vserver 1.9.3

[linux-2.6.git] / drivers / pcmcia / pxa2xx_base.c

diff --git a/drivers/pcmcia/pxa2xx_base.c b/drivers/pcmcia/pxa2xx_base.c
index 491d11b..2bdf9a0 100644 (file)
--- a/drivers/pcmcia/pxa2xx_base.c
+++ b/drivers/pcmcia/pxa2xx_base.c
@@ -28,6 +28,7 @@
 #include <asm/io.h>
 #include <asm/irq.h>
 #include <asm/system.h>
+#include <asm/arch/pxa-regs.h>
 
 #include <pcmcia/cs_types.h>
 #include <pcmcia/ss.h>
@@ -178,39 +179,6 @@ int pxa2xx_drv_pcmcia_probe(struct device *dev)
        first = ops->first;
        nr = ops->nr;
 
-       /* Setup GPIOs for PCMCIA/CF alternate function mode.
-        *
-        * It would be nice if set_GPIO_mode included support
-        * for driving GPIO outputs to default high/low state
-        * before programming GPIOs as outputs. Setting GPIO
-        * outputs to default high/low state via GPSR/GPCR
-        * before defining them as outputs should reduce
-        * the possibility of glitching outputs during GPIO
-        * setup. This of course assumes external terminators
-        * are present to hold GPIOs in a defined state.
-        *
-        * In the meantime, setup default state of GPIO
-        * outputs before we enable them as outputs.
-        */
-
-       GPSR(GPIO48_nPOE) = GPIO_bit(GPIO48_nPOE) |
-               GPIO_bit(GPIO49_nPWE) |
-               GPIO_bit(GPIO50_nPIOR) |
-               GPIO_bit(GPIO51_nPIOW) |
-               GPIO_bit(GPIO52_nPCE_1) |
-               GPIO_bit(GPIO53_nPCE_2);
-
-       pxa_gpio_mode(GPIO48_nPOE_MD);
-       pxa_gpio_mode(GPIO49_nPWE_MD);
-       pxa_gpio_mode(GPIO50_nPIOR_MD);
-       pxa_gpio_mode(GPIO51_nPIOW_MD);
-       pxa_gpio_mode(GPIO52_nPCE_1_MD);
-       pxa_gpio_mode(GPIO53_nPCE_2_MD);
-       pxa_gpio_mode(GPIO54_pSKTSEL_MD); /* REVISIT: s/b dependent on num sockets */
-       pxa_gpio_mode(GPIO55_nPREG_MD);
-       pxa_gpio_mode(GPIO56_nPWAIT_MD);
-       pxa_gpio_mode(GPIO57_nIOIS16_MD);
-
        /* Provide our PXA2xx specific timing routines. */
        ops->set_timing  = pxa2xx_pcmcia_set_timing;
 #ifdef CONFIG_CPU_FREQ