Sets the TCP or UDP destination port to \fIport\fR.
.
.IP \fBmod_nw_tos\fB:\fItos\fR
-Sets the IPv4 ToS/DSCP field to \fItos\fR. Valid values are between 0 and
-255, inclusive. Note that the two lower reserved bits are never
-modified.
+Sets the IPv4 ToS/DSCP field to \fItos\fR, which must be a multiple of
+4 between 0 and 255. This action does not modify the two least
+significant bits of the ToS field (the ECN bits).
.RE
.IP
The following actions are Nicira vendor extensions that, as of this writing, are
``packet_in'' message will be sent only to the controllers having
controller id zero which have registered for the invalid ttl packets.
.
+.IP \fBset_mpls_ttl\fR:\fIttl\fR
+Set the TTL of the outer MPLS label stack entry of a packet.
+\fIttl\fR should be in the range 0 to 255 inclusive.
+.
+.IP \fBdec_mpls_ttl\fR
+Decrement TTL of the outer MPLS label stack entry of a packet. If the TTL
+is initially zero, no decrement occurs. Instead, a ``packet-in'' message
+with reason code \fBOFPR_INVALID_TTL\fR is sent to each connected
+controller with controller id zer that has enabled receiving them.
+Processing the current set of actions then stops. However, if the current
+set of actions was reached through ``resubmit'' then remaining actions in
+outer levels resume processing.
+.
.IP \fBnote:\fR[\fIhh\fR]...
Does nothing at all. Any number of bytes represented as hex digits
\fIhh\fR may be included. Pairs of hex digits may be separated by
Example: \fBload:55\->NXM_NX_REG2[0..5]\fR loads value 55 (bit pattern
\fB110111\fR) into bits 0 through 5, inclusive, in register 2.
.
+.IP "\fBpush:\fIsrc\fB[\fIstart\fB..\fIend\fB]"
+Pushes \fIstart\fR to \fIend\fR bits inclusive, in fields
+on top of the stack.
+.IP
+Example: \fBpush:NXM_NX_REG2[0..5]\fR push the value stored in register
+2 bits 0 through 5, inclusive, on to the internal stack.
+.
+.IP "\fBpop:\fIdst\fB[\fIstart\fB..\fIend\fB]"
+Pops from the top of the stack, retrieves the \fIstart\fR to \fIend\fR bits
+inclusive, from the value popped and store them into the corresponding
+bits in \fIdst\fR.
+.
+.IP
+Example: \fBpop:NXM_NX_REG2[0..5]\fR pops the value from top of the stack.
+Set register 2 bits 0 through 5, inclusive, based on bits 0 through 5 from the
+value just popped.
+.
.IP "\fBset_field:\fIvalue\fB\->\fIdst"
Writes the literal \fIvalue\fR into the field \fIdst\fR, which should
be specified as a name used for matching. (This is similar to
.IP
Refer to \fBnicira\-ext.h\fR for more details.
.
-.IP "\fBautopath(\fIid\fB, \fIdst\fB[\fIstart\fB..\fIend\fB])\fR"
-Deprecated and slated for removal in Feburary 2013.
-.IP
-Given \fIid\fR, chooses an OpenFlow port and populates it in
-\fIdst\fB[\fIstart\fB..\fIend\fB]\fR, which must be an NXM field as
-described above.
-.IP
-Currently, \fIid\fR should be the OpenFlow port number of an interface on the
-bridge. If it isn't then \fIdst\fB[\fIstart\fB..\fIend\fB]\fR will be
-populated with the OpenFlow port "none". If \fIid\fR is a member of a bond,
-the normal bond selection logic will be used to choose the destination port.
-Otherwise, the register will be populated with \fIid\fR itself.
-.IP
-Refer to \fBnicira\-ext.h\fR for more details.
-.
.IP "\fBbundle(\fIfields\fB, \fIbasis\fB, \fIalgorithm\fB, \fIslave_type\fB, slaves:[\fIs1\fB, \fIs2\fB, ...])\fR"
Hashes \fIfields\fR using \fIbasis\fR as a universal hash parameter, then
applies the bundle link selection \fIalgorithm\fR to choose one of the listed
.RE
.IP
This action was added in Open vSwitch 1.5.90.
+.
+.IP "\fBsample(\fIargument\fR[\fB,\fIargument\fR]...\fB)\fR"
+Samples packets and sends one sample for every sampled packet.
+.IP
+\fIargument\fR takes the following forms:
+.RS
+.IP "\fBprobability=\fIpackets\fR"
+The number of sampled packets out of 65535. Must be greater or equal to 1.
+.IP "\fBcollector_set_id=\fIid\fR"
+The unsigned 32-bit integer identifier of the set of sample collectors
+to send sampled packets to. Defaults to 0.
+.IP "\fBobs_domain_id=\fIid\fR"
+When sending samples to IPFIX collectors, the unsigned 32-bit integer
+Observation Domain ID sent in every IPFIX flow record. Defaults to 0.
+.IP "\fBobs_point_id=\fIid\fR"
+When sending samples to IPFIX collectors, the unsigned 32-bit integer
+Observation Point ID sent in every IPFIX flow record. Defaults to 0.
+.RE
+.IP
+Refer to \fBovs\-vswitchd.conf.db\fR(8) for more details on
+configuring sample collector sets.
+.IP
+This action was added in Open vSwitch 1.10.90.
+.
.IP "\fBexit\fR"
This action causes Open vSwitch to immediately halt execution of further
actions. Those actions which have already been executed are unaffected. Any
.BR ovs\-appctl (8),
.BR ovs\-controller (8),
.BR ovs\-vswitchd (8)
+.BR ovs\-vswitchd.conf.db (8)
git://git.onelab.eu / sliver-openvswitch.git / blobdiff