*/
/* define _CPIA_DEBUG_ for verbose debug output (see cpia.h) */
-/* #define _CPIA_DEBUG_ 1 */
+/* #define _CPIA_DEBUG_ 1 */
#include <linux/config.h>
static int cpia_pp_open(void *privdata);
static int cpia_pp_registerCallback(void *privdata, void (*cb) (void *cbdata),
- void *cbdata);
+ void *cbdata);
static int cpia_pp_transferCmd(void *privdata, u8 *command, u8 *data);
static int cpia_pp_streamStart(void *privdata);
static int cpia_pp_streamStop(void *privdata);
int stream_irq;
};
-static struct cpia_camera_ops cpia_pp_ops =
+static struct cpia_camera_ops cpia_pp_ops =
{
cpia_pp_open,
cpia_pp_registerCallback,
}
/* Special CPiA PPC modes: These are invoked by using the 1284 Extensibility
- * Link Flag during negotiation */
+ * Link Flag during negotiation */
#define UPLOAD_FLAG 0x08
#define NIBBLE_TRANSFER 0x01
#define ECP_TRANSFER 0x03
/* CPiA nonstandard "Nibble" mode (no nDataAvail signal after each byte). */
/* The standard kernel parport_ieee1284_read_nibble() fails with the CPiA... */
-static size_t cpia_read_nibble (struct parport *port,
- void *buffer, size_t len,
+static size_t cpia_read_nibble (struct parport *port,
+ void *buffer, size_t len,
int flags)
{
- /* adapted verbatim, with one change, from
+ /* adapted verbatim, with one change, from
parport_ieee1284_read_nibble() in drivers/parport/ieee1284-ops.c */
unsigned char *buf = buffer;
int i;
unsigned char byte = 0;
-
+
len *= 2; /* in nibbles */
for (i=0; i < len; i++) {
unsigned char nibble;
* after every second nibble to signal that more
* data is available. (the total number of Bytes that
* should be sent is known; if too few are received, an error
- * will be recorded after a timeout).
+ * will be recorded after a timeout).
* This is incompatible with parport_ieee1284_read_nibble(),
* which expects to find nFault LO after every second nibble.
*/
- /* Solution: modify cpia_read_nibble to only check for
+ /* Solution: modify cpia_read_nibble to only check for
* nDataAvail before the first nibble is sent.
*/
/* Does the error line indicate end of data? */
if (((i /*& 1*/) == 0) &&
(parport_read_status(port) & PARPORT_STATUS_ERROR)) {
- port->physport->ieee1284.phase = IEEE1284_PH_HBUSY_DNA;
- DBG("%s: No more nibble data (%d bytes)\n",
- port->name, i/2);
-
- /* Go to reverse idle phase. */
- parport_frob_control (port,
- PARPORT_CONTROL_AUTOFD,
- PARPORT_CONTROL_AUTOFD);
- port->physport->ieee1284.phase = IEEE1284_PH_REV_IDLE;
- break;
+ DBG("%s: No more nibble data (%d bytes)\n",
+ port->name, i/2);
+ goto end_of_data;
}
/* Event 7: Set nAutoFd low. */
/* Second nibble */
byte |= nibble << 4;
*buf++ = byte;
- } else
+ } else
byte = nibble;
}
- i /= 2; /* i is now in bytes */
-
if (i == len) {
/* Read the last nibble without checking data avail. */
- port = port->physport;
- if (parport_read_status (port) & PARPORT_STATUS_ERROR)
- port->ieee1284.phase = IEEE1284_PH_HBUSY_DNA;
+ if (parport_read_status (port) & PARPORT_STATUS_ERROR) {
+ end_of_data:
+ /* Go to reverse idle phase. */
+ parport_frob_control (port,
+ PARPORT_CONTROL_AUTOFD,
+ PARPORT_CONTROL_AUTOFD);
+ port->physport->ieee1284.phase = IEEE1284_PH_REV_IDLE;
+ }
else
- port->ieee1284.phase = IEEE1284_PH_HBUSY_DAVAIL;
+ port->physport->ieee1284.phase = IEEE1284_PH_HBUSY_DAVAIL;
}
- return i;
+ return i/2;
}
/* CPiA nonstandard "Nibble Stream" mode (2 nibbles per cycle, instead of 1)
- * (See CPiA Data sheet p. 31)
- *
- * "Nibble Stream" mode used by CPiA for uploads to non-ECP ports is a
- * nonstandard variant of nibble mode which allows the same (mediocre)
- * data flow of 8 bits per cycle as software-enabled ECP by TRISTATE-capable
+ * (See CPiA Data sheet p. 31)
+ *
+ * "Nibble Stream" mode used by CPiA for uploads to non-ECP ports is a
+ * nonstandard variant of nibble mode which allows the same (mediocre)
+ * data flow of 8 bits per cycle as software-enabled ECP by TRISTATE-capable
* parallel ports, but works also for non-TRISTATE-capable ports.
