/* *********************************************************************
* SB1250 Board Support Package
- *
+ *
* Register Definitions File: sb1250_regs.h
- *
+ *
* This module contains the addresses of the on-chip peripherals
* on the SB1250.
- *
+ *
* SB1250 specification level: 01/02/2002
- *
- * Author: Mitch Lichtenberg
- *
- *********************************************************************
+ *
+ *********************************************************************
*
* Copyright 2000,2001,2002,2003
* Broadcom Corporation. All rights reserved.
- *
- * This program is free software; you can redistribute it and/or
- * modify it under the terms of the GNU General Public License as
- * published by the Free Software Foundation; either version 2 of
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of
* the License, or (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
- * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
+ * Foundation, Inc., 59 Temple Place, Suite 330, Boston,
* MA 02111-1307 USA
********************************************************************* */
/* *********************************************************************
* Some general notes:
- *
+ *
* For the most part, when there is more than one peripheral
* of the same type on the SOC, the constants below will be
* offsets from the base of each peripheral. For example,
* the MAC registers are described as offsets from the first
* MAC register, and there will be a MAC_REGISTER() macro
- * to calculate the base address of a given MAC.
- *
+ * to calculate the base address of a given MAC.
+ *
* The information in this file is based on the SB1250 SOC
* manual version 0.2, July 2000.
********************************************************************* */
-/* *********************************************************************
+/* *********************************************************************
* Memory Controller Registers
********************************************************************* */
* XXX: can't remove MC base 0 if 112x, since it's used by other macros,
* since there is one reg there (but it could get its addr/offset constant).
*/
+
+#if SIBYTE_HDR_FEATURE_1250_112x /* This MC only on 1250 & 112x */
#define A_MC_BASE_0 0x0010051000
#define A_MC_BASE_1 0x0010052000
#define MC_REGISTER_SPACING 0x1000
#define R_MC_TEST_ECC 0x0000000420
#define R_MC_MCLK_CFG 0x0000000500
-/* *********************************************************************
+#endif /* 1250 & 112x */
+
+/* *********************************************************************
* L2 Cache Control Registers
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x /* This L2C only on 1250/112x */
+
#define A_L2_READ_TAG 0x0010040018
#define A_L2_ECC_TAG 0x0010040038
#if SIBYTE_HDR_FEATURE(1250, PASS3) || SIBYTE_HDR_FEATURE(112x, PASS1)
#define A_L2_READ_ADDRESS A_L2_READ_TAG
#define A_L2_EEC_ADDRESS A_L2_ECC_TAG
+#endif
-/* *********************************************************************
+/* *********************************************************************
* PCI Interface Registers
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x /* This PCI/HT only on 1250/112x */
#define A_PCI_TYPE00_HEADER 0x00DE000000
#define A_PCI_TYPE01_HEADER 0x00DE000800
+#endif
-/* *********************************************************************
+/* *********************************************************************
* Ethernet DMA and MACs
********************************************************************* */
(R_MAC_DMA_CHANNEL_BASE(txrx,chan) + \
(reg))
-/*
+/*
* DMA channel registers, relative to A_MAC_DMA_CHANNEL_BASE
*/
#define MAC_CHMAP_COUNT 4
-/* *********************************************************************
+/* *********************************************************************
* DUART Registers
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x /* This MC only on 1250 & 112x */
#define R_DUART_NUM_PORTS 2
#define A_DUART 0x0010060000
-#define A_DUART_REG(r)
-
#define DUART_CHANREG_SPACING 0x100
#define A_DUART_CHANREG(chan,reg) (A_DUART + DUART_CHANREG_SPACING*(chan) + (reg))
#define R_DUART_CHANREG(chan,reg) (DUART_CHANREG_SPACING*(chan) + (reg))
+#endif /* 1250 & 112x */
#define R_DUART_MODE_REG_1 0x100
#define R_DUART_MODE_REG_2 0x110
#define DUART_IMRISR_SPACING 0x20
+#if SIBYTE_HDR_FEATURE_1250_112x /* This MC only on 1250 & 112x */
#define R_DUART_IMRREG(chan) (R_DUART_IMR_A + (chan)*DUART_IMRISR_SPACING)
#define R_DUART_ISRREG(chan) (R_DUART_ISR_A + (chan)*DUART_IMRISR_SPACING)
#define A_DUART_IMRREG(chan) (A_DUART + R_DUART_IMRREG(chan))
#define A_DUART_ISRREG(chan) (A_DUART + R_DUART_ISRREG(chan))
+#endif /* 1250 & 112x */
#endif /* 1250 PASS2 || 112x PASS1 */
-/* *********************************************************************
+/* *********************************************************************
* Synchronous Serial Registers
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x /* sync serial only on 1250/112x */
+
#define A_SER_BASE_0 0x0010060400
#define A_SER_BASE_1 0x0010060800
#define SER_SPACING 0x400
(reg))
-/*
+/*
* DMA channel registers, relative to A_SER_DMA_CHANNEL_BASE
*/
#define R_SER_RMON_RX_ERRORS 0x000001F0
#define R_SER_RMON_RX_BADADDR 0x000001F8
-/* *********************************************************************
+#endif /* 1250/112x */
+
