#!/bin/sh +x
-IP=/sbin/ip
-
SLICE=$1
SLICEID=`id -u $SLICE`
NODEID=$2
KEY=$3
-modprobe etun
-
-###
-### Avoid IP address collisions between NAT and virtual links.
-### Virtual links have addresses 10.A.B.[23], where A < B always.
-### So make sure that A > B for NAT.
-###
-if [ $KEY > $NODEID ]; then
- BASE="10.$KEY.$NODEID"
-else
- BASE="10.$NODEID.$KEY"
-fi
+#
+# OpenVPN uses addresses in 10.<nodeid>/16 block. Avoid collisions with
+# this block. NAT interface is not advertised and so does not require
+# unique address throughout the topology. But the address of each slice's
+# NAT interface must be unique on a single node.
+#
+BASE="10.0.$KEY"
+EXTIP=$BASE.1
+EXTNET=$EXTIP/24
+INTIP=$BASE.2
+INTNET=$INTIP/24
+BASENET=$BASE.0/24
### Setup etun
ETUN0=nat$KEY
ETUN1=natx$KEY
-echo $ETUN0,$ETUN1 > /sys/module/etun/parameters/newif
-ifconfig $ETUN1 $BASE.1 up
-
-/sbin/iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
-/sbin/iptables -A FORWARD -i eth0 -o $ETUN1 -m state --state RELATED,ESTABLISHED -j ACCEPT
-/sbin/iptables -A FORWARD -i $ETUN1 -o eth0 -j ACCEPT
+ip link add name $ETUN0 type veth peer name $ETUN1
+ifconfig $ETUN1 $EXTNET up
### Put a process in the vserver so we can move the interface there
-su $SLICE -c "sleep 30" &
-sleep 1
-PID=`su $SLICE -c "pgrep sleep"`
-chcontext --ctx 1 -- echo $PID > /sys/class/net/$ETUN0/new_ns_pid
+su $SLICE -c "sleep 30 &"
+PID=`su $SLICE -c "pgrep -n sleep"`
+ip link set $ETUN0 netns $PID
+naddress --add --nid $SLICEID --ip $INTNET
sleep 1
-su $SLICE -c "sudo /sbin/ifconfig $ETUN0 $BASE.2/24 up; \
- sudo /sbin/route add -net $BASE.0/24 $ETUN0; \
- sudo /sbin/route add default gw $BASE.1"
+su $SLICE -c "sudo /sbin/ifconfig $ETUN0 $INTNET up; \
+ sudo /sbin/route add default gw $EXTIP; \
+ sudo /sbin/ifconfig lo 127.0.0.1/8 up"
+ip rule add dev eth0 fwmark $KEY table $KEY
+ip route add table $KEY default via $INTIP
+iptables -t mangle -A PREROUTING -i $ETUN1 -j CONNMARK --set-mark $KEY
git://git.onelab.eu / nodemanager-topo.git / blobdiff