/*
- * linux/arch/arm/mach-omap/omap2/board-apollon.c
+ * linux/arch/arm/mach-omap2/board-apollon.c
*
* Copyright (C) 2005,2006 Samsung Electronics
* Author: Kyungmin Park <kyungmin.park@samsung.com>
#include <linux/mtd/mtd.h>
#include <linux/mtd/partitions.h>
#include <linux/mtd/onenand.h>
+#include <linux/irq.h>
#include <linux/interrupt.h>
#include <linux/delay.h>
static struct omap_mmc_config apollon_mmc_config __initdata = {
.mmc [0] = {
- .enabled = 0,
- .wire4 = 0,
+ .enabled = 1,
+ .wire4 = 1,
.wp_pin = -1,
.power_pin = -1,
.switch_pin = -1,
omap_set_gpio_dataout(LED2_GPIO15, 0);
}
-static irqreturn_t apollon_sw_interrupt(int irq, void *ignored, struct pt_regs *regs)
+static irqreturn_t apollon_sw_interrupt(int irq, void *ignored)
{
static unsigned int led0, led1, led2;
/* REVISIT: where's the correct place */
omap_cfg_reg(W19_24XX_SYS_NIRQ);
+ /* Use Interal loop-back in MMC/SDIO Module Input Clock selection */
+ CONTROL_DEVCONF |= (1 << 24);
+
/*
* Make sure the serial ports are muxed on at this point.
* You have to mux them off in device drivers later on