This commit was manufactured by cvs2svn to create branch 'vserver'.
[linux-2.6.git] / drivers / usb / gadget / omap_udc.h
1 /*
2  * omap_udc.h -- for omap 3.2 udc, with OTG support
3  *
4  * 2004 (C) Texas Instruments, Inc.
5  * 2004 (C) David Brownell
6  */
7
8 /*
9  * USB device/endpoint management registers
10  */
11 #define UDC_REG(offset)              __REG16(UDC_BASE + (offset))
12
13 #define UDC_REV_REG                     UDC_REG(0x0)    /* Revision */
14 #define UDC_EP_NUM_REG                  UDC_REG(0x4)    /* Which endpoint */
15 #       define  UDC_SETUP_SEL           (1 << 6)
16 #       define  UDC_EP_SEL              (1 << 5)
17 #       define  UDC_EP_DIR              (1 << 4)
18         /* low 4 bits for endpoint number */
19 #define UDC_DATA_REG                    UDC_REG(0x08)   /* Endpoint FIFO */
20 #define UDC_CTRL_REG                    UDC_REG(0x0C)   /* Endpoint control */
21 #       define  UDC_CLR_HALT            (1 << 7)
22 #       define  UDC_SET_HALT            (1 << 6)
23 #       define  UDC_SET_FIFO_EN         (1 << 2)
24 #       define  UDC_CLR_EP              (1 << 1)
25 #       define  UDC_RESET_EP            (1 << 0)
26 #define UDC_STAT_FLG_REG                UDC_REG(0x10)   /* Endpoint status */
27 #       define  UDC_NO_RXPACKET         (1 << 15)
28 #       define  UDC_MISS_IN             (1 << 14)
29 #       define  UDC_DATA_FLUSH          (1 << 13)
30 #       define  UDC_ISO_ERR             (1 << 12)
31 #       define  UDC_ISO_FIFO_EMPTY      (1 << 9)
32 #       define  UDC_ISO_FIFO_FULL       (1 << 8)
33 #       define  UDC_EP_HALTED           (1 << 6)
34 #       define  UDC_STALL               (1 << 5)
35 #       define  UDC_NAK                 (1 << 4)
36 #       define  UDC_ACK                 (1 << 3)
37 #       define  UDC_FIFO_EN             (1 << 2)
38 #       define  UDC_NON_ISO_FIFO_EMPTY  (1 << 1)
39 #       define  UDC_NON_ISO_FIFO_FULL   (1 << 0)
40 #define UDC_RXFSTAT_REG                 UDC_REG(0x14)   /* OUT bytecount */
41 #define UDC_SYSCON1_REG                 UDC_REG(0x18)   /* System config 1 */
42 #       define  UDC_CFG_LOCK            (1 << 8)
43 #       define  UDC_DATA_ENDIAN         (1 << 7)
44 #       define  UDC_DMA_ENDIAN          (1 << 6)
45 #       define  UDC_NAK_EN              (1 << 4)
46 #       define  UDC_AUTODECODE_DIS      (1 << 3)
47 #       define  UDC_SELF_PWR            (1 << 2)
48 #       define  UDC_SOFF_DIS            (1 << 1)
49 #       define  UDC_PULLUP_EN           (1 << 0)
50 #define UDC_SYSCON2_REG                 UDC_REG(0x1C)   /* System config 2 */
51 #       define  UDC_RMT_WKP             (1 << 6)
52 #       define  UDC_STALL_CMD           (1 << 5)
53 #       define  UDC_DEV_CFG             (1 << 3)
54 #       define  UDC_CLR_CFG             (1 << 2)
55 #define UDC_DEVSTAT_REG                 UDC_REG(0x20)   /* Device status */
56 #       define  UDC_B_HNP_ENABLE        (1 << 9)
57 #       define  UDC_A_HNP_SUPPORT       (1 << 8)
58 #       define  UDC_A_ALT_HNP_SUPPORT   (1 << 7)
59 #       define  UDC_R_WK_OK             (1 << 6)
60 #       define  UDC_USB_RESET           (1 << 5)
61 #       define  UDC_SUS                 (1 << 4)
62 #       define  UDC_CFG                 (1 << 3)
63 #       define  UDC_ADD                 (1 << 2)
64 #       define  UDC_DEF                 (1 << 1)
65 #       define  UDC_ATT                 (1 << 0)
66 #define UDC_SOF_REG                     UDC_REG(0x24)   /* Start of frame */
67 #       define  UDC_FT_LOCK             (1 << 12)
68 #       define  UDC_TS_OK               (1 << 11)
69 #       define  UDC_TS                  0x03ff
70 #define UDC_IRQ_EN_REG                  UDC_REG(0x28)   /* Interrupt enable */
71 #       define  UDC_SOF_IE              (1 << 7)
72 #       define  UDC_EPN_RX_IE           (1 << 5)
73 #       define  UDC_EPN_TX_IE           (1 << 4)
74 #       define  UDC_DS_CHG_IE           (1 << 3)
75 #       define  UDC_EP0_IE              (1 << 0)
76 #define UDC_DMA_IRQ_EN_REG              UDC_REG(0x2C)   /* DMA irq enable */
77         /* rx/tx dma channels numbered 1-3 not 0-2 */
78 #       define  UDC_TX_DONE_IE(n)       (1 << (4 * (n) - 2))
79 #       define  UDC_RX_CNT_IE(n)        (1 << (4 * (n) - 3))
80 #       define  UDC_RX_EOT_IE(n)        (1 << (4 * (n) - 4))
81 #define UDC_IRQ_SRC_REG                 UDC_REG(0x30)   /* Interrupt source */
82 #       define  UDC_TXN_DONE            (1 << 10)
83 #       define  UDC_RXN_CNT             (1 << 9)
84 #       define  UDC_RXN_EOT             (1 << 8)
85 #       define  UDC_SOF                 (1 << 7)
86 #       define  UDC_EPN_RX              (1 << 5)
87 #       define  UDC_EPN_TX              (1 << 4)
88 #       define  UDC_DS_CHG              (1 << 3)
89 #       define  UDC_SETUP               (1 << 2)
90 #       define  UDC_EP0_RX              (1 << 1)
91 #       define  UDC_EP0_TX              (1 << 0)
