xenserver: Fix typo in RPM install message.

[sliver-openvswitch.git] / xenserver / openvswitch-xen.spec

diff --git a/xenserver/openvswitch-xen.spec b/xenserver/openvswitch-xen.spec
index 7a2e176..c428fc6 100644 (file)
--- a/xenserver/openvswitch-xen.spec
+++ b/xenserver/openvswitch-xen.spec
@@ -231,10 +231,19 @@ if [ "$1" = "1" ]; then    # $1 = 2 for upgrade
     printf "\nYou MUST reboot the server NOW to complete the change to\n"
     printf "Open vSwitch.  Attempts to modify networking on the server\n"
     printf "or any hosted VM will fail until after the reboot and could\n"
-    printf "leave the server in an state requiring manual recovery.\n\n"
+    printf "leave the server in a state requiring manual recovery.\n\n"
 else
-    printf "\nTo use the new Open vSwitch install, you should reboot the\n" 
-    printf "server now.  Failure to do so may result in incorrect operation."
+
+    mode=$(cat /etc/xensource/network.conf)
+    if [ "$mode" != "vswitch" ] && [ "$mode" != "openvswitch" ]; then
+        printf "\nThe server is not configured to run Open vSwitch.  To run in\n"
+        printf "vswitch mode, you must run the following command:\n\n"
+        printf "\txe-switch-network-backend vswitch"
+    else
+        printf "\nTo use the new Open vSwitch install, you should reboot the\n"
+        printf "server now.  Failure to do so may result in incorrect operation."
+    fi
+
     printf "\n\n"
 fi