help
This enables support for accessing all type of NAND flash
devices. For further information see
- <http://www.linux-mtd.infradead.org/doc/nand.html>.
+ <http://www.linux-mtd.infradead.org/tech/nand.html>.
config MTD_NAND_VERIFY_WRITE
bool "Verify NAND page writes"
device thinks the write was successful, a bit could have been
flipped accidentaly due to device wear or something else.
-config MTD_NAND_ECC_SMC
- bool "NAND ECC Smart Media byte order"
- depends on MTD_NAND
- default n
- help
- Software ECC according to the Smart Media Specification.
- The original Linux implementation had byte 0 and 1 swapped.
-
config MTD_NAND_AUTCPU12
tristate "SmartMediaCard on autronix autcpu12 board"
depends on MTD_NAND && ARCH_AUTCPU12
help
If you had to ask, you don't have one. Say 'N'.
-config MTD_NAND_AMS_DELTA
- tristate "NAND Flash device on Amstrad E3"
- depends on MACH_AMS_DELTA && MTD_NAND
- help
- Support for NAND flash on Amstrad E3 (Delta).
-
config MTD_NAND_TOTO
tristate "NAND Flash device on TOTO board"
- depends on ARCH_OMAP && MTD_NAND && BROKEN
+ depends on ARCH_OMAP && MTD_NAND
help
Support for NAND flash on Texas Instruments Toto platform.
-config MTD_NAND_TS7250
- tristate "NAND Flash device on TS-7250 board"
- depends on MACH_TS72XX && MTD_NAND
- help
- Support for NAND flash on Technologic Systems TS-7250 platform.
-
config MTD_NAND_IDS
tristate
config MTD_NAND_PPCHAMELEONEVB
tristate "NAND Flash device on PPChameleonEVB board"
- depends on PPCHAMELEONEVB && MTD_NAND && BROKEN
+ depends on PPCHAMELEONEVB && MTD_NAND
help
This enables the NAND flash driver on the PPChameleon EVB Board.
This enables the NAND flash controller on the S3C2410 and S3C2440
SoCs
- No board specific support is done by this driver, each board
+ No board specfic support is done by this driver, each board
must advertise a platform_device for the driver to attach.
config MTD_NAND_S3C2410_DEBUG
currently not be able to switch to software, as there is no
implementation for ECC method used by the S3C2410
-config MTD_NAND_NDFC
- tristate "NDFC NanD Flash Controller"
- depends on MTD_NAND && 44x
- help
- NDFC Nand Flash Controllers are integrated in EP44x SoCs
-
-config MTD_NAND_S3C2410_CLKSTOP
- bool "S3C2410 NAND IDLE clock stop"
- depends on MTD_NAND_S3C2410
- default n
- help
- Stop the clock to the NAND controller when there is no chip
- selected to save power. This will mean there is a small delay
- when the is NAND chip selected or released, but will save
- approximately 5mA of power when there is nothing happening.
-
config MTD_NAND_DISKONCHIP
tristate "DiskOnChip 2000, Millennium and Millennium Plus (NAND reimplementation) (EXPERIMENTAL)"
depends on MTD_NAND && EXPERIMENTAL
tristate "Support for NAND Flash on Sharp SL Series (C7xx + others)"
depends on MTD_NAND && ARCH_PXA
-config MTD_NAND_CS553X
- tristate "NAND support for CS5535/CS5536 (AMD Geode companion chip)"
- depends on MTD_NAND && X86_32 && (X86_PC || X86_GENERICARCH)
- help
- The CS553x companion chips for the AMD Geode processor
- include NAND flash controllers with built-in hardware ECC
- capabilities; enabling this option will allow you to use
- these. The driver will check the MSRs to verify that the
- controller is enabled for NAND, and currently requires that
- the controller be in MMIO mode.
-
- If you say "m", the module will be called "cs553x_nand.ko".
-
config MTD_NAND_NANDSIM
tristate "Support for NAND Flash Simulator"
depends on MTD_NAND && MTD_PARTITIONS
help
- The simulator may simulate various NAND flash chips for the
+ The simulator may simulate verious NAND flash chips for the
MTD nand layer.
endmenu