linux 2.6.16.38 w/ vs2.0.3-rc1
[linux-2.6.git] / drivers / mtd / nand / autcpu12.c
index fe94ae9..a3c7fea 100644 (file)
@@ -4,7 +4,7 @@
  *  Copyright (c) 2002 Thomas Gleixner <tgxl@linutronix.de>
  *
  *  Derived from drivers/mtd/spia.c
- *      Copyright (C) 2000 Steven J. Hill (sjhill@realitydiluted.com)
+ *      Copyright (C) 2000 Steven J. Hill (sjhill@realitydiluted.com)
  *
  * $Id: autcpu12.c,v 1.23 2005/11/07 11:14:30 gleixner Exp $
  *
  * MTD structure for AUTCPU12 board
  */
 static struct mtd_info *autcpu12_mtd = NULL;
-static void __iomem *autcpu12_fio_base;
+
+static int autcpu12_io_base = CS89712_VIRT_BASE;
+static int autcpu12_fio_pbase = AUTCPU12_PHYS_SMC;
+static int autcpu12_fio_ctrl = AUTCPU12_SMC_SELECT_OFFSET;
+static int autcpu12_pedr = AUTCPU12_SMC_PORT_OFFSET;
+static void __iomem * autcpu12_fio_base;
 
 /*
  * Define partitions for flash devices
@@ -89,131 +94,108 @@ static struct mtd_partition partition_info128k[] = {
 #define NUM_PARTITIONS128K 2
 /*
  *     hardware specific access to control-lines
- *
- *     ALE bit 4 autcpu12_pedr
- *     CLE bit 5 autcpu12_pedr
- *     NCE bit 0 fio_ctrl
- *
- */
-static void autcpu12_hwcontrol(struct mtd_info *mtd, int cmd,
-                              unsigned int ctrl)
+*/
+static void autcpu12_hwcontrol(struct mtd_info *mtd, int cmd)
 {
-       struct nand_chip *chip = mtd->priv;
 
-       if (ctrl & NAND_CTRL_CHANGE) {
-               void __iomem *addr
-               unsigned char bits;
+       switch(cmd){
 
-               addr = CS89712_VIRT_BASE + AUTCPU12_SMC_PORT_OFFSET;
-               bits = (ctrl & NAND_CLE) << 4;
-               bits |= (ctrl & NAND_ALE) << 2;
-               writeb((readb(addr) & ~0x30) | bits, addr);
+               case NAND_CTL_SETCLE: (*(volatile unsigned char *) (autcpu12_io_base + autcpu12_pedr)) |=  AUTCPU12_SMC_CLE; break;
+               case NAND_CTL_CLRCLE: (*(volatile unsigned char *) (autcpu12_io_base + autcpu12_pedr)) &= ~AUTCPU12_SMC_CLE; break;
 
-               addr = autcpu12_fio_base + AUTCPU12_SMC_SELECT_OFFSET;
-               writeb((readb(addr) & ~0x1) | (ctrl & NAND_NCE), addr);
-       }
+               case NAND_CTL_SETALE: (*(volatile unsigned char *) (autcpu12_io_base + autcpu12_pedr)) |=  AUTCPU12_SMC_ALE; break;
+               case NAND_CTL_CLRALE: (*(volatile unsigned char *) (autcpu12_io_base + autcpu12_pedr)) &= ~AUTCPU12_SMC_ALE; break;
 
-       if (cmd != NAND_CMD_NONE)
-               writeb(cmd, chip->IO_ADDR_W);
+               case NAND_CTL_SETNCE: (*(volatile unsigned char *) (autcpu12_fio_base + autcpu12_fio_ctrl)) = 0x01; break;
+               case NAND_CTL_CLRNCE: (*(volatile unsigned char *) (autcpu12_fio_base + autcpu12_fio_ctrl)) = 0x00; break;
+       }
 }
 
 /*
- *     read device ready pin
- */
+     read device ready pin
+*/
 int autcpu12_device_ready(struct mtd_info *mtd)
 {
-       void __iomem *addr = CS89712_VIRT_BASE + AUTCPU12_SMC_PORT_OFFSET;
 
-       return readb(addr) & AUTCPU12_SMC_RDY;
+       return ( (*(volatile unsigned char *) (autcpu12_io_base + autcpu12_pedr)) & AUTCPU12_SMC_RDY) ? 1 : 0;
+
 }
 
 /*
  * Main initialization routine
  */
-static int __init autcpu12_init(void)
+int __init autcpu12_init (void)
 {
        struct nand_chip *this;
        int err = 0;
 
        /* Allocate memory for MTD device structure and private data */
-       autcpu12_mtd = kmalloc(sizeof(struct mtd_info) + sizeof(struct nand_chip),
-                              GFP_KERNEL);
+       autcpu12_mtd = kmalloc (sizeof(struct mtd_info) + sizeof (struct nand_chip),
+                               GFP_KERNEL);
        if (!autcpu12_mtd) {
-               printk("Unable to allocate AUTCPU12 NAND MTD device structure.\n");
+               printk ("Unable to allocate AUTCPU12 NAND MTD device structure.\n");
                err = -ENOMEM;
                goto out;
        }
 
