-
-/* $Id: mtd.h,v 1.45 2003/05/20 21:56:40 dwmw2 Exp $ */
+/*
+ * $Id: mtd.h,v 1.56 2004/08/09 18:46:04 dmarlin Exp $
+ *
+ * Copyright (C) 1999-2003 David Woodhouse <dwmw2@infradead.org> et al.
+ *
+ * Released under GPL
+ */
#ifndef __MTD_MTD_H__
#define __MTD_MTD_H__
-#ifdef __KERNEL__
+#ifndef __KERNEL__
+#error This is a kernel header. Perhaps include mtd-user.h instead?
+#endif
#include <linux/config.h>
#include <linux/version.h>
#include <linux/module.h>
#include <linux/uio.h>
-#endif /* __KERNEL__ */
-
-struct erase_info_user {
- u_int32_t start;
- u_int32_t length;
-};
-
-struct mtd_oob_buf {
- u_int32_t start;
- u_int32_t length;
- unsigned char *ptr;
-};
+#include <linux/mtd/compatmac.h>
+#include <mtd/mtd-abi.h>
#define MTD_CHAR_MAJOR 90
#define MTD_BLOCK_MAJOR 31
#define MAX_MTD_DEVICES 16
-
-
-#define MTD_ABSENT 0
-#define MTD_RAM 1
-#define MTD_ROM 2
-#define MTD_NORFLASH 3
-#define MTD_NANDFLASH 4
-#define MTD_PEROM 5
-#define MTD_OTHER 14
-#define MTD_UNKNOWN 15
-
-
-
-#define MTD_CLEAR_BITS 1 // Bits can be cleared (flash)
-#define MTD_SET_BITS 2 // Bits can be set
-#define MTD_ERASEABLE 4 // Has an erase function
-#define MTD_WRITEB_WRITEABLE 8 // Direct IO is possible
-#define MTD_VOLATILE 16 // Set for RAMs
-#define MTD_XIP 32 // eXecute-In-Place possible
-#define MTD_OOB 64 // Out-of-band data (NAND flash)
-#define MTD_ECC 128 // Device capable of automatic ECC
-
-// Some common devices / combinations of capabilities
-#define MTD_CAP_ROM 0
-#define MTD_CAP_RAM (MTD_CLEAR_BITS|MTD_SET_BITS|MTD_WRITEB_WRITEABLE)
-#define MTD_CAP_NORFLASH (MTD_CLEAR_BITS|MTD_ERASEABLE)
-#define MTD_CAP_NANDFLASH (MTD_CLEAR_BITS|MTD_ERASEABLE|MTD_OOB)
-#define MTD_WRITEABLE (MTD_CLEAR_BITS|MTD_SET_BITS)
-
-
-// Types of automatic ECC/Checksum available
-#define MTD_ECC_NONE 0 // No automatic ECC available
-#define MTD_ECC_RS_DiskOnChip 1 // Automatic ECC on DiskOnChip
-#define MTD_ECC_SW 2 // SW ECC for Toshiba & Samsung devices
-
-struct mtd_info_user {
- u_char type;
- u_int32_t flags;
- u_int32_t size; // Total size of the MTD
- u_int32_t erasesize;
- u_int32_t oobblock; // Size of OOB blocks (e.g. 512)
- u_int32_t oobsize; // Amount of OOB data per block (e.g. 16)
- u_int32_t ecctype;
- u_int32_t eccsize;
-};
-
-struct region_info_user {
- u_int32_t offset; /* At which this region starts,
- * from the beginning of the MTD */
- u_int32_t erasesize; /* For this region */
- u_int32_t numblocks; /* Number of blocks in this region */
- u_int32_t regionindex;
-};
-
-#define MEMGETINFO _IOR('M', 1, struct mtd_info_user)
-#define MEMERASE _IOW('M', 2, struct erase_info_user)
-#define MEMWRITEOOB _IOWR('M', 3, struct mtd_oob_buf)
-#define MEMREADOOB _IOWR('M', 4, struct mtd_oob_buf)
-#define MEMLOCK _IOW('M', 5, struct erase_info_user)
-#define MEMUNLOCK _IOW('M', 6, struct erase_info_user)
-#define MEMGETREGIONCOUNT _IOR('M', 7, int)
-#define MEMGETREGIONINFO _IOWR('M', 8, struct region_info_user)
-#define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo)
-
-struct nand_oobinfo {
- int useecc;
- int eccpos[6];
-};
-
-
-#ifndef __KERNEL__
-
-typedef struct mtd_info_user mtd_info_t;
-typedef struct erase_info_user erase_info_t;
-typedef struct region_info_user region_info_t;
-typedef struct nand_oobinfo nand_oobinfo_t;
-
- /* User-space ioctl definitions */
-
-#else /* __KERNEL__ */
-
-
#define MTD_ERASE_PENDING 0x01
#define MTD_ERASING 0x02
