linux 2.6.16.38 w/ vs2.0.3-rc1

[linux-2.6.git] / Documentation / i2c / busses / scx200_acb

diff --git a/Documentation/i2c/busses/scx200_acb b/Documentation/i2c/busses/scx200_acb
index 7c07883..08c8cd1 100644 (file)
--- a/Documentation/i2c/busses/scx200_acb
+++ b/Documentation/i2c/busses/scx200_acb
@@ -2,31 +2,13 @@ Kernel driver scx200_acb
 
 Author: Christer Weinigel <wingel@nano-system.com>
 
-The driver supersedes the older, never merged driver named i2c-nscacb.
-
 Module Parameters
 -----------------
 
-* base: up to 4 ints
-  Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
-
-  By default the driver uses two base addresses 0x820 and 0x840.
-  If you want only one base address, specify the second as 0 so as to
-  override this default.
+* base: int
+  Base addresses for the ACCESS.bus controllers
 
 Description
 -----------
 
-Enable the use of the ACCESS.bus controller on the Geode SCx200 and
-SC1100 processors and the CS5535 and CS5536 Geode companion devices.
-
-Device-specific notes
----------------------
-
-The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
-If the scx200_acb driver is built into the kernel, add the following
-parameter to your boot command line:
-  scx200_acb.base=0x810,0x820
-If the scx200_acb driver is built as a module, add the following line to
-the file /etc/modprobe.conf instead:
-  options scx200_acb base=0x810,0x820
+Enable the use of the ACCESS.bus controllers of a SCx200 processor.