*/
#include <linux/config.h>
-
-#ifdef CONFIG_USB_DEBUG
-# define DEBUG
-#else
-# undef DEBUG
-#endif
-
#include <linux/module.h>
#include <linux/moduleparam.h>
#include <linux/pci.h>
#include <linux/init.h>
#include <linux/timer.h>
#include <linux/list.h>
-#include <linux/interrupt.h> /* for in_interrupt () */
#include <linux/usb.h>
#include <linux/usb_otg.h>
-#include "../core/hcd.h"
#include <linux/dma-mapping.h>
-#include <linux/dmapool.h> /* needed by ohci-mem.c when no PCI */
+#include <linux/dmapool.h>
+#include <linux/reboot.h>
#include <asm/io.h>
#include <asm/irq.h>
#include <asm/unaligned.h>
#include <asm/byteorder.h>
+#include "../core/hcd.h"
-#define DRIVER_VERSION "2004 Nov 08"
+#define DRIVER_VERSION "2005 April 22"
#define DRIVER_AUTHOR "Roman Weissgaerber, David Brownell"
#define DRIVER_DESC "USB 1.1 'Open' Host Controller (OHCI) Driver"
/*-------------------------------------------------------------------------*/
-// #define OHCI_VERBOSE_DEBUG /* not always helpful */
+#undef OHCI_VERBOSE_DEBUG /* not always helpful */
/* For initializing controller (mask in an HCFS mode too) */
#define OHCI_CONTROL_INIT OHCI_CTRL_CBSR
static void ohci_dump (struct ohci_hcd *ohci, int verbose);
static int ohci_init (struct ohci_hcd *ohci);
static void ohci_stop (struct usb_hcd *hcd);
+static int ohci_reboot (struct notifier_block *, unsigned long , void *);
#include "ohci-hub.c"
#include "ohci-dbg.c"
struct usb_hcd *hcd,
struct usb_host_endpoint *ep,
struct urb *urb,
- int mem_flags
+ gfp_t mem_flags
) {
struct ohci_hcd *ohci = hcd_to_ohci (hcd);
struct ed *ed;
spin_lock_irqsave (&ohci->lock, flags);
/* don't submit to a dead HC */
+ if (!test_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags)) {
+ retval = -ENODEV;
+ goto fail;
+ }
if (!HC_IS_RUNNING(hcd->state)) {
retval = -ENODEV;
goto fail;
goto sanitize;
}
spin_unlock_irqrestore (&ohci->lock, flags);
- set_current_state (TASK_UNINTERRUPTIBLE);
- schedule_timeout (1);
+ schedule_timeout_uninterruptible(1);
goto rescan;
case ED_IDLE: /* fully unlinked */
if (list_empty (&ed->td_list)) {
ohci_writel (ohci, ohci->hc_control, &ohci->regs->control);
}
+/* reboot notifier forcibly disables IRQs and DMA, helping kexec and
+ * other cases where the next software may expect clean state from the
+ * "firmware". this is bus-neutral, unlike shutdown() methods.
+ */
+static int
+ohci_reboot (struct notifier_block *block, unsigned long code, void *null)
+{
+ struct ohci_hcd *ohci;
+
+ ohci = container_of (block, struct ohci_hcd, reboot_notifier);
+ ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
+ ohci_usb_reset (ohci);
+ /* flush the writes */
+ (void) ohci_readl (ohci, &ohci->regs->control);
+ return 0;
+}
+
/*-------------------------------------------------------------------------*
* HC functions
*-------------------------------------------------------------------------*/
static int ohci_init (struct ohci_hcd *ohci)
{
int ret;
+ struct usb_hcd *hcd = ohci_to_hcd(ohci);
disable (ohci);
- ohci->regs = ohci_to_hcd(ohci)->regs;
+ ohci->regs = hcd->regs;
ohci->next_statechange = jiffies;
+ /* REVISIT this BIOS handshake is now moved into PCI "quirks", and
+ * was never needed for most non-PCI systems ... remove the code?