        /* map physical adress */
-       autcpu12_fio_base = ioremap(AUTCPU12_PHYS_SMC, SZ_1K);
-       if (!autcpu12_fio_base) {
+       autcpu12_fio_base = ioremap(autcpu12_fio_pbase,SZ_1K);
+       if(!autcpu12_fio_base){
                printk("Ioremap autcpu12 SmartMedia Card failed\n");
                err = -EIO;
                goto out_mtd;
        }
 
        /* Get pointer to private data */
-       this = (struct nand_chip *)(&autcpu12_mtd[1]);
+       this = (struct nand_chip *) (&autcpu12_mtd[1]);
 
        /* Initialize structures */
-       memset(autcpu12_mtd, 0, sizeof(struct mtd_info));
-       memset(this, 0, sizeof(struct nand_chip));
+       memset((char *) autcpu12_mtd, 0, sizeof(struct mtd_info));
+       memset((char *) this, 0, sizeof(struct nand_chip));
 
        /* Link the private data with the MTD structure */
        autcpu12_mtd->priv = this;
-       autcpu12_mtd->owner = THIS_MODULE;
 
        /* Set address of NAND IO lines */
        this->IO_ADDR_R = autcpu12_fio_base;
        this->IO_ADDR_W = autcpu12_fio_base;
-       this->cmd_ctrl = autcpu12_hwcontrol;
+       this->hwcontrol = autcpu12_hwcontrol;
        this->dev_ready = autcpu12_device_ready;
        /* 20 us command delay time */
        this->chip_delay = 20;
-       this->ecc.mode = NAND_ECC_SOFT;
+       this->eccmode = NAND_ECC_SOFT;
 
        /* Enable the following for a flash based bad block table */
        /*
-          this->options = NAND_USE_FLASH_BBT;
-        */
+       this->options = NAND_USE_FLASH_BBT;
+       */
        this->options = NAND_USE_FLASH_BBT;
 
        /* Scan to find existance of the device */
-       if (nand_scan(autcpu12_mtd, 1)) {
+       if (nand_scan (autcpu12_mtd, 1)) {
                err = -ENXIO;
                goto out_ior;
        }
 
        /* Register the partitions */
-       switch (autcpu12_mtd->size) {
-               case SZ_16M:
-                       add_mtd_partitions(autcpu12_mtd, partition_info16k,
-                                          NUM_PARTITIONS16K);
-                       break;
-               case SZ_32M:
-                       add_mtd_partitions(autcpu12_mtd, partition_info32k,
-                                          NUM_PARTITIONS32K);
-                       break;
-               case SZ_64M:
-                       add_mtd_partitions(autcpu12_mtd, partition_info64k,
-                                          NUM_PARTITIONS64K);
-                       break;
-               case SZ_128M:
-                       add_mtd_partitions(autcpu12_mtd, partition_info128k,
-                                          NUM_PARTITIONS128K);
-                       break;
-               default:
-                       printk("Unsupported SmartMedia device\n");
+       switch(autcpu12_mtd->size){
+               case SZ_16M: add_mtd_partitions(autcpu12_mtd, partition_info16k, NUM_PARTITIONS16K); break;
+               case SZ_32M: add_mtd_partitions(autcpu12_mtd, partition_info32k, NUM_PARTITIONS32K); break;
+               case SZ_64M: add_mtd_partitions(autcpu12_mtd, partition_info64k, NUM_PARTITIONS64K); break;
+               case SZ_128M: add_mtd_partitions(autcpu12_mtd, partition_info128k, NUM_PARTITIONS128K); break;
+               default: {
+                       printk ("Unsupported SmartMedia device\n");
                        err = -ENXIO;
                        goto out_ior;
+               }
        }
        goto out;
 
- out_ior:
-       iounmap(autcpu12_fio_base);
- out_mtd:
-       kfree(autcpu12_mtd);
- out:
+out_ior:
+       iounmap((void *)autcpu12_fio_base);
+out_mtd:
+       kfree (autcpu12_mtd);
+out:
        return err;
 }
 
@@ -222,19 +204,20 @@ module_init(autcpu12_init);
 /*
  * Clean up routine
  */
-static void __exit autcpu12_cleanup(void)
+#ifdef MODULE
+static void __exit autcpu12_cleanup (void)
 {
        /* Release resources, unregister device */
-       nand_release(autcpu12_mtd);
+       nand_release (autcpu12_mtd);
 
        /* unmap physical adress */
-       iounmap(autcpu12_fio_base);
+       iounmap((void *)autcpu12_fio_base);
 
        /* Free the MTD device structure */
-       kfree(autcpu12_mtd);
+       kfree (autcpu12_mtd);
 }
-
 module_exit(autcpu12_cleanup);
+#endif
 
 MODULE_LICENSE("GPL");
 MODULE_AUTHOR("Thomas Gleixner <tglx@linutronix.de>");