* (Standard nibble mode only send 4 bits per cycle)
*
*/
-static size_t cpia_read_nibble_stream(struct parport *port,
- void *buffer, size_t len,
+static size_t cpia_read_nibble_stream(struct parport *port,
+ void *buffer, size_t len,
int flags)
{
int i;
unsigned char nibble[2], byte = 0;
int j;
- /* Image Data is complete when 4 consecutive EOI bytes (0xff) are seen */
+ /* Image Data is complete when 4 consecutive EOI bytes (0xff) are seen */
if (endseen > 3 )
break;
parport_frob_control (port,
PARPORT_CONTROL_AUTOFD,
PARPORT_CONTROL_AUTOFD);
-
+
/* Event 9: nAck goes low. */
port->ieee1284.phase = IEEE1284_PH_REV_DATA;
if (parport_wait_peripheral (port,
/* Read lower nibble */
nibble[0] = parport_read_status (port) >>3;
-
+
/* Event 10: Set nAutoFd high. */
parport_frob_control (port, PARPORT_CONTROL_AUTOFD, 0);
port->name);
break;
}
-
+
/* Read upper nibble */
nibble[1] = parport_read_status (port) >>3;
-
+
/* reassemble the byte */
for (j = 0; j < 2 ; j++ ) {
nibble[j] &= ~8;
static int ForwardSetup(struct pp_cam_entry *cam)
{
int retry;
-
- /* The CPiA uses ECP protocol for Downloads from the Host to the camera.
+
+ /* The CPiA uses ECP protocol for Downloads from the Host to the camera.
* This will be software-emulated if ECP hardware is not present
*/
upload_mode = mode;
if(extensibility) mode = UPLOAD_FLAG|transfer_mode|IEEE1284_EXT_LINK;
- /* the usual camera maximum response time is 10ms, but after
+ /* the usual camera maximum response time is 10ms, but after
* receiving some commands, it needs up to 40ms. */
-
+
for(retry = 0; retry < 4; ++retry) {
if(!parport_negotiate(cam->port, mode)) {
break;
/* support for CPiA variant nibble reads */
if(cam->port->ieee1284.mode == IEEE1284_MODE_NIBBLE) {
- if(cpia_read_nibble(cam->port, packet, size, 0) != size)
- retval = -EIO;
+ if(cpia_read_nibble(cam->port, packet, size, 0) != size)
+ retval = -EIO;
} else {
- if(parport_read(cam->port, packet, size) != size)
+ if(parport_read(cam->port, packet, size) != size)
retval = -EIO;
}
EndTransferMode(cam);
block_size = PARPORT_CHUNK_SIZE;
while( !cam->image_complete ) {
cond_resched();
-
+
new_bytes = cpia_pp_read(cam->port, buffer, block_size );
if( new_bytes <= 0 ) {
break;
}
i=-1;
while(++i<new_bytes && endseen<4) {
- if(*buffer==EOI) {
- endseen++;
- } else {
- endseen=0;
- }
+ if(*buffer==EOI) {
+ endseen++;
+ } else {
+ endseen=0;
+ }
buffer++;
}
read_bytes += i;
}
if((err = ReadPacket(cam, buffer, 8)) < 0) {
DBG("Error reading command result\n");
- return err;
+ return err;
}
memcpy(data, buffer, databytes);
} else if(command[0] == DATA_OUT) {
static int cpia_pp_open(void *privdata)
{
struct pp_cam_entry *cam = (struct pp_cam_entry *)privdata;
-
+
if (cam == NULL)
return -EINVAL;
-
+
if(cam->open_count == 0) {
if (parport_claim(cam->pdev)) {
DBG("failed to claim the port\n");
parport_write_control(cam->port, PARPORT_CONTROL_SELECT);
udelay(50);
parport_write_control(cam->port,
- PARPORT_CONTROL_SELECT
- | PARPORT_CONTROL_INIT);
+ PARPORT_CONTROL_SELECT
+ | PARPORT_CONTROL_INIT);
}
-
+
++cam->open_count;
-
+
return 0;
}
{
struct pp_cam_entry *cam = privdata;
int retval = 0;
-
+
if(cam->port->irq != PARPORT_IRQ_NONE) {
INIT_WORK(&cam->cb_task, cb, cbdata);
} else {
return -ENXIO;
}
- cam = kmalloc(sizeof(struct pp_cam_entry), GFP_KERNEL);
+ cam = kzalloc(sizeof(struct pp_cam_entry), GFP_KERNEL);
if (cam == NULL) {
LOG("failed to allocate camera structure\n");
return -ENOMEM;
}
- memset(cam,0,sizeof(struct pp_cam_entry));
-
+
pdev = parport_register_device(port, "cpia_pp", NULL, NULL,
- NULL, 0, cam);
+ NULL, 0, cam);
if (!pdev) {
LOG("failed to parport_register_device\n");
}
cpia = NULL;
}
- spin_unlock( &cam_list_lock_pp );
+ spin_unlock( &cam_list_lock_pp );
if (!cpia) {
DBG("cpia_pp_detach failed to find cam_data in cam_list\n");
return;
}
-
- cam = (struct pp_cam_entry *) cpia->lowlevel_data;
+
+ cam = (struct pp_cam_entry *) cpia->lowlevel_data;
cpia_unregister_camera(cpia);
- if(cam->open_count > 0)
+ if(cam->open_count > 0)
cpia_pp_close(cam);
parport_unregister_device(cam->pdev);
- cpia->lowlevel_data = NULL;
+ cpia->lowlevel_data = NULL;
kfree(cam);
}
int cpia_pp_init(void)
{
- printk(KERN_INFO "%s v%d.%d.%d\n",ABOUT,
+ printk(KERN_INFO "%s v%d.%d.%d\n",ABOUT,
CPIA_PP_MAJ_VER,CPIA_PP_MIN_VER,CPIA_PP_PATCH_VER);
if(parport_nr[0] == PPCPIA_PARPORT_OFF) {
printk(" disabled\n");
return 0;
}
-
+
spin_lock_init( &cam_list_lock_pp );
if (parport_register_driver (&cpia_pp_driver)) {
parport_nr[parport_ptr++] = PPCPIA_PARPORT_NONE;
}
- return 0;
+ return 1;
}
__setup("cpia_pp=", cpia_pp_setup);
git://git.onelab.eu / linux-2.6.git / blobdiff