+ */
+
#ifndef IR_DISABLE
/* SMM owns the HC? not for long! */
if (!no_handshake && ohci_readl (ohci,
/* Disable HC interrupts */
ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
- // flush the writes
- (void) ohci_readl (ohci, &ohci->regs->control);
+
+ /* flush the writes, and save key bits like RWC */
+ if (ohci_readl (ohci, &ohci->regs->control) & OHCI_CTRL_RWC)
+ ohci->hc_control |= OHCI_CTRL_RWC;
+
+ /* Read the number of ports unless overridden */
+ if (ohci->num_ports == 0)
+ ohci->num_ports = roothub_a(ohci) & RH_A_NDP;
if (ohci->hcca)
return 0;
- ohci->hcca = dma_alloc_coherent (ohci_to_hcd(ohci)->self.controller,
+ ohci->hcca = dma_alloc_coherent (hcd->self.controller,
sizeof *ohci->hcca, &ohci->hcca_dma, 0);
if (!ohci->hcca)
return -ENOMEM;
if ((ret = ohci_mem_init (ohci)) < 0)
- ohci_stop (ohci_to_hcd(ohci));
+ ohci_stop (hcd);
+ else {
+ register_reboot_notifier (&ohci->reboot_notifier);
+ create_debug_files (ohci);
+ }
return ret;
-
}
/*-------------------------------------------------------------------------*/
/* Start an OHCI controller, set the BUS operational
* resets USB and controller
* enable interrupts
- * connect the virtual root hub
*/
static int ohci_run (struct ohci_hcd *ohci)
{
u32 mask, temp;
- struct usb_device *udev;
- struct usb_bus *bus;
int first = ohci->fminterval == 0;
+ struct usb_hcd *hcd = ohci_to_hcd(ohci);
disable (ohci);
/* also: power/overcurrent flags in roothub.a */
}
- /* Reset USB nearly "by the book". RemoteWakeupConnected
- * saved if boot firmware (BIOS/SMM/...) told us it's connected
- * (for OHCI integrated on mainboard, it normally is)
+ /* Reset USB nearly "by the book". RemoteWakeupConnected was
+ * saved if boot firmware (BIOS/SMM/...) told us it's connected,
+ * or if bus glue did the same (e.g. for PCI add-in cards with
+ * PCI PM support).
*/
- ohci->hc_control = ohci_readl (ohci, &ohci->regs->control);
ohci_dbg (ohci, "resetting from state '%s', control = 0x%x\n",
hcfs2string (ohci->hc_control & OHCI_CTRL_HCFS),
- ohci->hc_control);
-
- if (ohci->hc_control & OHCI_CTRL_RWC
- && !(ohci->flags & OHCI_QUIRK_AMD756))
- ohci_to_hcd(ohci)->can_wakeup = 1;
+ ohci_readl (ohci, &ohci->regs->control));
+ if ((ohci->hc_control & OHCI_CTRL_RWC) != 0
+ && !device_may_wakeup(hcd->self.controller))
+ device_init_wakeup(hcd->self.controller, 1);
switch (ohci->hc_control & OHCI_CTRL_HCFS) {
case OHCI_USB_OPER:
msleep(temp);
temp = roothub_a (ohci);
if (!(temp & RH_A_NPS)) {
- unsigned ports = temp & RH_A_NDP;
-
/* power down each port */
- for (temp = 0; temp < ports; temp++)
+ for (temp = 0; temp < ohci->num_ports; temp++)
ohci_writel (ohci, RH_PS_LSDA,
&ohci->regs->roothub.portstatus [temp]);
}
ohci->hc_control &= OHCI_CTRL_RWC;
ohci->hc_control |= OHCI_CONTROL_INIT | OHCI_USB_OPER;
ohci_writel (ohci, ohci->hc_control, &ohci->regs->control);
- ohci_to_hcd(ohci)->state = HC_STATE_RUNNING;
+ hcd->state = HC_STATE_RUNNING;
/* wake on ConnectStatusChange, matching external hubs */
ohci_writel (ohci, RH_HS_DRWE, &ohci->regs->roothub.status);
// POTPGT delay is bits 24-31, in 2 ms units.