#define MTD_ERASE_SUSPEND 0x04
#define MTD_ERASE_DONE 0x08
#define MTD_ERASE_FAILED 0x10
+/* If the erase fails, fail_addr might indicate exactly which block failed. If
+ fail_addr = 0xffffffff, the failure was not at the device level or was not
+ specific to any particular block. */
struct erase_info {
struct mtd_info *mtd;
u_int32_t addr;
u_int32_t len;
+ u_int32_t fail_addr;
u_long time;
u_long retries;
u_int dev;
u_int32_t oobblock; // Size of OOB blocks (e.g. 512)
u_int32_t oobsize; // Amount of OOB data per block (e.g. 16)
+ u_int32_t oobavail; // Number of bytes in OOB area available for fs
u_int32_t ecctype;
u_int32_t eccsize;
/* This function is not yet implemented */
int (*write_user_prot_reg) (struct mtd_info *mtd, loff_t from, size_t len, size_t *retlen, u_char *buf);
- /* iovec-based read/write methods. We need these especially for NAND flash,
+ /* kvec-based read/write methods. We need these especially for NAND flash,
with its limited number of write cycles per erase.
NB: The 'count' parameter is the number of _vectors_, each of
which contains an (ofs, len) tuple.
*/
- int (*readv) (struct mtd_info *mtd, struct iovec *vecs, unsigned long count, loff_t from, size_t *retlen);
- int (*readv_ecc) (struct mtd_info *mtd, struct iovec *vecs, unsigned long count, loff_t from,
+ int (*readv) (struct mtd_info *mtd, struct kvec *vecs, unsigned long count, loff_t from, size_t *retlen);
+ int (*readv_ecc) (struct mtd_info *mtd, struct kvec *vecs, unsigned long count, loff_t from,
size_t *retlen, u_char *eccbuf, struct nand_oobinfo *oobsel);
- int (*writev) (struct mtd_info *mtd, const struct iovec *vecs, unsigned long count, loff_t to, size_t *retlen);
- int (*writev_ecc) (struct mtd_info *mtd, const struct iovec *vecs, unsigned long count, loff_t to,
+ int (*writev) (struct mtd_info *mtd, const struct kvec *vecs, unsigned long count, loff_t to, size_t *retlen);
+ int (*writev_ecc) (struct mtd_info *mtd, const struct kvec *vecs, unsigned long count, loff_t to,
size_t *retlen, u_char *eccbuf, struct nand_oobinfo *oobsel);
/* Sync */
int (*suspend) (struct mtd_info *mtd);
void (*resume) (struct mtd_info *mtd);
+ /* Bad block management functions */
+ int (*block_isbad) (struct mtd_info *mtd, loff_t ofs);
+ int (*block_markbad) (struct mtd_info *mtd, loff_t ofs);
+
void *priv;
struct module *owner;
extern void register_mtd_user (struct mtd_notifier *new);
extern int unregister_mtd_user (struct mtd_notifier *old);
-int default_mtd_writev(struct mtd_info *mtd, const struct iovec *vecs,
+int default_mtd_writev(struct mtd_info *mtd, const struct kvec *vecs,
unsigned long count, loff_t to, size_t *retlen);
-int default_mtd_readv(struct mtd_info *mtd, struct iovec *vecs,
+int default_mtd_readv(struct mtd_info *mtd, struct kvec *vecs,
unsigned long count, loff_t from, size_t *retlen);
#define MTD_ERASE(mtd, args...) (*(mtd->erase))(mtd, args)
#define MTD_WRITEOOB(mtd, args...) (*(mtd->write_oob))(mtd, args)
#define MTD_SYNC(mtd) do { if (mtd->sync) (*(mtd->sync))(mtd); } while (0)
+
+#ifdef CONFIG_MTD_PARTITIONS
+void mtd_erase_callback(struct erase_info *instr);
+#else
+static inline void mtd_erase_callback(struct erase_info *instr)
+{
+ if (instr->callback)
+ instr->callback(instr);
+}
+#endif
+
/*
* Debugging macro and defines
*/
#endif /* CONFIG_MTD_DEBUG */
-#endif /* __KERNEL__ */
-
#endif /* __MTD_MTD_H__ */
git://git.onelab.eu / linux-2.6.git / blobdiff