#include <linux/bitmap.h>
#include <linux/module.h>
#include <linux/topology.h>
+#include <linux/bootmem.h>
+#include <linux/mm.h>
#include <asm/proto.h>
#include <asm/numa.h>
#include <asm/e820.h>
+int acpi_numa __initdata;
+
static struct acpi_table_slit *acpi_slit;
static nodemask_t nodes_parsed __initdata;
-static nodemask_t nodes_found __initdata;
-static struct node nodes[MAX_NUMNODES] __initdata;
-static u8 pxm2node[256] = { [0 ... 255] = 0xff };
+static struct bootnode nodes[MAX_NUMNODES] __initdata;
+static struct bootnode nodes_add[MAX_NUMNODES];
+static int found_add_area __initdata;
+int hotadd_percent __initdata = 0;
/* Too small nodes confuse the VM badly. Usually they result
from BIOS bugs. */
#define NODE_MIN_SIZE (4*1024*1024)
-static int node_to_pxm(int n);
-
-int pxm_to_node(int pxm)
-{
- if ((unsigned)pxm >= 256)
- return -1;
- /* Extend 0xff to (int)-1 */
- return (signed char)pxm2node[pxm];
-}
-
static __init int setup_node(int pxm)
{
- unsigned node = pxm2node[pxm];
- if (node == 0xff) {
- if (nodes_weight(nodes_found) >= MAX_NUMNODES)
- return -1;
- node = first_unset_node(nodes_found);
- node_set(node, nodes_found);
- pxm2node[pxm] = node;
- }
- return pxm2node[pxm];
+ return acpi_map_pxm_to_node(pxm);
}
static __init int conflicting_nodes(unsigned long start, unsigned long end)
{
int i;
for_each_node_mask(i, nodes_parsed) {
- struct node *nd = &nodes[i];
+ struct bootnode *nd = &nodes[i];
if (nd->start == nd->end)
continue;
if (nd->end > start && nd->start < end)
static __init void cutoff_node(int i, unsigned long start, unsigned long end)
{
- struct node *nd = &nodes[i];
+ struct bootnode *nd = &nodes[i];
+
+ if (found_add_area)
+ return;
+
if (nd->start < start) {
nd->start = start;
if (nd->end < nd->start)
int i;
printk(KERN_ERR "SRAT: SRAT not used.\n");
acpi_numa = -1;
+ found_add_area = 0;
for (i = 0; i < MAX_LOCAL_APIC; i++)
apicid_to_node[i] = NUMA_NO_NODE;
+ for (i = 0; i < MAX_NUMNODES; i++)
+ nodes_add[i].start = nodes[i].end = 0;
+ remove_all_active_ranges();
}
static __init inline int srat_disabled(void)
int pxm, node;
if (srat_disabled())
return;
- if (pa->header.length != sizeof(struct acpi_table_processor_affinity)) { bad_srat();
+ if (pa->header.length != sizeof(struct acpi_table_processor_affinity)) {
+ bad_srat();
return;
}
if (pa->flags.enabled == 0)
pxm, pa->apic_id, node);
}
+#ifdef CONFIG_MEMORY_HOTPLUG_RESERVE
+/*
+ * Protect against too large hotadd areas that would fill up memory.
