# USB Storage driver configuration
#
-comment "NOTE: USB_STORAGE enables SCSI, and 'SCSI disk support' may also be needed; see USB_STORAGE Help for more information"
+comment "NOTE: USB_STORAGE enables SCSI, and 'SCSI disk support'"
+comment "may also be needed; see USB_STORAGE Help for more information"
depends on USB
config USB_STORAGE
config USB_STORAGE_ISD200
bool "ISD-200 USB/ATA Bridge support"
- depends on USB_STORAGE && BLK_DEV_IDE
+ depends on USB_STORAGE
+ depends on BLK_DEV_IDE=y || BLK_DEV_IDE=USB_STORAGE
---help---
Say Y here if you want to use USB Mass Store devices based
on the In-Systems Design ISD-200 USB/ATA bridge.
Say Y here to include additional code to support the Lexar Jumpshot
USB CompactFlash reader.
+config USB_STORAGE_ALAUDA
+ bool "Olympus MAUSB-10/Fuji DPC-R1 support (EXPERIMENTAL)"
+ depends on USB_STORAGE && EXPERIMENTAL
+ help
+ Say Y here to include additional code to support the Olympus MAUSB-10
+ and Fujifilm DPC-R1 USB Card reader/writer devices.
+
+ These devices are based on the Alauda chip and support support both
+ XD and SmartMedia cards.
+
+config USB_STORAGE_ONETOUCH
+ bool "Support OneTouch Button on Maxtor Hard Drives (EXPERIMENTAL)"
+ depends on USB_STORAGE && INPUT_EVDEV && EXPERIMENTAL && !PM
+ help
+ Say Y here to include additional code to support the Maxtor OneTouch
+ USB hard drive's onetouch button.
+
+ This code registers the button on the front of Maxtor OneTouch USB
+ hard drive's as an input device. An action can be associated with
+ this input in any keybinding software. (e.g. gnome's keyboard short-
+ cuts)
+
+config USB_LIBUSUAL
+ bool "The shared table of common (or usual) storage devices"
+ depends on USB
+ help
+ This module contains a table of common (or usual) devices
+ for usb-storage and ub drivers, and allows to switch binding
+ of these devices without rebuilding modules.
+
+ Typical syntax of /etc/modprobe.conf is:
+
+ options libusual bias="ub"
+
+ If unsure, say N.