mdelay ((temp >> 23) & 0x1fe);
- bus = &ohci_to_hcd(ohci)->self;
- ohci_to_hcd(ohci)->state = HC_STATE_RUNNING;
+ hcd->state = HC_STATE_RUNNING;
ohci_dump (ohci, 1);
- udev = bus->root_hub;
- if (udev) {
- return 0;
- }
-
- /* connect the virtual root hub */
- udev = usb_alloc_dev (NULL, bus, 0);
- if (!udev) {
- disable (ohci);
- ohci->hc_control &= ~OHCI_CTRL_HCFS;
- ohci_writel (ohci, ohci->hc_control, &ohci->regs->control);
- return -ENOMEM;
- }
-
- udev->speed = USB_SPEED_FULL;
- if (usb_hcd_register_root_hub (udev, ohci_to_hcd(ohci)) != 0) {
- usb_put_dev (udev);
- disable (ohci);
- ohci->hc_control &= ~OHCI_CTRL_HCFS;
- ohci_writel (ohci, ohci->hc_control, &ohci->regs->control);
- return -ENODEV;
- }
- if (ohci->power_budget)
- hub_set_power_budget(udev, ohci->power_budget);
-
- create_debug_files (ohci);
return 0;
}
if (ints & OHCI_INTR_RD) {
ohci_vdbg (ohci, "resume detect\n");
+ ohci_writel (ohci, OHCI_INTR_RD, ®s->intrstatus);
if (hcd->state != HC_STATE_QUIESCING)
- schedule_work(&ohci->rh_resume);
+ usb_hcd_resume_root_hub(hcd);
}
if (ints & OHCI_INTR_WDH) {
ohci_writel (ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
remove_debug_files (ohci);
+ unregister_reboot_notifier (&ohci->reboot_notifier);
ohci_mem_cleanup (ohci);
if (ohci->hcca) {
dma_free_coherent (hcd->self.controller,
/* must not be called from interrupt context */
-#if defined(CONFIG_USB_SUSPEND) || defined(CONFIG_PM)
+#ifdef CONFIG_PM
static int ohci_restart (struct ohci_hcd *ohci)
{
int temp;
int i;
struct urb_priv *priv;
- struct usb_device *root = ohci_to_hcd(ohci)->self.root_hub;
/* mark any devices gone, so they do nothing till khubd disconnects.
* recycle any "live" eds/tds (and urbs) right away.
*/
spin_lock_irq(&ohci->lock);
disable (ohci);
- for (i = 0; i < root->maxchild; i++) {
- if (root->children [i])
- usb_set_device_state (root->children[i],
- USB_STATE_NOTATTACHED);
- }
+ usb_root_hub_lost_power(ohci_to_hcd(ohci)->self.root_hub);
if (!list_empty (&ohci->pending))
ohci_dbg(ohci, "abort schedule...\n");
list_for_each_entry (priv, &ohci->pending, pending) {
* and that if we try to turn them back on the root hub
* will respond to CSC processing.
*/
- i = roothub_a (ohci) & RH_A_NDP;
+ i = ohci->num_ports;
while (i--)
ohci_writel (ohci, RH_PS_PSS,
- &ohci->regs->roothub.portstatus [temp]);
+ &ohci->regs->roothub.portstatus [i]);
ohci_dbg (ohci, "restart complete\n");
}
return 0;
#include "ohci-sa1111.c"
#endif
+#ifdef CONFIG_ARCH_S3C2410
+#include "ohci-s3c2410.c"
+#endif
+
#ifdef CONFIG_ARCH_OMAP
#include "ohci-omap.c"
#endif
#include "ohci-ppc-soc.c"
#endif
+#ifdef CONFIG_ARCH_AT91RM9200
+#include "ohci-at91.c"
+#endif
+
#if !(defined(CONFIG_PCI) \
|| defined(CONFIG_SA1111) \
+ || defined(CONFIG_ARCH_S3C2410) \
|| defined(CONFIG_ARCH_OMAP) \
|| defined (CONFIG_ARCH_LH7A404) \
|| defined (CONFIG_PXA27x) \
|| defined (CONFIG_SOC_AU1X00) \
|| defined (CONFIG_USB_OHCI_HCD_PPC_SOC) \
+ || defined (CONFIG_ARCH_AT91RM9200) \
)
#error "missing bus glue for ohci-hcd"
#endif
git://git.onelab.eu / linux-2.6.git / blobdiff