+ */
+static int hotadd_enough_memory(struct bootnode *nd)
+{
+ static unsigned long allocated;
+ static unsigned long last_area_end;
+ unsigned long pages = (nd->end - nd->start) >> PAGE_SHIFT;
+ long mem = pages * sizeof(struct page);
+ unsigned long addr;
+ unsigned long allowed;
+ unsigned long oldpages = pages;
+
+ if (mem < 0)
+ return 0;
+ allowed = (end_pfn - absent_pages_in_range(0, end_pfn)) * PAGE_SIZE;
+ allowed = (allowed / 100) * hotadd_percent;
+ if (allocated + mem > allowed) {
+ unsigned long range;
+ /* Give them at least part of their hotadd memory upto hotadd_percent
+ It would be better to spread the limit out
+ over multiple hotplug areas, but that is too complicated
+ right now */
+ if (allocated >= allowed)
+ return 0;
+ range = allowed - allocated;
+ pages = (range / PAGE_SIZE);
+ mem = pages * sizeof(struct page);
+ nd->end = nd->start + range;
+ }
+ /* Not completely fool proof, but a good sanity check */
+ addr = find_e820_area(last_area_end, end_pfn<<PAGE_SHIFT, mem);
+ if (addr == -1UL)
+ return 0;
+ if (pages != oldpages)
+ printk(KERN_NOTICE "SRAT: Hotadd area limited to %lu bytes\n",
+ pages << PAGE_SHIFT);
+ last_area_end = addr + mem;
+ allocated += mem;
+ return 1;
+}
+
+static int update_end_of_memory(unsigned long end)
+{
+ found_add_area = 1;
+ if ((end >> PAGE_SHIFT) > end_pfn)
+ end_pfn = end >> PAGE_SHIFT;
+ return 1;
+}
+
+static inline int save_add_info(void)
+{
+ return hotadd_percent > 0;
+}
+#else
+int update_end_of_memory(unsigned long end) {return -1;}
+static int hotadd_enough_memory(struct bootnode *nd) {return 1;}
+#ifdef CONFIG_MEMORY_HOTPLUG_SPARSE
+static inline int save_add_info(void) {return 1;}
+#else
+static inline int save_add_info(void) {return 0;}
+#endif
+#endif
+/*
+ * Update nodes_add and decide if to include add are in the zone.
+ * Both SPARSE and RESERVE need nodes_add infomation.
+ * This code supports one contigious hot add area per node.
+ */
+static int reserve_hotadd(int node, unsigned long start, unsigned long end)
+{
+ unsigned long s_pfn = start >> PAGE_SHIFT;
+ unsigned long e_pfn = end >> PAGE_SHIFT;
+ int ret = 0, changed = 0;
+ struct bootnode *nd = &nodes_add[node];
+
+ /* I had some trouble with strange memory hotadd regions breaking
+ the boot. Be very strict here and reject anything unexpected.
+ If you want working memory hotadd write correct SRATs.
+
+ The node size check is a basic sanity check to guard against
+ mistakes */
+ if ((signed long)(end - start) < NODE_MIN_SIZE) {
+ printk(KERN_ERR "SRAT: Hotplug area too small\n");
+ return -1;
+ }
+
+ /* This check might be a bit too strict, but I'm keeping it for now. */
+ if (absent_pages_in_range(s_pfn, e_pfn) != e_pfn - s_pfn) {
+ printk(KERN_ERR
+ "SRAT: Hotplug area %lu -> %lu has existing memory\n",
+ s_pfn, e_pfn);
+ return -1;
+ }
+
+ if (!hotadd_enough_memory(&nodes_add[node])) {
+ printk(KERN_ERR "SRAT: Hotplug area too large\n");
+ return -1;
+ }
+
+ /* Looks good */
+
+ if (nd->start == nd->end) {
+ nd->start = start;
+ nd->end = end;
+ changed = 1;
+ } else {
+ if (nd->start == end) {
+ nd->start = start;
+ changed = 1;
+ }
+ if (nd->end == start) {
+ nd->end = end;
+ changed = 1;
+ }
+ if (!changed)
+ printk(KERN_ERR "SRAT: Hotplug zone not continuous. Partly ignored\n");
+ }
+
+ ret = update_end_of_memory(nd->end);
+
+ if (changed)
+ printk(KERN_INFO "SRAT: hot plug zone found %Lx - %Lx\n", nd->start, nd->end);
+ return ret;
+}
+
/* Callback for parsing of the Proximity Domain <-> Memory Area mappings */
void __init
acpi_numa_memory_affinity_init(struct acpi_table_memory_affinity *ma)
{
- struct node *nd;
+ struct bootnode *nd, oldnode;
unsigned long start, end;
int node, pxm;
int i;
}
if (ma->flags.enabled == 0)
return;
+ if (ma->flags.hot_pluggable && !save_add_info())
+ return;
start = ma->base_addr_lo | ((u64)ma->base_addr_hi << 32);
end = start + (ma->length_lo | ((u64)ma->length_hi << 32));
pxm = ma->proximity_domain;
bad_srat();
return;
}
- /* It is fine to add this area to the nodes data it will be used later*/
- if (ma->flags.hot_pluggable == 1)
- printk(KERN_INFO "SRAT: hot plug zone found %lx - %lx \n",
- start, end);
i = conflicting_nodes(start, end);
if (i == node) {
printk(KERN_WARNING
return;
}
nd = &nodes[node];
+ oldnode = *nd;
if (!node_test_and_set(node, nodes_parsed)) {
nd->start = start;
nd->end = end;
if (nd->end < end)
nd->end = end;
}
+
printk(KERN_INFO "SRAT: Node %u PXM %u %Lx-%Lx\n", node, pxm,
nd->start, nd->end);
+ e820_register_active_regions(node, nd->start >> PAGE_SHIFT,
+ nd->end >> PAGE_SHIFT);
+ push_node_boundaries(node, nd->start >> PAGE_SHIFT,
+ nd->end >> PAGE_SHIFT);
+
+ if (ma->flags.hot_pluggable && (reserve_hotadd(node, start, end) < 0)) {
+ /* Ignore hotadd region. Undo damage */
+ printk(KERN_NOTICE "SRAT: Hotplug region ignored\n");
+ *nd = oldnode;
+ if ((nd->start | nd->end) == 0)
+ node_clear(node, nodes_parsed);
+ }
}
/* Sanity check to catch more bad SRATs (they are amazingly common).