92 #       define  UDC_IRQ_SRC_MASK        0x7bf
93 #define UDC_EPN_STAT_REG                UDC_REG(0x34)   /* EP irq status */
94 #define UDC_DMAN_STAT_REG               UDC_REG(0x38)   /* DMA irq status */
95 #       define  UDC_DMA_RX_SB           (1 << 12)
96 #       define  UDC_DMA_RX_SRC(x)       (((x)>>8) & 0xf)
97 #       define  UDC_DMA_TX_SRC(x)       (((x)>>0) & 0xf)
98
99
100 /* DMA configuration registers:  up to three channels in each direction.  */
101 #define UDC_RXDMA_CFG_REG               UDC_REG(0x40)   /* 3 eps for RX DMA */
102 #define UDC_TXDMA_CFG_REG               UDC_REG(0x44)   /* 3 eps for TX DMA */
103 #define UDC_DATA_DMA_REG                UDC_REG(0x48)   /* rx/tx fifo addr */
104
105 /* rx/tx dma control, numbering channels 1-3 not 0-2 */
106 #define UDC_TXDMA_REG(chan)             UDC_REG(0x50 - 4 + 4 * (chan))
107 #       define UDC_TXN_EOT              (1 << 15)       /* bytes vs packets */
108 #       define UDC_TXN_START            (1 << 14)       /* start transfer */
109 #       define UDC_TXN_TSC              0x03ff          /* units in xfer */
110 #define UDC_RXDMA_REG(chan)             UDC_REG(0x60 - 4 + 4 * (chan))
111 #       define UDC_RXN_STOP             (1 << 15)       /* enable EOT irq */
112 #       define UDC_RXN_TC               0x00ff          /* packets in xfer */
113
114
115 /*
116  * Endpoint configuration registers (used before CFG_LOCK is set)
117  * UDC_EP_TX_REG(0) is unused
118  */
119 #define UDC_EP_RX_REG(endpoint)         UDC_REG(0x80 + (endpoint)*4)
120 #       define  UDC_EPN_RX_VALID        (1 << 15)
121 #       define  UDC_EPN_RX_DB           (1 << 14)
122         /* buffer size in bits 13, 12 */
123 #       define  UDC_EPN_RX_ISO          (1 << 11)
124         /* buffer pointer in low 11 bits */
125 #define UDC_EP_TX_REG(endpoint)         UDC_REG(0xc0 + (endpoint)*4)
126         /* same bitfields as in RX_REG */
127
128 /*-------------------------------------------------------------------------*/
129
130 struct omap_req {
131         struct usb_request              req;
132         struct list_head                queue;
133         unsigned                        dma_bytes;
134         unsigned                        mapped:1;
135 };
136
137 struct omap_ep {
138         struct usb_ep                   ep;
139         struct list_head                queue;
140         unsigned long                   irqs;
141         struct list_head                iso;
142         const struct usb_endpoint_descriptor    *desc;
143         char                            name[14];
144         u16                             maxpacket;
145         u8                              bEndpointAddress;
146         u8                              bmAttributes;
147         unsigned                        double_buf:1;
148         unsigned                        stopped:1;
149         unsigned                        ackwait:1;
150         unsigned                        has_dma:1;
151         u8                              dma_channel;
152         int                             lch;
153         struct omap_udc                 *udc;
154 };
155
156 struct omap_udc {
157         struct usb_gadget               gadget;
158         struct usb_gadget_driver        *driver;
159         spinlock_t                      lock;
160         struct omap_ep                  ep[32];
161         u16                             devstat;
162         struct otg_transceiver          *transceiver;
163         struct list_head                iso;
164         unsigned                        softconnect:1;
165         unsigned                        vbus_active:1;
166         unsigned                        ep0_pending:1;
167         unsigned                        ep0_in:1;
168         unsigned                        ep0_set_config:1;
169         unsigned                        ep0_reset_config:1;
170         unsigned                        ep0_setup:1;
171         unsigned                        hmc:6;
172
173         struct completion               *done;
174 };
175
176 /*-------------------------------------------------------------------------*/
177
178 #ifdef DEBUG
179 #define DBG(stuff...)           printk(KERN_DEBUG "udc: " stuff)
180 #else
181 #define DBG(stuff...)           do{}while(0)
182 #endif
183
184 #ifdef VERBOSE
185 #    define VDBG                DBG
186 #else
187 #    define VDBG(stuff...)      do{}while(0)
188 #endif
189
190 #define ERR(stuff...)           printk(KERN_ERR "udc: " stuff)
191 #define WARN(stuff...)          printk(KERN_WARNING "udc: " stuff)
192 #define INFO(stuff...)          printk(KERN_INFO "udc: " stuff)
193
194 /*-------------------------------------------------------------------------*/
195
196 // #define      HMC_1510        ((MOD_CONF_CTRL_0_REG >> 1) & 0x3f)
197 #define HMC_1610        (OTG_SYSCON_2_REG & 0x3f)
198 #define HMC              HMC_1610
199