should be enabled. Default is disabled, set to
<code>true</code> to enable.
</column>
+
+ <column name="other_config" key="mac-aging-time"
+ type='{"type": "integer", "minInteger": 1}'>
+ <p>
+ The maximum number of seconds to retain a MAC learning entry for
+ which no packets have been seen. The default is currently 300
+ seconds (5 minutes). The value, if specified, is forced into a
+ reasonable range, currently 15 to 3600 seconds.
+ </p>
+
+ <p>
+ A short MAC aging time allows a network to more quickly detect that a
+ host is no longer connected to a switch port. However, it also makes
+ it more likely that packets will be flooded unnecessarily, when they
+ are addressed to a connected host that rarely transmits packets. To
+ reduce the incidence of unnecessary flooding, use a MAC aging time
+ longer than the maximum interval at which a host will ordinarily
+ transmit packets.
+ </p>
+ </column>
</group>
<group title="Bridge Status">
VLAN splinters increase kernel and userspace memory overhead, so do
not use them unless they are needed.
</p>
+
+ <p>
+ VLAN splinters do not support 802.1p priority tags. Received
+ priorities will appear to be 0, regardless of their actual values,
+ and priorities on transmitted packets will also be cleared to 0.
+ </p>
</column>
</group>
supported range of queue numbers depend on <ref column="type"/>. The
queue numbers are the same as the <code>queue_id</code> used in
OpenFlow in <code>struct ofp_action_enqueue</code> and other
- structures. Queue 0 is used by OpenFlow output actions that do not
- specify a specific queue.</p>
+ structures.</p>
+
+ <p>
+ Queue 0 is the ``default queue.'' It is used by OpenFlow output
+ actions when no specific queue has been set. Ordinarily <ref
+ column="queues"/> should include a configuration for queue 0. When no
+ configuration for queue 0 is present, a default configuration is used.
+ (Before version 1.6, Open vSwitch would leave queue 0 unconfigured in
+ this case. With some queuing disciplines, this dropped all packets
+ destined for the default queue.)
+ </p>
</column>
<group title="Configuration for linux-htb and linux-hfsc">
<group title="Configuration for linux-htb QoS">
<p>
- These key-value pairs are defined for <ref table="QoS"/> <ref
- table="QoS" column="type"/> of <code>linux-htb</code>.
+ <ref table="QoS"/> <ref table="QoS" column="type"/>
+ <code>linux-htb</code> may use <code>queue_id</code>s less than 61440.
+ It has the following key-value pairs defined.
</p>
<column name="other_config" key="min-rate"
<group title="Configuration for linux-hfsc QoS">
<p>
- These key-value pairs are defined for <ref table="QoS"/> <ref
- table="QoS" column="type"/> of <code>linux-hfsc</code>.
+ <ref table="QoS"/> <ref table="QoS" column="type"/>
+ <code>linux-hfsc</code> may use <code>queue_id</code>s less than 61440.
+ It has the following key-value pairs defined.
</p>
<column name="other_config" key="min-rate"