unsigned long s = nodes[i].start >> PAGE_SHIFT;
unsigned long e = nodes[i].end >> PAGE_SHIFT;
pxmram += e - s;
- pxmram -= e820_hole_size(s, e);
+ pxmram -= absent_pages_in_range(s, e);
+ if ((long)pxmram < 0)
+ pxmram = 0;
}
- e820ram = end_pfn - e820_hole_size(0, end_pfn);
+ e820ram = end_pfn - absent_pages_in_range(0, end_pfn);
/* We seem to lose 3 pages somewhere. Allow a bit of slack. */
if ((long)(e820ram - pxmram) >= 1*1024*1024) {
printk(KERN_ERR
/* First clean up the node list */
for (i = 0; i < MAX_NUMNODES; i++) {
- cutoff_node(i, start, end);
- if ((nodes[i].end - nodes[i].start) < NODE_MIN_SIZE)
+ cutoff_node(i, start, end);
+ if ((nodes[i].end - nodes[i].start) < NODE_MIN_SIZE) {
unparse_node(i);
+ node_set_offline(i);
+ }
}
if (acpi_numa <= 0)
/* Finally register nodes */
for_each_node_mask(i, nodes_parsed)
setup_node_bootmem(i, nodes[i].start, nodes[i].end);
+ /* Try again in case setup_node_bootmem missed one due
+ to missing bootmem */
+ for_each_node_mask(i, nodes_parsed)
+ if (!node_online(i))
+ setup_node_bootmem(i, nodes[i].start, nodes[i].end);
+
for (i = 0; i < NR_CPUS; i++) {
if (cpu_to_node[i] == NUMA_NO_NODE)
continue;
return 0;
}
-static int node_to_pxm(int n)
+void __init srat_reserve_add_area(int nodeid)
{
- int i;
- if (pxm2node[n] == n)
- return n;
- for (i = 0; i < 256; i++)
- if (pxm2node[i] == n)
- return i;
- return 0;
+ if (found_add_area && nodes_add[nodeid].end) {
+ u64 total_mb;
+
+ printk(KERN_INFO "SRAT: Reserving hot-add memory space "
+ "for node %d at %Lx-%Lx\n",
+ nodeid, nodes_add[nodeid].start, nodes_add[nodeid].end);
+ total_mb = (nodes_add[nodeid].end - nodes_add[nodeid].start)
+ >> PAGE_SHIFT;
+ total_mb *= sizeof(struct page);
+ total_mb >>= 20;
+ printk(KERN_INFO "SRAT: This will cost you %Lu MB of "
+ "pre-allocated memory.\n", (unsigned long long)total_mb);
+ reserve_bootmem_node(NODE_DATA(nodeid), nodes_add[nodeid].start,
+ nodes_add[nodeid].end - nodes_add[nodeid].start);
+ }
}
int __node_distance(int a, int b)
}
EXPORT_SYMBOL(__node_distance);
+
+int memory_add_physaddr_to_nid(u64 start)
+{
+ int i, ret = 0;
+
+ for_each_node(i)
+ if (nodes_add[i].start <= start && nodes_add[i].end > start)
+ ret = i;
+
+ return ret;
+}
+EXPORT_SYMBOL_GPL(memory_add_physaddr_to_nid);
+
git://git.onelab.eu / linux-2.6.git / blobdiff