.IP
When \fBdl_type\fR and \fBnw_proto\fR take other values, the values of
these settings are ignored (see \fBFlow Syntax\fR above).
+.IP \fBtun_id=\fItunnel-id\fR[\fB/\fImask\fR]
+Matches tunnel identifier \fItunnel-id\fR. Only packets that arrive
+over a tunnel that carries a key (e.g. GRE with the RFC 2890 key
+extension) will have a nonzero tunnel ID. If \fImask\fR is omitted,
+\fItunnel-id\fR is the exact tunnel ID to match; \fImask\fR is
+specified, then a 1-bit in \fImask\fR indicates that the corresponding
+bit in \fItunnel-id\fR must match exactly, and a 0-bit wildcards that
+bit.
+.IP
+\fBtun_id\fR requires use of one of two Nicira extensions to OpenFlow:
+.RS
+.IP "NXM (Nicira Extended Match)"
+This extension fully supports \fBtun_id\fR.
+.IP "Tunnel ID from Cookie"
+This extension supports \fBtun_id\fR with three caveats: the top 32 bits
+of the \fBcookie\fR (see below) are used for \fItunnel-id\fR and thus
+unavailable for other use, specifying \fBtun_id\fR on
+\fBdump\-flows\fR or \fBdump\-aggregate\fR has no effect, and
+\fImask\fR is not supported.
+.RE
+.IP
+When \fBtun_id\fR is specified, \fBovs\-ofctl\fR will automatically
+attempt to negotiate use of one of these extensions. It will use the
+``tunnel ID from cookie'' extension if neither caveat applies and NXM
+otherwise. If the switch does not support the needed extension, then
+\fBovs\-ofctl\fR will report a fatal error.
+.IP "\fBreg\fIidx\fB=\fIvalue\fR[\fB/\fImask\fR]"
+Matches \fIvalue\fR either exactly or with optional \fImask\fR in
+register number \fIidx\fR. The valid range of \fIidx\fR depends on
+the switch. \fIvalue\fR and \fImask\fR are 32-bit integers, by
+default in decimal (use a \fB0x\fR prefix to specify hexadecimal).
+Arbitrary \fImask\fR values are allowed: a 1-bit in \fImask\fR
+indicates that the corresponding bit in \fIvalue\fR must match
+exactly, and a 0-bit wildcards that bit.
+.IP
+When a packet enters an OpenFlow switch, all of the registers are set
+to 0. Only explicit Nicira extension actions change register values.
+.IP
+Register matches require support for the NXM (Nicira Extended Match)
+extension to OpenFlow. When a register match is specified,
+\fBovs\-ofctl\fR will automatically attempt to negotiate use of this
+extension. If the switch does not support NXM, then \fBovs\-ofctl\fR
+will report a fatal error.
.
.PP
The following shorthand notations are also available:
\fBresubmit\fR actions are ignored.
.
.IP \fBset_tunnel\fB:\fIid\fR
-If outputting to a port that encapsulates the packet in a tunnel and supports
-an identifier (such as GRE), sets the identifier to \fBid\fR.
+.IQ \fBset_tunnel64\fB:\fIid\fR
+If outputting to a port that encapsulates the packet in a tunnel and
+supports an identifier (such as GRE), sets the identifier to \fBid\fR.
+If the \fBset_tunnel\fR form is used and \fIid\fR fits in 32 bits,
+then this uses an action extension that is supported by Open vSwitch
+1.0 and later. Otherwise, if \fIid\fR is a 64-bit value, it requires
+Open vSwitch 1.1 or later.
.
.IP \fBdrop_spoofed_arp\fR
Stops processing further actions, if the packet being processed is an
Restores the queue to the value it was before any \fBset_queue\fR
actions were applied.
.
+.IP \fBnote:\fR[\fIhh\fR]...
+Does nothing at all. Any number of bytes represented as hex digits
+\fIhh\fR may be included. Pairs of hex digits may be separated by
+periods for readability.
+.
+.IP "\fBmove:\fIsrc\fB[\fIstart\fB..\fIend\fB]->\fIdst\fB[\fIstart\fB..\fIend\fB]\fR"
+Copies the named bits from field \fIsrc\fR to field \fIdst\fR.
+\fIsrc\fR and \fIdst\fR must be NXM field names as defined in
+\fBnicira\-ext.h\fR, e.g. \fBNXM_OF_UDP_SRC\fR or \fBNXM_NX_REG0\fR.
