maximum bandwidth to \fItarget\fR for round-trips of \fIn\fR-byte
messages.
.
+.SS "Other Commands"
+.
+.IP "\fBofp\-parse\fR \fIfile\fR"
+Reads \fIfile\fR (or \fBstdin\fR if \fIfile\fR is \fB\-\fR) as a
+series of OpenFlow messages in the binary format used on an OpenFlow
+connection, and prints them to the console. This can be useful for
+printing OpenFlow messages captured from a TCP stream.
+.
.SS "Flow Syntax"
.PP
Some \fBovs\-ofctl\fR commands accept an argument that describes a flow or
corresponding bit in \fItunnel-id\fR must match exactly, and a 0-bit
wildcards that bit.
.
+.IP \fBtun_src=\fIip\fR[\fB/\fInetmask\fR]
+.IQ \fBtun_dst=\fIip\fR[\fB/\fInetmask\fR]
+Matches tunnel IPv4 source (or destination) address \fIip\fR. Only packets
+that arrive over a tunnel will have nonzero tunnel addresses.
+The address may be specified as an IP address or host name
+(e.g. \fB192.168.1.1\fR or \fBwww.example.com\fR). The optional
+\fInetmask\fR allows restricting a match to a masked IPv4 address.
+The netmask may be specified as a dotted quad
+(e.g. \fB192.168.1.0/255.255.255.0\fR) or as a CIDR block
+(e.g. \fB192.168.1.0/24\fR).
+.
.IP "\fBreg\fIidx\fB=\fIvalue\fR[\fB/\fImask\fR]"
Matches \fIvalue\fR either exactly or with optional \fImask\fR in
register number \fIidx\fR. The valid range of \fIidx\fR depends on
When a packet enters an OpenFlow switch, all of the registers are set
to 0. Only explicit Nicira extension actions change register values.
.
+.IP \fBpkt_mark=\fIvalue\fR[\fB/\fImask\fR]
+Matches packet metadata mark \fIvalue\fR either exactly or with optional
+\fImask\fR. The mark is associated data that may be passed into other
+system components in order to facilitate interaction between subsystems.
+On Linux this corresponds to the skb mark but the exact implementation is
+platform-dependent.
+.
.PP
Defining IPv6 flows (those with \fBdl_type\fR equal to 0x86dd) requires
support for NXM. The following shorthand notations are available for
\fBpush_mpls\fR being discarded.
.
.IP \fBpop_mpls\fR:\fIethertype\fR
-Strips the outermost MPLS label stack entry. If the MPLS label
-stripped was the only one, changes the ethertype of a packet to
-\fIethertype\fR, which should not ordinarily be an MPLS Ethertype.
+Strips the outermost MPLS label stack entry.
+Currently the implementation restricts \fIethertype\fR to a non-MPLS Ethertype
+and thus \fBpop_mpls\fR should only be applied to packets with
+an MPLS label stack depth of one.
.
.IP
There are some limitations in the implementation. \fBpop_mpls\fR
Open Flow 1.2 and above.)
.
.IP
-Example: \fBset_field:fe80:0123:4567:890a:a6ba:dbff:fefe:59fa\->ipv6_src\fR
+Example: \fBset_field:00:11:22:33:44:55->eth_src\fR.
.
.IP "\fBmultipath(\fIfields\fB, \fIbasis\fB, \fIalgorithm\fB, \fIn_links\fB, \fIarg\fB, \fIdst\fB[\fIstart\fB..\fIend\fB])\fR"
Hashes \fIfields\fR using \fIbasis\fR as a universal hash parameter,
.RE
.IP
This action was added in Open vSwitch 1.5.90.
+.
+.IP "\fBsample(\fIargument\fR[\fB,\fIargument\fR]...\fB)\fR"
+Samples packets and sends one sample for every sampled packet.
+.IP
+\fIargument\fR takes the following forms:
+.RS
+.IP "\fBprobability=\fIpackets\fR"
+The number of sampled packets out of 65535. Must be greater or equal to 1.
+.IP "\fBcollector_set_id=\fIid\fR"
+The unsigned 32-bit integer identifier of the set of sample collectors
+to send sampled packets to. Defaults to 0.
+.IP "\fBobs_domain_id=\fIid\fR"
+When sending samples to IPFIX collectors, the unsigned 32-bit integer
+Observation Domain ID sent in every IPFIX flow record. Defaults to 0.
+.IP "\fBobs_point_id=\fIid\fR"
+When sending samples to IPFIX collectors, the unsigned 32-bit integer
+Observation Point ID sent in every IPFIX flow record. Defaults to 0.
+.RE
+.IP
+Refer to \fBovs\-vswitchd.conf.db\fR(8) for more details on
+configuring sample collector sets.
+.IP
+This action was added in Open vSwitch 1.10.90.
+.
.IP "\fBexit\fR"
This action causes Open vSwitch to immediately halt execution of further
actions. Those actions which have already been executed are unaffected. Any
.BR ovs\-appctl (8),
.BR ovs\-controller (8),
.BR ovs\-vswitchd (8)
+.BR ovs\-vswitchd.conf.db (8)