+/* *********************************************************************
* Generic Bus Registers
********************************************************************* */
#define R_IO_PCMCIA_CFG 0x0A60
#define R_IO_PCMCIA_STATUS 0x0A70
-/* *********************************************************************
+/* *********************************************************************
* GPIO Registers
********************************************************************* */
#define R_GPIO_PIN_CLR 0x30
#define R_GPIO_PIN_SET 0x38
-/* *********************************************************************
+/* *********************************************************************
* SMBus Registers
********************************************************************* */
#define R_SMB_CONTROL 0x0000000060
#define R_SMB_PEC 0x0000000070
-/* *********************************************************************
+/* *********************************************************************
* Timer Registers
********************************************************************* */
#if SIBYTE_HDR_FEATURE(1250, PASS2) || SIBYTE_HDR_FEATURE(112x, PASS1)
#define A_SCD_SCRATCH 0x0010020C10
+#endif /* 1250 PASS2 || 112x PASS1 */
+#if SIBYTE_HDR_FEATURE(1250, PASS2) || SIBYTE_HDR_FEATURE(112x, PASS1) || SIBYTE_HDR_FEATURE_CHIP(1480)
#define A_SCD_ZBBUS_CYCLE_COUNT 0x0010030000
#define A_SCD_ZBBUS_CYCLE_CP0 0x0010020C00
#define A_SCD_ZBBUS_CYCLE_CP1 0x0010020C08
-#endif /* 1250 PASS2 || 112x PASS1 */
-
+#endif
-/* *********************************************************************
+/* *********************************************************************
* System Control Registers
********************************************************************* */
#define A_SCD_SYSTEM_CFG 0x0010020008
#define A_SCD_SYSTEM_MANUF 0x0010038000
-/* *********************************************************************
+/* *********************************************************************
* System Address Trap Registers
********************************************************************* */
#define A_ADDR_TRAP_CFG_1 0x0010020448
#define A_ADDR_TRAP_CFG_2 0x0010020450
#define A_ADDR_TRAP_CFG_3 0x0010020458
-#if SIBYTE_HDR_FEATURE(1250, PASS2) || SIBYTE_HDR_FEATURE(112x, PASS1)
+#if SIBYTE_HDR_FEATURE(1250, PASS2) || SIBYTE_HDR_FEATURE(112x, PASS1) || SIBYTE_HDR_FEATURE_CHIP(1480)
#define A_ADDR_TRAP_REG_DEBUG 0x0010020460
-#endif /* 1250 PASS2 || 112x PASS1 */
+#endif /* 1250 PASS2 || 112x PASS1 || 1480 */
-/* *********************************************************************
+/* *********************************************************************
* System Interrupt Mapper Registers
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x
#define A_IMR_CPU0_BASE 0x0010020000
#define A_IMR_CPU1_BASE 0x0010022000
#define IMR_REGISTER_SPACING 0x2000
#define R_IMR_INTERRUPT_STATUS_COUNT 7
#define R_IMR_INTERRUPT_MAP_BASE 0x0200
#define R_IMR_INTERRUPT_MAP_COUNT 64
+#endif /* 1250/112x */
-/* *********************************************************************
+/* *********************************************************************
* System Performance Counter Registers
********************************************************************* */
#define A_SCD_PERF_CNT_2 0x00100204E0
#define A_SCD_PERF_CNT_3 0x00100204E8
-/* *********************************************************************
+/* *********************************************************************
* System Bus Watcher Registers
********************************************************************* */
#define A_SCD_BUS_ERR_STATUS 0x0010020880
#if SIBYTE_HDR_FEATURE(1250, PASS2) || SIBYTE_HDR_FEATURE(112x, PASS1)
#define A_SCD_BUS_ERR_STATUS_DEBUG 0x00100208D0
+#define A_BUS_ERR_STATUS_DEBUG 0x00100208D0
#endif /* 1250 PASS2 || 112x PASS1 */
#define A_BUS_ERR_DATA_0 0x00100208A0
#define A_BUS_ERR_DATA_1 0x00100208A8
#define A_BUS_L2_ERRORS 0x00100208C0
#define A_BUS_MEM_IO_ERRORS 0x00100208C8
-/* *********************************************************************
+/* *********************************************************************
* System Debug Controller Registers
********************************************************************* */
#define A_SCD_JTAG_BASE 0x0010000000
-/* *********************************************************************
+/* *********************************************************************
* System Trace Buffer Registers
********************************************************************* */
#define A_SCD_TRACE_SEQUENCE_6 0x0010020A90
#define A_SCD_TRACE_SEQUENCE_7 0x0010020A98
-/* *********************************************************************
+/* *********************************************************************
* System Generic DMA Registers
********************************************************************* */
* Physical Address Map
********************************************************************* */
+#if SIBYTE_HDR_FEATURE_1250_112x
#define A_PHYS_MEMORY_0 _SB_MAKE64(0x0000000000)
#define A_PHYS_MEMORY_SIZE _SB_MAKE64((256*1024*1024))
#define A_PHYS_SYSTEM_CTL _SB_MAKE64(0x0010000000)
#define A_PHYS_L2CACHE_WAY1 _SB_MAKE64(0x00D01A0000)
#define A_PHYS_L2CACHE_WAY2 _SB_MAKE64(0x00D01C0000)
#define A_PHYS_L2CACHE_WAY3 _SB_MAKE64(0x00D01E0000)
+#endif
#endif
git://git.onelab.eu / linux-2.6.git / blobdiff