+Each \fIstart\fR and \fIend\fR pair, which are inclusive, must specify
+the same number of bits and must fit within its respective field.
+Shorthands for \fB[\fIstart\fB..\fIend\fB]\fR exist: use
+\fB[\fIbit\fB]\fR to specify a single bit or \fB[]\fR to specify an
+entire field.
+.IP
+Examples: \fBmove:NXM_NX_REG0[0..5]\->NXM_NX_REG1[26..31]\fR copies the
+six bits numbered 0 through 5, inclusive, in register 0 into bits 26
+through 31, inclusive;
+\fBmove:NXM_NX_REG0[0..15]->NXM_OF_VLAN_TCI[]\fR copies the least
+significant 16 bits of register 0 into the VLAN TCI field.
+.
+.IP "\fBload:\fIvalue\fB\->\fIdst\fB[\fIstart\fB..\fIend\fB]"
+Writes \fIvalue\fR to bits \fIstart\fR through \fIend\fR, inclusive,
+in field \fBdst\fR.
+.IP
+Example: \fBload:55\->NXM_NX_REG2[0..5]\fR loads value 55 (bit pattern
+\fB110111\fR) into bits 0 through 5, inclusive, in register 2.
+.
+.IP "\fBmultipath(\fIfields\fB, \fIbasis\fB, \fIalgorithm\fB, \fIn_links\fB, \fIarg\fB, \fIdst\fB[\fIstart\fB..\fIend\fB])\fR"
+Hashes \fIfields\fR using \fIbasis\fR as a universal hash parameter,
+then the applies multipath link selection \fIalgorithm\fR (with
+parameter \fIarg\fR) to choose one of \fIn_links\fR output links
+numbered 0 through \fIn_links\fR minus 1, and stores the link into
+\fIdst\fB[\fIstart\fB..\fIend\fB]\fR, which must be an NXM register as
+described above.
+.IP
+Currently, \fIfields\fR must be either \fBeth_src\fR or
+\fBsymmetric_l4\fR and \fIalgorithm\fR must be one of \fBmodulo_n\fR,
+\fBhash_threshold\fR, \fBhrw\fR, and \fBiter_hash\fR. Only
+the \fBiter_hash\fR algorithm uses \fIarg\fR.
+.IP
+Refer to \fBnicira\-ext.h\fR for more details.
.RE
.
.IP
\fB\-\-strict\fR
Uses strict matching when running flow modification commands.
.
+.IP "\fB\-F \fIformat\fR"
+.IQ "\fB\-\-flow\-format=\fIformat\fR"
+\fBovs\-ofctl\fR supports the following flow formats, in order of
+increasing capability:
+.RS
+.IP "\fBopenflow10\fR"
+This is the standard OpenFlow 1.0 flow format. It should be supported
+by all OpenFlow switches.
+.
+.IP "\fBtun_id_from_cookie\fR"
+This Nicira extension to OpenFlow adds minimal and limited support for
+\fBtun_id\fR, but it does not support any other Nicira flow
+extensions. (This flow format is deprecated.)
+.
+.IP "\fBnxm\fR (Nicira Extended Match)"
+This Nicira extension to OpenFlow is flexible and extensible. It
+supports all of the Nicira flow extensions, such as \fBtun_id\fR and
+registers.
+.RE
+.IP
+Usually, \fBovs\-ofctl\fR picks the correct format automatically. For
+commands that modify the flow table, \fBovs\-ofctl\fR by default uses
+the most widely supported flow format that supports the flows being
+added. For commands that query the flow table, \fBovs\-ofctl\fR by
+default queries and uses the most advanced format supported by the
+switch.
+.IP
+This option, where \fIformat\fR is one of the formats listed in the
+above table, overrides \fBovs\-ofctl\fR's default choice of flow
+format. If a command cannot work as requested using the requested
+flow format, \fBovs\-ofctl\fR will report a fatal error.
+.
+.IP "\fB\-m\fR"
+.IQ "\fB\-\-more\fR"
+Increases the verbosity of OpenFlow messages printed and logged by
+\fBovs\-ofctl\fR commands. Specify this option more than once to
+increase verbosity further.
.SS "Public Key Infrastructure Options"
.so lib/ssl.man
.so lib/vlog.man
git://git.onelab.eu / sliver-openvswitch.git / blobdiff