inexpensive battery powered microcontroller evaluation board.
This same cable can be used to flash new firmware.
-config SPI_MPC83xx
- tristate "Freescale MPC83xx SPI controller"
- depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL
- select SPI_BITBANG
- help
- This enables using the Freescale MPC83xx SPI controller in master
- mode.
-
- Note, this driver uniquely supports the SPI controller on the MPC83xx
- family of PowerPC processors. The MPC83xx uses a simple set of shift
- registers for data (opposed to the CPM based descriptor model).
-
-config SPI_PXA2XX
- tristate "PXA2xx SSP SPI master"
- depends on SPI_MASTER && ARCH_PXA && EXPERIMENTAL
- help
- This enables using a PXA2xx SSP port as a SPI master controller.
- The driver can be configured to use any SSP port and additional
- documentation can be found a Documentation/spi/pxa2xx.
-
-config SPI_S3C24XX_GPIO
- tristate "Samsung S3C24XX series SPI by GPIO"
- depends on SPI_MASTER && ARCH_S3C2410 && SPI_BITBANG && EXPERIMENTAL
- help
- SPI driver for Samsung S3C24XX series ARM SoCs using
- GPIO lines to provide the SPI bus. This can be used where
- the inbuilt hardware cannot provide the transfer mode, or
- where the board is using non hardware connected pins.
#
# Add new SPI master controllers in alphabetical order above this line
#
-config SPI_S3C24XX
- tristate "Samsung S3C24XX series SPI"
- depends on SPI_MASTER && ARCH_S3C2410 && EXPERIMENTAL
- help
- SPI driver for Samsung S3C24XX series ARM SoCs
-
#
# There are lots of SPI device types, with sensors and memory
# being probably the most widely used ones.
git://git.onelab.eu / linux-2.6.git / blobdiff