 0x08 /* Offset to high addr bits */
+#define HT_CAPTYPE_DIRECT_ROUTE 0xB0 /* Direct routing configuration */
+#define HT_CAPTYPE_VCSET 0xB8 /* Virtual Channel configuration */
+#define HT_CAPTYPE_ERROR_RETRY 0xC0 /* Retry on error configuration */
+#define HT_CAPTYPE_GEN3 0xD0 /* Generation 3 hypertransport configuration */
+#define HT_CAPTYPE_PM 0xE0 /* Hypertransport powermanagement configuration */
+
+
#endif /* LINUX_PCI_REGS_H */